Low-Overhead Maximum Power Point Tracking for Micro-Scale Solar Energy Harvesting Systems

Environmental energy harvesting is a promising approach to achieving extremely long operational lifetimes in a variety of micro-scale electronic systems. Maximum power point tracking (MPPT) is a technique used in energy harvesting systems to maximize the amount of harvested power. Existing MPPT methods, originally intended for large-scale systems, incur high power overheads when used in micro-scale energy harvesting, where the output voltage of the transducers is very low (less than 500mV) and the harvested power is miniscule (only hundreds of μW). This paper presents a low-overhead MPPT algorithm for micro-scale solar energy harvesting systems. The proposed algorithm is based on the use of a negative feedback control loop and is particularly amenable to hardware-efficient implementation. We have used the proposed algorithm to design a micro-scale solar energy harvesting system, which has been implemented using IBM 45nm technology. Post-layout simulation results demonstrate that the proposed MPPT scheme successfully tracks the optimal operating point with a tracking error of less than 1% and incurs minimal power overheads.

[1]  Kaushik Roy,et al.  Maximum power point considerations in micro-scale solar energy harvesting systems , 2010, Proceedings of 2010 IEEE International Symposium on Circuits and Systems.

[2]  Hui Shao,et al.  The Design of a Micro Power Management System for Applications Using Photovoltaic Cells With the Maximum Output Power Control , 2009, IEEE Transactions on Very Large Scale Integration (VLSI) Systems.

[3]  Kaushik Roy,et al.  Efficient power conversion for ultra low voltage micro scale energy transducers , 2010, 2010 Design, Automation & Test in Europe Conference & Exhibition (DATE 2010).

[4]  K. Strunz,et al.  20mV input boost converter for thermoelectric energy harvesting , 2009, 2009 Symposium on VLSI Circuits.

[5]  Luca Benini,et al.  An Efficient Solar Energy Harvester for Wireless Sensor Nodes , 2008, 2008 Design, Automation and Test in Europe.

[6]  Vijay Raghunathan,et al.  Design and Power Management of Energy Harvesting Embedded Systems , 2006, ISLPED'06 Proceedings of the 2006 International Symposium on Low Power Electronics and Design.

[7]  P.L. Chapman,et al.  Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[8]  Erick O. Torres,et al.  Electrostatic Energy-Harvesting and Battery-Charging CMOS System Prototype , 2009, IEEE Transactions on Circuits and Systems I: Regular Papers.

[9]  Vivek De,et al.  Effectiveness of adaptive supply voltage and body bias for reducing impact of parameter variations in low power and high performance microprocessors , 2002, VLSIC 2002.

[10]  Loreto Mateu,et al.  Review of energy harvesting techniques and applications for microelectronics (Keynote Address) , 2005, SPIE Microtechnologies.

[11]  Kaushik Roy,et al.  On-Chip Variability Sensor Using Phase-Locked Loop for Detecting and Correcting Parametric Timing Failures , 2010, IEEE Transactions on Very Large Scale Integration (VLSI) Systems.

[12]  Kostas Kalaitzakis,et al.  Development of a microcontroller-based, photovoltaic maximum power point tracking control system , 2001 .

[13]  Min Chen,et al.  Single inductor, multiple input, multiple output (SIMIMO) power mixer-charger-supply system , 2007, Proceedings of the 2007 international symposium on Low power electronics and design (ISLPED '07).

[14]  Hui Shao,et al.  A micro power management system and maximum output power control for solar energy harvesting applications , 2007, Proceedings of the 2007 international symposium on Low power electronics and design (ISLPED '07).

[15]  Naveen Verma,et al.  Ultralow-power electronics for biomedical applications. , 2008, Annual review of biomedical engineering.