The Device to Measuring of the Load Angle for Salient-Pole Synchronous Machine in Education Laboratory

Abstract This paper presents information about a new device for measuring the synchronous machine load angle in laboratory conditions using the optical encoder. The prototype device is used in education for practical measuring exercises in the study course of electrical machines. Described in the article is block diagram of the measuring device. The operation principle of the device and the measurement principle of load angle of the synchronous machine presents a subject of the article, too. Moreover, the device evaluates operating mode (motor or generator) of the synchronous machine.

[1]  E. Barrera-Cardiel,et al.  Microcontroller-based power-angle instrument for a power systems laboratory , 1999, 1999 IEEE Power Engineering Society Summer Meeting. Conference Proceedings (Cat. No.99CH36364).

[2]  P. Y. Kovalenko,et al.  Estimation of synchronous generator participation in low-frequency oscillations damping based on synchronized phasor measurements , 2014 .

[3]  Martin Koutný,et al.  Modelling of part medium access methods in the HomePlug , 2012 .

[4]  Ali Keyhani,et al.  Synchronous generator model identification and parameter estimation from operating data , 2003 .

[5]  Roy Moxley,et al.  Adding shaft angle measurement to generator protection and monitoring , 2013, 2013 66th Annual Conference for Protective Relay Engineers.

[6]  Ioan-Adrian Viorel,et al.  On the Identification of the Synchronous Machine Parameters Using Standstill DC Decay Test. , 2006 .

[7]  E. B. Powell,et al.  Generator rotor angle measurement by stroboscopic means , 1958 .

[8]  D. Sumina,et al.  Determination of Load Angle for Salient-pole Synchronous Machine , 2010 .

[9]  Om P. Malik,et al.  Measurement setup for a power laboratory motor generator station , 1995 .

[10]  Chengxue Zhang,et al.  A new approach to real time measurement of power angles of generators at different locations for stability control , 2000, 2000 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.00CH37077).

[11]  Juha J. Pyrhönen,et al.  Limitation of the load angle in a direct-torque-controlled synchronous machine drive , 2004, IEEE Transactions on Industrial Electronics.