Facet-specific interaction between methanol and TiO2 probed by sum-frequency vibrational spectroscopy

Significance Facet engineering has become a major strategy for designing crystalline catalysts, yet many fundamental issues, including facet-specific interaction with adsorbates, remain unsolved due to lack of experimental investigation. Using surface-specific sum-frequency vibrational spectroscopy, we have conducted an in-depth study of methanol adsorption on four different facets of TiO2 under ambient conditions. The spectra revealed that for the four facets investigated, dissociation of adsorbed methanol occurs only when surface defects are present. Adsorption kinetics and energetics appeared nearly the same on different facets, but the Fermi resonance coupling strength for CH3 of adsorbed methanol was found to depend sensitively on facets and methanol coverage, and could serve as a gauge for studying facet effects on molecular adsorption and surface reactions. The facet-specific interaction between molecules and crystalline catalysts, such as titanium dioxides (TiO2), has attracted much attention due to possible facet-dependent reactivity. Using surface-sensitive sum-frequency vibrational spectroscopy, we have studied how methanol interacts with different common facets of crystalline TiO2, including rutile(110), (001), (100), and anatase(101), under ambient temperature and pressure. We found that methanol adsorbs predominantly in the molecular form on all of the four surfaces, while spontaneous dissociation into methoxy occurs preferentially when these surfaces become defective. Extraction of Fermi resonance coupling between stretch and bending modes of the methyl group in analyzing adsorbed methanol spectra allows determination of the methanol adsorption isotherm. The isotherms obtained for the four surfaces are nearly the same, yielding two adsorbed Gibbs free energies associated with two different adsorption configurations singled out by ab initio calculations. They are (i) ∼−20 kJ/mol for methanol with its oxygen attached to a low-coordinated surface titanium, and (ii) ∼−5 kJ/mol for methanol hydrogen-bonded to a surface oxygen and a neighboring methanol molecule. Despite similar adsorption energetics, the Fermi resonance coupling strength for adsorbed methanol appears to depend sensitively on the surface facet and coverage.

[1]  Yuanqin Yu,et al.  Complete Raman spectral assignment of methanol in the C-H stretching region. , 2013, The journal of physical chemistry. A.

[2]  Wenshao Yang,et al.  Molecular hydrogen formation from photocatalysis of methanol on anatase-TiO₂(101). , 2014, Journal of the American Chemical Society.

[3]  J. Nørskov,et al.  Oxygen vacancies as active sites for water dissociation on rutile TiO(2)(110). , 2001, Physical review letters.

[4]  Ulrike Diebold,et al.  The surface science of titanium dioxide , 2003 .

[5]  Hafner,et al.  Ab initio molecular dynamics for liquid metals. , 1995, Physical review. B, Condensed matter.

[6]  H. Fidder,et al.  Hydrogen-bonding-induced enhancement of Fermi resonances: a linear IR and nonlinear 2D-IR study of aniline-d5. , 2013, The journal of physical chemistry. B.

[7]  B. Solomonov,et al.  Gibbs free energy of hydrogen bonding of aliphatic alcohols with liquid water at 298 K , 2012 .

[8]  K. Syres,et al.  Adsorption of Organic Molecules on Rutile TiO2 and Anatase TiO2 Single Crystal Surfaces , 2012 .

[9]  Jinlong Yang,et al.  Theoretical study of the molecular and electronic structure of methanol on a TiO2(110) surface , 2009 .

[10]  G. Somorjai,et al.  Polar ordering at the liquid-vapor interface of n-alcohols (C1-C8) , 1995 .

[11]  Yaochun Shen,et al.  Interfacial layer structure at alcohol/silica interfaces probed by sum-frequency vibrational spectroscopy , 2005 .

[12]  Yi Luo,et al.  Intermolecular Interactions at the Interface Quantified by Surface-Sensitive Second-Order Fermi Resonant Signals , 2015 .

[13]  Y. Horiuchi,et al.  Understanding TiO2 photocatalysis: mechanisms and materials. , 2014, Chemical reviews.

