论文信息 - Geometric design of involute spur gear drives with symmetric and asymmetric teeth using the Realized Potential Method - 字舞流文

Geometric design of involute spur gear drives with symmetric and asymmetric teeth using the Realized Potential Method

Ognyan Alipiev | O. Alipiev

[1] Robert Errichello,et al. The Geometry of Involute Gears , 1987 .

[2] F. Litvin,et al. Gear geometry and applied theory , 1994 .

[3] Faydor L. Litvin,et al. Asymmetric modified spur gear drives: reduction of noise, localization of contact, simulation of meshing and stress analysis , 2000 .

[4] Alexander L. Kapelevich,et al. Geometry and design of involute spur gears with asymmetric teeth , 2000 .

[5] Katsumi Inoue,et al. Bending Load Capacity Enhancement Using an Asymmetric Tooth Profile , 2003 .

[6] Shyue-Cheng Yang. Study on an internal gear with asymmetric involute teeth , 2007 .

[7] G. D. Francesco,et al. Asymmetric Teeth: Bending Stress Calculation , 2007 .

[8] Fatih Karpat,et al. Dynamic analysis of involute spur gears with asymmetric teeth , 2008 .

[9] V. Senthil Kumar,et al. Optimization of asymmetric spur gear drives to improve the bending load capacity , 2008 .

[10] Vasilios Spitas,et al. Reduction of gear fillet stresses by using one-sided involute asymmetric teeth , 2009 .