Effect of Surface Preparation by High-Temperature Hydrogen Annealing on the Passivation of Ni-20 At.% Cr Alloy in Sulfuric Acid
暂无分享,去创建一个
P. Marcus | A. Seyeux | S. Zanna | V. Maurice | L. Klein | Luntao Wang | D. Mercier | Junsoo Han | S. Neupane
[1] O. Gharbi,et al. Current state of electrochemical techniques and corrosion rate analysis for next-generation materials , 2022, Current Opinion in Electrochemistry.
[2] I. Guillot,et al. Enhanced passivity of Cr-Fe-Co-Ni-Mo multi-component single-phase face-centred cubic alloys: design, production and corrosion behaviour , 2022, Corrosion Science.
[3] E. Lundgren,et al. Thickness and composition of native oxides and near-surface regions of Ni superalloys , 2022, Journal of Alloys and Compounds.
[4] P. Marcus,et al. Thermal stability of surface oxides on nickel alloys (NiCr and NiCrMo) investigated by XPS and ToF-SIMS , 2021, Applied Surface Science.
[5] S. Kim,et al. Effects of reducing atmospheres of bright annealing on the surface and corrosion characteristics of super duplex stainless steel tubes , 2021 .
[6] M. Orazem,et al. impedance response of a thin film on an electrode: Deciphering the influence of the double layer capacitance. , 2021, Chemphyschem : a European journal of chemical physics and physical chemistry.
[7] L. Marks,et al. Oxygen injection during fast vs slow passivation in aqueous solution , 2021, Acta Materialia.
[8] Matthew R. Barone,et al. Initial atomic-scale oxidation pathways on a Ni–15Cr(100) alloy surface , 2021, npj Materials Degradation.
[9] J. Scully,et al. Electrochemical stability, physical, and electronic properties of thermally pre-formed oxide compared to artificially sputtered oxide on Fe thin films in aqueous chloride , 2021, Corrosion Science.
[10] P. Marcus,et al. XPS and ToF-SIMS Investigation of Native Oxides and Passive Films Formed on Nickel Alloys Containing Chromium and Molybdenum , 2021 .
[11] J. Saal,et al. Element redistributions during early stages of oxidation in a Ni38Cr22Fe20Mn10Co10 multi-principal element alloy , 2021 .
[12] M. Biesinger,et al. Investigating the Role of Mo and Cr during the Activation and Passivation of Ni-Based Alloys in Acidic Chloride Solution , 2021, Journal of The Electrochemical Society.
[13] B. Normand,et al. Relationship between the Resistivity Profiles Obtained from the Power Law Model and the Physico-Chemical Properties of Passive Films , 2021 .
[14] H. Abe,et al. Effect of Mechanical Surface Treatments on the Surface State and Passive Behavior of 304L Stainless Steel , 2021, Metals.
[15] J. Lu,et al. Enhanced Mechanical Properties and Corrosion Resistance of 316l Stainless Steel by Pre-Forming a Gradient Nanostructured Surface Layer and Annealing , 2020, Acta Materialia.
[16] Chengshuang Zhou,et al. Enhanced Corrosion Resistance of Additively Manufactured 316L Stainless Steel After Heat Treatment , 2020 .
[17] A. Neville,et al. Revealing the superior corrosion protection of the passive film on selective laser melted 316L SS in a phosphate-buffered saline solution , 2020 .
[18] H. Ke,et al. DFT-Based Calculation of Dissolution Activation Energy and Kinetics of Ni–Cr Alloys , 2020 .
[19] J. Saal,et al. Aqueous passivation of multi-principal element alloy Ni38Fe20Cr22Mn10Co10: Unexpected high Cr enrichment within the passive film , 2020 .
[20] N. Haghdadi,et al. Additive manufacturing of steels: a review of achievements and challenges , 2020, Journal of Materials Science.
[21] G. Mori,et al. Effect of Polishing on Electrochemical Behavior and Passive Layer Composition of Different Stainless Steels , 2020, Materials.
[22] E. Schindelholz,et al. How build angle and post-processing impact roughness and corrosion of additively manufactured 316L stainless steel , 2020, npj Materials Degradation.