[14]  V. Sokolov,et al.  Molecular dynamics simulation of liquid methanol. I. Molecular modeling including C-H vibration and Fermi resonance. , 2011, The Journal of chemical physics.

[15]  T. Tachikawa,et al.  Evidence for crystal-face-dependent TiO2 photocatalysis from single-molecule imaging and kinetic analysis. , 2011, Journal of the American Chemical Society.

[16]  Y. Shen,et al.  In situ sum-frequency vibrational spectroscopy of electrochemical interfaces with surface plasmon resonance , 2014, Proceedings of the National Academy of Sciences.

[17]  G. A. Jeffrey,et al.  An Introduction to Hydrogen Bonding , 1997 .

[18]  Li-Qiong Wang,et al.  Electronic structure calculations of small molecule adsorbates on (110) and (100) TiO2 , 1998 .

[19]  Zefeng Ren,et al.  In Situ Studies on the Dissociation and Photocatalytic Reactions of CH3OH on TiO2 Thin Film by Sum Frequency Generation Vibrational Spectroscopy , 2015 .

[20]  U. Diebold,et al.  Reaction of O2 with Subsurface Oxygen Vacancies on TiO2 Anatase (101) , 2013, Science.

[21]  A. Fujishima,et al.  TiO2 photocatalysis and related surface phenomena , 2008 .

[22]  Chuanyi Wang,et al.  Molecular Species on Nanoparticulate Anatase TiO2 Film Detected by Sum Frequency Generation: Trace Hydrocarbons and Hydroxyl Groups , 2003 .

[23]  Georg Kresse,et al.  Direct view at excess electrons in TiO2 rutile and anatase. , 2014, Physical review letters.

[24]  E. Román,et al.  Adsorption of methanol on the low Ti+3 point defects of the TiO2(001) surface at 300 K , 1990 .

[25]  Yadong Li,et al.  Evolution of anatase surface active sites probed by in situ sum-frequency phonon spectroscopy , 2016, Science Advances.

[26]  Zefeng Ren,et al.  Methanol Adsorption on TiO2 Film Studied by Sum Frequency Generation Vibrational Spectroscopy , 2015 .

[27]  Jian Pan,et al.  On the true photoreactivity order of {001}, {010}, and {101} facets of anatase TiO2 crystals. , 2011, Angewandte Chemie.

[28]  Martin Schwartz,et al.  Fermi resonance in aqueous methanol , 1980 .

[29]  M. Barteau,et al.  Reactions of methanol on TiO2(001) single crystal surfaces , 1989 .

[30]  D. Ben‐Amotz,et al.  Pressure Dependent Vibrational Fermi Resonance in Liquid CH3OH and CH2Cl2 , 1998 .

[31]  Y. Shen,et al.  Interfacial structures of methanol:water mixtures at a hydrophobic interface probed by sum-frequency vibrational spectroscopy. , 2006, The Journal of chemical physics.

[32]  Wenshao Yang,et al.  Strong photon energy dependence of the photocatalytic dissociation rate of methanol on TiO2(110). , 2013, Journal of the American Chemical Society.

[33]  Y. Shen.  Surface nonlinear optics [Invited] , 2011 .

[34]  Zhibo Ma,et al.  Stepwise photocatalytic dissociation of methanol and water on TiO2(110). , 2012, Journal of the American Chemical Society.

[35]  Zhibo Ma,et al.  Effect of the Hydrogen Bond in Photoinduced Water Dissociation: A Double-Edged Sword. , 2016, The journal of physical chemistry letters.

[36]  Y. Shen,et al.  Structure of the submonolayer of ethanol adsorption on a vapor/fused silica interface studied with sum frequency vibrational spectroscopy. , 2015, The journal of physical chemistry. A.

[37]  Minoru Obara,et al.  Femtosecond laser micromachining of TiO2 crystal surface for robust optical catalyst , 2000 .

