Study of the Transit-Time Limitations of the Impulse Response in Mid-Wave Infrared HgCdTe Avalanche Photodiodes

The impulse response in frontside-illuminated mid-wave infrared HgCdTe electron avalanche photodiodes (APDs) has been measured with localized photoexcitation at varying positions in the depletion layer. Gain measurements have shown an exponential gain, with a maximum value of M = 5000 for the diffusion current at a reverse bias of Vb = 12 V. When the light was injected in the depletion layer, the gain was reduced as the injection approached the N+ edge of the junction. The impulse response was limited by the diode series resistance–capacitance product, RC, due to the large capacitance of the diode metallization. Hence, the fall time is given by the RC constant, estimated as RC = 270 ps, and the rise time is due to the charging of the diode capacitance via the transit and multiplication of carriers in the depletion layer. The latter varies between t10–90 = 20 ps (at intermediate gains M < 500) and t10–90 = 70 ps (at M = 3500). The corresponding RC-limited bandwidth is BW = 600 MHz, which yields a new absolute record in gain–bandwidth product of GBW = 2.1 THz. The increase in rise time at high gains indicates the existence of a limit in the transit-time-limited gain–bandwidth product, GBW = 19 THz. The impulse response was modeled using a one-dimensional deterministic model, which allowed a quantitative analysis of the data in terms of the average velocity of electrons and holes. The fitting of the data yielded a saturation of the electron and hole velocity of ve = 2.3 × 107 cm/s and vh = 1.0 × 107 cm/s at electric fields E > 1.5 kV/cm. The increase in rise time at high bias is consistent with the results of Monte Carlo simulations and can be partly explained by a reduction of the electron saturation velocity due to frequent impact ionization. Finally, the model was used to predict the bandwidth in diodes with shorter RC = 5 ps, giving BW = 16 GHz and BW = 21 GHz for xj = 4 μm and xj = 2 μm, respectively, for a gain of M = 100.

[1]  Jeffrey D. Beck,et al.  The HgCdTe electron avalanche photodiode , 2004, 2006 Digest of the LEOS Summer Topical Meetings.

[2]  Jeremy Copley,et al.  A low-noise laser-gated imaging system for long-range target identification , 2004, SPIE Defense + Commercial Sensing.

[3]  S. Derelle,et al.  A Monte Carlo study of multiplication and noise in HgCdTe avalanche photodiodes , 2008, Photonics Europe.

[4]  M. Kinch,et al.  The HgCdTe electron avalanche photodiode , 2006, 2006 Digest of the LEOS Summer Topical Meetings.

[5]  John Marciniec,et al.  HgCdTe MWIR Back-Illuminated Electron-Initiated Avalanche Photodiode Arrays , 2007 .

[6]  Gérard Destefanis,et al.  Gain and Dark Current Characteristics of Planar HgCdTe Avalanche Photo Diodes , 2007 .

[7]  Neil T. Gordon,et al.  Photomultiplication with low excess noise factor in MWIR to optical fiber compatible wavelengths in cooled HgCdTe mesa diodes , 2005, SPIE Defense + Commercial Sensing.

[8]  R. B. Emmons,et al.  Avalanche‐Photodiode Frequency Response , 1967 .

[9]  Richard Scritchfield,et al.  Gated IR Imaging with 128 × 128 HgCdTe Electron Avalanche Photodiode FPA , 2008 .

[10]  J. Rothman,et al.  A Monte Carlo Study of $\hbox{Hg}_{0.7}\hbox{Cd}_{0.3}\hbox{Te}$ e-APD , 2009, IEEE Transactions on Electron Devices.

[11]  Bahaa E. A. Saleh,et al.  Effect of dead space on the excess noise factor and time response of avalanche photodiodes , 1990 .

[12]  Robert D. Allen,et al.  Evaluation of InGaAs camera for scientific near infrared imaging applications , 2006, SPIE Optics + Photonics.

[13]  F. Ma,et al.  HgCdTe electron avalanche photodiodes , 2004 .

[14]  Jean-Paul Chamonal,et al.  Impulse Response Time Measurements in Hg0.7Cd0.3Te MWIR Avalanche Photodiodes , 2008 .

[15]  Jeffrey D. Beck,et al.  MWIR HgCdTe avalanche photodiodes , 2001, SPIE Optics + Photonics.