Implementation of the CMOS MEMS Condenser Microphone with Corrugated Metal Diaphragm and Silicon Back-Plate

This study reports a CMOS-MEMS condenser microphone implemented using the standard thin film stacking of 0.35 μm UMC CMOS 3.3/5.0 V logic process, and followed by post-CMOS micromachining steps without introducing any special materials. The corrugated diaphragm for the microphone is designed and implemented using the metal layer to reduce the influence of thin film residual stresses. Moreover, a silicon substrate is employed to increase the stiffness of the back-plate. Measurements show the sensitivity of microphone is −42 ± 3 dBV/Pa at 1 kHz (the reference sound-level is 94 dB) under 6 V pumping voltage, the frequency response is 100 Hz–10 kHz, and the S/N ratio >55 dB. It also has low power consumption of less than 200 μA, and low distortion of less than 1% (referred to 100 dB).

[1]  K. J. Gabriel,et al.  Post-CMOS processing for high-aspect-ratio integrated silicon microstructures , 2002 .

[2]  T. Brosnihan,et al.  A MEMS Condenser Microphone for Consumer Applications , 2006, 19th IEEE International Conference on Micro Electro Mechanical Systems.

[3]  Wouter Olthuis,et al.  A review of silicon microphones , 1994 .

[4]  Wouter Olthuis,et al.  The design, fabrication, and testing of corrugated silicon nitride diaphragms , 1994 .

[5]  J. Bergqvist.  Finite-element modelling and characterization of a silicon condenser microphone with a highly perforated backplate , 1993 .

[6]  H. S. Wolff,et al.  iRun: Horizontal and Vertical Shape of a Region-Based Graph Compression , 2022, Sensors.

[7]  H. Fujita,et al.  Large deflection performance of surface micromachined corrugated diaphragms , 1991, TRANSDUCERS '91: 1991 International Conference on Solid-State Sensors and Actuators. Digest of Technical Papers.

[8]  Burhanuddin Yeop Majlis,et al.  Design and fabrication of a new MEMS capacitive microphone using a perforated aluminum diaphragm , 2009 .

[9]  Hong-Ching Her,et al.  Acoustic analysis and fabrication of microelectromechanical system capacitive microphones , 2008 .

[10]  Zhijian Li,et al.  Single-chip condenser miniature microphone with a high sensitive circular corrugated diaphragm , 2002, Technical Digest. MEMS 2002 IEEE International Conference. Fifteenth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.02CH37266).

[11]  Allan D. Pierce,et al.  Acoustical Society of America , 2005 .

[12]  K. J. Gabriel,et al.  CMOS-MEMS membrane for audio-frequency acoustic actuation , 2001, Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090).

[13]  Weileun Fang,et al.  Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes , 2005 .