[38]  Blöchl,et al.  Improved tetrahedron method for Brillouin-zone integrations. , 1994, Physical review. B, Condensed matter.

[39]  Surface nonlinear optics , 1980 .

[40]  Mary Jane Shultz,et al.  Surface Characterization of Nanoscale TiO2 Film by Sum Frequency Generation Using Methanol as a Molecular Probe , 2004 .

[41]  Wang,et al.  Accurate and simple analytic representation of the electron-gas correlation energy. , 1992, Physical review. B, Condensed matter.

[42]  M. A. Henderson.  A surface science perspective on TiO2 photocatalysis , 2011 .

[43]  Heather C. Allen,et al.  Surface studies of aqueous methanol solutions by vibrational broad bandwidth sum frequency generation spectroscopy , 2003 .

[44]  P. Cremer,et al.  Investigation of Water Structure at the TiO2/Aqueous Interface , 2004 .

[45]  Li‐Min Liu,et al.  Coverage Dependence of Methanol Dissociation on TiO2(110). , 2015, The journal of physical chemistry letters.

[46]  A. Selloni,et al.  Methanol adsorption and reactivity on clean and hydroxylated anatase(101) surfaces , 2004 .

[47]  Chuanyi Wang,et al.  Comparative study of acetic acid, methanol, and water adsorbed on anatase TiO2 probed by sum frequency generation spectroscopy. , 2005, Journal of the American Chemical Society.

[48]  M. Gillan,et al.  Adsorption of Methanol on TiO2(110): A First-Principles Investigation , 1998 .

[49]  A broadband and compact femtosecond delay compensator with birefringent crystals , 2017 .

[50]  Jin Zou,et al.  Anatase TiO2 single crystals with a large percentage of reactive facets , 2008, Nature.

[51]  Chuanyi Wang,et al.  Direct observation of competitive adsorption between methanol and water on TiO2: an in situ sum-frequency generation study. , 2004, Journal of the American Chemical Society.

[52]  Yang Wang,et al.  Role of point defects on the reactivity of reconstructed anatase titanium dioxide (001) surface , 2013, Nature Communications.

[53]  U. Diebold,et al.  Experimental Investigation of the Interaction of Water and Methanol with Anatase−TiO2(101) , 2003 .

[54]  Jinlong Yang,et al.  Site-specific photocatalytic splitting of methanol on TiO2(110) , 2010 .

[55]  G. Kresse,et al.  From ultrasoft pseudopotentials to the projector augmented-wave method , 1999 .

[56]  Wei Xiao,et al.  Enhanced photocatalytic CO₂-reduction activity of anatase TiO₂ by coexposed {001} and {101} facets. , 2014, Journal of the American Chemical Society.

[57]  G. Richmond,et al.  Ordered polyelectrolyte assembly at the oil–water interface , 2012, Proceedings of the National Academy of Sciences.

[58]  S. Baldelli,et al.  Quantitative orientation analysis by sum frequency generation in the presence of near-resonant background signal: acetonitrile on rutile TiO2 (110). , 2013, The journal of physical chemistry. A.

[59]  W. Gan,et al.  Determination of structure and energetics for gibbs surface adsorption layers of binary liquid mixture 1. Acetone + water. , 2005, The journal of physical chemistry. B.

[60]  Ruidan Zhang,et al.  Spectral Identification of Methanol on TiO2(110) Surfaces with Sum Frequency Generation in the C–H Stretching Region , 2015 .

[61]  J. Sanz,et al.  Methanol Adsorption and Dissociation on TiO2(110) from First Principles Calculations , 2007 .

[62]  D. Cahill,et al.  Competitive molecular adsorption at liquid/solid interfaces: A study by sum-frequency vibrational spectroscopy , 2007 .

[63]  Jian Wang,et al.  Nernst and Seebeck effects in a graphene nanoribbon , 2009, 1011.2666.

[64]  G. Somorjai,et al.  Determination of molecular surface structure, composition, and dynamics under reaction conditions at high pressures and at the solid-liquid interface. , 2011, Angewandte Chemie.