Investigation of flow next to membrane walls

Abstract The research reported here is based on a flat membrane demo-model demonstrating flow through the spacer between two membranes. The main objectives of the investigation were to measure velocity and estimate the magnitude of mixing index (MI) within a unit cell of the turbulence promoter net. The control of mixing intensity next to the membrane walls enables controlling parameters such as flux, product concentration and the local mass transfer coefficient. The particle image velocimetry (PIV) method was used for velocity measurements and MI estimations. The results show that flow direction changes occur near the spacer rods mainly due to the existence of an obstacle that the flow had to bypass. Significant mixing intensity can be found at higher flow rates than those used regularly in membrane processes. A simple, steady state two-dimensional flow analysis confirmed the measurements’ main findings. It was also shown that the spacer between the membranes may induce membrane fouling close to the filaments.

[1]  Do-Hyeong Kim,et al.  Large-Eddy Simulation of Turbulent Flow Past a Square Cylinder Confined in a Channel , 2002 .

[2]  B. Mikic,et al.  Minimum-dissipation transport enhancement by flow destabilization: Reynolds’ analogy revisited , 1988, Journal of Fluid Mechanics.

[3]  Gunnar Eigil Jonsson,et al.  Flow dynamics and concentration polarisation in spacer-filled channels☆ , 2002 .

[4]  R. Adrian.  Particle-Imaging Techniques for Experimental Fluid Mechanics , 1991 .

[5]  Christian Trägårdh,et al.  Computer simulations of mass transfer in the concentration boundary layer over ultrafiltration membranes , 1993 .

[6]  V. Kottke,et al.  Visualization and determination of local mass transfer at solid walls in liquid flow , 1998 .

[7]  A. B. de Haan,et al.  Optimization of non-woven spacers by CFD and validation by experiments , 2002 .

[8]  Michael K. Stenstrom,et al.  An unsteady-state model to predict concentration polarization in commercial spiral wound membranes , 1999 .

[9]  I. Grant.  Particle image velocimetry: A review , 1997 .

[10]  William G. Light,et al.  Improvement of Thin-Channel Design for Pressure-Driven Membrane Systems , 1981 .

[11]  W. T. Hanbury,et al.  Spiral wound modules performance an analytical solution: Part II , 1991 .

[12]  M. Gharib,et al.  On errors of digital particle image velocimetry , 1997 .

[13]  Dianne E. Wiley,et al.  Novel spacer design improves observed flux , 2004 .

[14]  S. V. Polyakov,et al.  Turbulence promoter geometry: its influence on salt rejection and pressure losses of a composite-membrane spiral would module , 1992 .

[15]  A. Melling.  Tracer particles and seeding for particle image velocimetry , 1997 .

[16]  Jasmedh Kaur,et al.  Studies on protein transmission in thin channel flow module: the role of dean vortices for improving mass transfer , 2002 .

[17]  David F. Fletcher,et al.  A CFD study of unsteady flow in narrow spacer-filled channels for spiral-wound membrane modules , 2002 .

[18]  G. Schock,et al.  Mass transfer and pressure loss in spiral wound modules , 1987 .

[19]  G. Belfort,et al.  Dean vortices with wall flux in a curved channel membrane system: 4. Effect of vortices on permeation fluxes of suspensions in microporous membrane , 1993 .

[20]  Viriato Semiao,et al.  The effect of the ladder-type spacers configuration in NF spiral-wound modules on the concentration boundary layers disruption☆ , 2002 .

[21]  David F. Fletcher,et al.  Simulation of the Flow around Spacer Filaments between Narrow Channel Walls. 1. Hydrodynamics , 2002 .

[22]  Sandeep K. Karode,et al.  Flow visualization through spacer filled channels by computational fluid dynamics I. , 2001 .

[23]  Anthony G. Fane,et al.  Net-Type Spacers: Effect of Configuration on Fluid Flow Path and Ultrafiltration Flux , 1994 .

[24]  Large eddy simulation of turbulent flow past a square cylinder confined in a channel , 2004 .

[25]  P. R. Neal,et al.  Estimation of foulant deposition across the leaf of a spiral-wound module☆ , 2002 .

[26]  J Schwinge,et al.  Characterization of a zigzag spacer for ultrafiltration , 2000 .

[27]  Dianne E. Wiley,et al.  CFD simulations of net-type turbulence promoters in a narrow channel , 2001 .

[28]  P. R. Neal,et al.  The effect of filament orientation on critical flux and particle deposition in spacer-filled channels , 2003 .

[29]  M. G. Parvatiyar,et al.  Mass transfer in a membrane tube with turbulent flow of Newtonian and non-Newtonian fluids , 1998 .

[30]  Ken Darcovich,et al.  Turbulent transport in membrane modules by CFD simulation in two dimensions , 1995 .

[31]  Keith Scott,et al.  Mass transfer characteristics of cross-corrugated membranes , 2002 .

[32]  Georges Belfort,et al.  Dean vortices with wall flux in a curved channel membrane system , 1993 .

[33]  W. Kaminski,et al.  An effect of vortex flow on fluxes in ultrafiltration plate-frame modules , 1997 .

[34]  S. Vigneswaran,et al.  Experimental assessment of filtration of biomass with transverse and axial fibres , 2002 .

[35]  Viriato Semiao,et al.  Flow management in nanofiltration spiral wound modules with ladder-type spacers , 2002 .

[36]  A. B. de Haan,et al.  Optimization of commercial net spacers in spiral wound membrane modules , 2002 .

[37]  V. Kottke,et al.  Effects of spacer geometry on pressure drop, mass transfer, mixing behavior, and residence time distribution , 1996 .

[38]  A. Friedl,et al.  CFD-simulation of mass transfer effects in gas and vapour permeation modules☆ , 2002 .

[39]  C. Pozrikidis.  Boundary conditions for shear flow past a permeable interface modeled as an array of cylinders , 2004 .

[40]  Anthony G. Fane,et al.  Optimal channel spacer design for ultrafiltration , 1991 .

[41]  Anthony G. Fane,et al.  Effects of net-type spacers on heat and mass transfer in direct contact membrane distillation and comparison with ultrafiltration studies , 2003 .

[42]  Viriato Semiao,et al.  Hydrodynamics and concentration polarization in NF/RO spiral-wound modules with ladder-type spacers , 2003 .

[43]  S. G. Yiantsios,et al.  Numerical simulation of the flow in a plane-channel containing a periodic array of cylindrical turbulence promoters , 2004 .

[44]  Dianne E. Wiley,et al.  Spacer characterization and pressure drop modelling in spacer-filled channels for ultrafiltration☆ , 1994 .

[45]  W. T. Hanbury,et al.  Optimal design of spiral wound modules: an analytical method , 1995 .

[46]  David F. Fletcher,et al.  Simulation of the Flow around Spacer Filaments between Channel Walls. 2. Mass-Transfer Enhancement , 2002 .

[47]  Markus Raffel,et al.  Particle Image Velocimetry: A Practical Guide , 2002 .