Local measurements for the study of external loop airlift hydrodynamics

Hot-film anemometry and an optical biprobe are used to measure local flow characteristics in the riser of an external loop airlift reactor. Important flow asymmetries are observed above the sparger and developing flow persists through a large part of the riser. As gas flow rate increases, radial gas hold-up profiles change from relatively flat to parabolic while the shape of radial liquid velocity profiles remains constant and Sauter bubble diameter increases. At large gas superficial velocities, slip velocity is found to deviate considerably from the frequently used value of 0.25 m/s. Local measurements allow a better understanding of two-phase flow in airlift reactors and can be used for CFD-modeling development and validation.

[1]  Nigel N. Clark,et al.  Chord length distributions related to bubble size distributions in multiphase flows , 1988 .

[2]  Milorad P. Dudukovic,et al.  18 Gas holdup and liquid recirculation in gas-lift reactors , 1980 .

[3]  M. Moo-Young,et al.  Liquid circulation in airlift reactors , 1988 .

[4]  K. Schügerl,et al.  Fluiddynamic characterization of airlift tower loop bioreactors with and without motionless mixtures , 1995 .

[5]  Gerhart Eigenberger,et al.  Gas—liquid flow in bubble columns and loop reactors: Part II. Comparison of detailed experiments and flow simulations , 1994 .

[6]  Chafaa Bentifraouine.  Hydrodynamique globale, locale et transfert de matière dans un réacteur airlift à boucle externe , 1997 .

[7]  P. Letón,et al.  A fluid dynamic model for bubble columns and airlift reactors , 1991 .

[8]  F. Larachi,et al.  Understanding gas-phase hydrodynamics in bubble columns: a convective model based on kinetic theory , 1997 .

[9]  A. Lübbert,et al.  Influence of the wakes in bubble driven multiphase flow systems , 1992 .

[10]  E. García-Calvo,et al.  Prediction of gas hold‐up and liquid velocity in airlift reactors using two‐phase flow friction coefficients , 1996 .

[11]  Gerhart Eigenberger,et al.  Gas—liquid flow in bubble columns and loop reactors: Part I. Detailed modelling and numerical simulation , 1994 .

[12]  C. Marks.  Measurements of the Terminal Velocity of Bubbles Rising in a Chain , 1973 .

[13]  M. Lilly,et al.  The influence of vessel height and top‐section size on the hydrodynamic characteristics of airlift fermentors , 1994, Biotechnology and bioengineering.

[14]  S. G. Bankoff,et al.  Structure of air-water bubbly flow in a vertical pipe—I. liquid mean velocity and turbulence measurements , 1993 .

[15]  T. J. Liu.  Bubble size and entrance length effects on void development in a vertical channel , 1993 .

[16]  Jose C. Merchuk,et al.  Hydrodynamics in rectangular air-lift reactors: Scale-up and the scale-up and the influence of gas-liquid separator design , 1991 .

[17]  Thomas Menzel,et al.  Reynolds shear stress for modeling of bubble column reactors , 1990 .

[18]  H. Koyama,et al.  Gas Holdups and Friction Factors of Gas-Liquid Two-Phase Flow in an Air-lift Bubble Column , 1988 .

[19]  C. Xuereb,et al.  An Experimental Study of the Hydrodynamic Characteristics of External Loop Airlift Contactors , 1997 .

[20]  A. Lübbert,et al.  Detailed investigations of the multiphase flow in airlift tower loop reactors , 1990 .

[21]  David F. Ollis,et al.  Airlift bioreactors: Analysis of local two‐phase hydrodynamics , 1991 .

[22]  V. Roig,et al.  Experimental investigation of a turbulent bubbly mixing layer , 1998 .

[23]  J. Merchuk,et al.  Concentric-tube airlift reactors: effects of geometrical design on performance. , 1994 .

[24]  Kh Choi,et al.  COMPARISON OF PROBE METHODS FOR MEASUREMENT OF BUBBLE PROPERTIES , 1990 .

[25]  J. F. Davidson,et al.  Gas hold-up in circulating bubble columns , 1988 .