Microstructural evolution at the initial stages of continuous annealing of cold rolled dual-phase steel

Abstract The performance of cold rolled dual-phase (DP) steels depends on their microstructure, which results from the thermomechanical processing conditions, involving hot rolling, cold rolling, and continuous annealing. The knowledge on the influence of each annealing stage on the microstructure formation is essential for manufacturing high-quality DP steels. In the present work, the effects of some intercritical annealing parameters (heating rate, soaking temperature, soaking time, and quench temperature) on the microstructure and mechanical properties of a cold rolled DP steel (0.08% C–1.91% Mn) were studied. The microstructure of specimens quenched after each annealing stage, simulated on a Gleeble, was analyzed using optical, scanning, and transmission electron microscopy. The tensile properties, determined for specimens submitted to complete annealing cycles, are influenced by the volume fractions of martensite, bainite, martensite/austenite (MA) constituent, and carbides, which depend on annealing processing parameters. The results obtained showed that the yield strength (YS) increase and the ultimate tensile strength (UTS) decrease with the increasing intercritical temperature. This can be explained by the increased formation of granular bainite associated with the increased volume fraction of austenite formed at the higher temperatures. The experimental data also showed that, for the annealing cycles carried out, UTS values in excess of 600 MPa could be obtained with the steel investigated.

[1]  N. Takeda,et al.  Influence of Microstructural Morphology and Prestraining on Short Fatigue Crack Propagation in Dual-phase Steels , 2001 .

[2]  Sangho Kim,et al.  Effects of martensite morphology and volume fraction on quasi-static and dynamic deformation behavior of dual-phase steels , 2000 .

[3]  John G. Speer,et al.  A perspective on the morphology of bainite , 1990 .

[4]  D. Matlock,et al.  The effect of intercritical annealing temperature on the structure of niobium microalloyed dualphase steel , 1980 .

[5]  Y. Tomita.  Effect of morphology of second-phase martensite on tensile properties of Fe-0.1C dual phase steels , 1990 .

[6]  Martin Pugh,et al.  Properties of thermomechanically processed dual-phase steels containing fibrous martensite , 2002 .

[7]  D. T. Llewellyn,et al.  Dual phase steels , 1996 .

[8]  G. Speich,et al.  Formation of Austenite During Intercritical Annealing of Dual-Phase Steels , 1981 .

[9]  Process Factors for Cold-rolled Dual-phase Sheet Steels , 1981 .

[10]  N. C. Goel,et al.  A theoretical model for the flow behavior of commercial dual-phase steels containing metastable retained austenite: Part I. derivation of flow curve equations , 1985 .

[11]  G. Purdy,et al.  Carbide Dissolution and Austenite Growth in the Intercritical Annealing of Fe–C–Mn Dual Phase Steels , 1984 .

[12]  M. Erdogan,et al.  Effect of epitaxial ferrite on yielding and plastic flow in dual phase steel in tension and compression , 1999 .

[13]  J. G. Thomson,et al.  Effect of hot band microstructure on strength and ductility of cold rolled dual phase steel. , 1987 .

[14]  H. Bunge,et al.  Recrystallization kinetics of a cold rolled dual-phase steel sheet , 1984 .