[23] Shuang Liu,et al. Pitting Corrosion Resistance on Annealing Treated Super Duplex Stainless Steel S32750 , 2020, Crystals.
[24] W. Nowak,et al. Differences in oxides morphology as a result of surface preparation of NiFe alloy , 2020 .
[25] H. Mirzadeh,et al. Unraveling the effects of surface preparation on the pitting corrosion resistance of austenitic stainless steel , 2020, Archives of Civil and Mechanical Engineering.
[26] I. Guillot,et al. Study of the surface oxides and corrosion behaviour of an equiatomic CoCrFeMnNi high entropy alloy by XPS and ToF-SIMS , 2020 .
[27] A. Lanzutti,et al. EIS comparative study and critical Equivalent Electrical Circuit (EEC) analysis of the native oxide layer of additive manufactured and wrought 316L stainless steel , 2020, Corrosion Science.
[28] M. Biesinger,et al. Investigating the transport mechanisms governing the oxidation of Hastelloy BC-1 by in situ ToF-SIMS , 2019, Corrosion Science.
[29] P. Marcus,et al. Mechanisms of Cr and Mo Enrichments in the Passive Oxide Film on 316L Austenitic Stainless Steel , 2019, Front. Mater..
[30] P. Marcus,et al. Origin of nanoscale heterogeneity in the surface oxide film protecting stainless steel against corrosion , 2019, npj Materials Degradation.
[31] A. Sikora,et al. Electropolishing of Stainless Steel in Laboratory and Industrial Scale , 2019, Metals.
[32] J. Cizek,et al. Annealing strategies for enhancing mechanical properties of additively manufactured 316L stainless steel deposited by cold spray , 2019, Surface and Coatings Technology.
[33] P. Marcus,et al. Passivation-Induced Physicochemical Alterations of the Native Surface Oxide Film on 316L Austenitic Stainless Steel , 2019, Journal of The Electrochemical Society.
[34] K. Ogle,et al. The Passivation of Ni-Cr-Mo Alloys: Time Resolved Enrichment and Dissolution of Cr and Mo during Passive-Active Cycles , 2019, Journal of The Electrochemical Society.
[35] J. Pan,et al. Passive film characterisation of duplex stainless steel using scanning Kelvin probe force microscopy in combination with electrochemical measurements , 2019, npj Materials Degradation.
[36] William H. Blades,et al. From Alloy to Oxide: Capturing the Early Stages of Oxidation on Ni-Cr(100) Alloys. , 2018, ACS applied materials & interfaces.
[37] L. Martinelli,et al. Tracer diffusion of Cr in Ni and Ni-22Cr studied by SIMS , 2018, Materialia.
[38] P. Marcus,et al. Comparative study of the surface oxide films on lean duplex and corresponding single phase stainless steels by XPS and ToF-SIMS , 2018, Corrosion Science.
[39] P. Marcus,et al. Current developments of nanoscale insight into corrosion protection by passive oxide films , 2018, Current Opinion in Solid State and Materials Science.
[40] Christopher M. Andolina,et al. In Situ Observations of Early Stage Oxidation of Ni-Cr and Ni-Cr-Mo Alloys , 2018, Corrosion.
[41] A. Góral,et al. Influence of Surface Pretreatment on the Corrosion Resistance of Cold-Sprayed Nickel Coatings in Acidic Chloride Solution , 2018, Journal of Materials Engineering and Performance.
[42] D. Young,et al. Temperature Effect on Oxidation Behavior of Ni-Cr Alloys in CO2Gas Atmosphere , 2017 .
[43] M. Ziętala,et al. The microstructure, mechanical properties and corrosion resistance of 316 L stainless steel fabricated using laser engineered net shaping , 2016 .
[44] M. Orazem,et al. Comparison of different methods for measuring the passive film thickness on metals , 2016 .
[45] L. Luo,et al. In situ atomic scale visualization of surface kinetics driven dynamics of oxide growth on a Ni-Cr surface. , 2016, Chemical communications.
