The paper presents the performance of a square footing with a structural skirt resting on sand and subjected to a vertical load through an experimental study. A series of tests were conducted in a model test tank to evaluate the performance in terms of improvement in bearing capacity and reduction in settlement of a square footing with and without a structural skirt. The results of the study reveal that this type of reinforcement increases the bearing capacity, reduces the settlement and modifies the load settlement behaviour of the footing. The various factors influencing the bearing capacity improvements and settlement reduction using a structural skirt are identified. Skirt factors are proposed which can be introduced into the general ultimate bearing capacity equation for a square footing resting on sand. The predictions made through the modified equation are in reasonable agreement with the experimental results. The bearing capacity of square footing is increased in the range of 11.2 to 70%. The improvement in bearing capacity decreases with the increase in base roughness of the footing. Further, an equation for a settlement reduction factor is proposed which can be used to calculate the settlement of the square footing with structural skirt resting on sand. The settlement reduction factor (SRF, defined as the ratio of settlement of footing with structural skirt to the settlement of footing without structural skirt at a given load) was in the range 0.11 to 1.0 depending on applied load and skirt depth ratio with the use of a structural skirt. The results further reveal that for a given depth of the skirt, the settlement reduction factor decreases with the increase in applied load. The improvement in the bearing capacity and reduction in settlement of a square footing with a structural skirt resting on sand are dependent on the geometrical and structural properties of the skirt, footing, sand characteristics and interface conditions of the sand–skirt–footing system.
[1]
Kenneth L. Lee,et al.
BEARING CAPACITY ANALYSIS OF REINFORCED EARTH SLABS
,
1975
.
[2]
Evert C. Lawton,et al.
Bearing capacity of reinforced sand subgrades
,
1984
.
[3]
R. Butterfield,et al.
An Air Activated Sand Spreader for Forming Uniform Sand Beds
,
1970
.
[4]
Mark Randolph,et al.
Combined loading of skirted foundations
,
1998
.
[5]
M. Y. Al-Aghbari.
Settlement of Shallow Circular Foundations with Structural Skirts Resting on Sand
,
2007
.
[6]
Aleksandar S. Vesic,et al.
Analysis of Ultimate Loads of Shallow Foundations
,
1973
.
[7]
P. K. Ninan.
An Apparatus for Forming Uniform Beds of Sand for Model Foundation Tests
,
1968
.
[8]
N. C. Samtani,et al.
Laboratory Tests of Strip Footing on Reinforced Cohesive Soil
,
1989
.
[9]
J. Brinch Hansen.
AKADEMIET FOR DE TEKNISKE VIDENSKABER
,
2008
.
[10]
Yue Hu,et al.
Bearing response of skirted foundation on nonhomogeneous soil
,
1999
.
[11]
B. P. Verma,et al.
Bearing Capacity Tests on Reinforced Sand Subgrades
,
1986
.
[12]
M Y Al Aghbari.
Settlement of shallow square foundation with structural skirts resting on sand
,
2002
.
[13]
J. B. Hansen,et al.
A general formula for bearing capacity
,
1961
.
[14]
J. N. Mandal,et al.
Bearing capacity of strip footing resting on reinforced sand subgrades
,
1995
.
[15]
K. Terzaghi.
Theoretical Soil Mechanics
,
1943
.
[16]
M A Mahmoud,et al.
BEARING CAPACITY TESTS ON STRIP FOOTING RESTING ON REINFORCED SAND SUBGRADES
,
1989
.
[17]
George Geoffrey Meyerhof,et al.
Some recent research on the bearing capacity of foundations
,
1963
.