[46] P. Marcus,et al. The fate of the protective oxide film on stainless steel upon early stage growth of a biofilm , 2015 .
[47] M. Olszta,et al. Grain boundary depletion and migration during selective oxidation of Cr in a Ni–5Cr binary alloy exposed to high-temperature hydrogenated water , 2014 .
[48] P. Marcus,et al. Structural, Magnetic, Electronic, Defect, and Diffusion Properties of Cr2O3: A DFT+U Study , 2014 .
[49] Erick A. White,et al. On the Use of the power-law model for interpreting constant-phase-element parameters , 2014 .
[50] J. Bubendorff,et al. Electrochemical and Structural Characterization of Nickel based Alloys Oxides , 2014 .
[51] D. Shoesmith,et al. Characterization of surface composition on Alloy 22 in neutral chloride solutions , 2013 .
[52] D. Shoesmith,et al. Characterization of film properties on the NiCrMo Alloy C-2000 , 2013 .
[53] P. Marcus,et al. Oxide Film Growth Kinetics on Metals and Alloys I. Physical Model , 2013 .
[54] T. Grgurić,et al. Transformation of austenite during isothermal annealing at 600–900 °C for heat-resistant stainless steel , 2013 .
[55] K. Rokosz,et al. Characterization of Passive Film Formed on AISI 316L Stainless Steel after Magnetoelectropolishing in a Broad Range of Polarization Parameters , 2012 .
[56] Vincent Vivier,et al. Constant-Phase-Element Behavior Caused by Resistivity Distributions in Films II. Applications , 2010 .
[57] Su-Moon Park,et al. Electrochemical impedance spectroscopy. , 2010, Annual review of analytical chemistry.
[58] Mark E. Orazem,et al. Enhanced Graphical Representation of Electrochemical Impedance Data , 2006 .
[59] Chan‐Jin Park,et al. Effects of Sigma Phase on the Initiation and Propagation of Pitting Corrosion of Duplex Stainless Steel, January 2005 , 2005 .
[60] H. Strehblow,et al. XPS investigations of electrochemically formed passive layers on Fe/Cr-alloys in 0.5 M H2SO4 , 2004 .
[61] Jian-Jang Lai,et al. The effects of electropolishing (EP) process parameters on corrosion resistance of 316L stainless steel , 2003 .
[62] D. Landolt,et al. Passive films on stainless steels—chemistry, structure and growth , 2003 .
[63] P. Schmuki. From Bacon to barriers: a review on the passivity of metals and alloys , 2002 .
[64] M. Montemor,et al. Semiconducting properties of oxide and passive films formed on AISI 304 stainless steel and Alloy 600 , 2002 .
[65] Joseph R. Davis. Nickel, cobalt, and their alloys , 2000 .
[66] D. Macdonald. Passivity–the key to our metals-based civilization , 1999 .
[67] P. Marcus,et al. X‐Ray Photoelectron Spectroscopy and Scanning Tunneling Microscopy Study of Passive Films Formed on (100) Fe‐18Cr‐13Ni Single‐Crystal Surfaces , 1998 .
[68] P. Borthen,et al. X‐Ray Photoelectron Spectroscopic Examinations of Electrochemically Formed Passive Layers on Ni‐Cr Alloys , 1997 .
[69] P. Marcus,et al. XPS and STM Study of Passive Films Formed on Fe‐22Cr(110) Single‐Crystal Surfaces , 1996 .
[70] S. Mikhailov,et al. Analytical and electrochemical study of passive films formed on nickel—chromium alloys: Influence of the chromium bulk concentration , 1994 .
[71] N. McIntyre,et al. Studies of initial oxidation of nickel–chromium alloys: Surface annealing by hydrogen ion bombardment , 1986 .
[72] M. Sluyters-Rehbach,et al. The analysis of electrode impedances complicated by the presence of a constant phase element , 1984 .
[73] I. Olefjord. The passive state of stainless steels , 1980 .
[74] M. Cohen,et al. The Effect of Surface Preparation on Oxide Films on Cr and Fe‐Cr Alloys , 1961 .