Low-loss photonic wires and compact ring resonators in silicon-on-insulator

We fabricated single-mode photonic wires, nanophotonic waveguides confining light by total internal reflection. The structures are defined in silicon-on-insulator using 248nm deep UV lithography, a widely adopted technology for CMOS applications. The crystalline silicon core has a thickness of 220nm and a width of up to 600nm. A 1um thick silica layer serves as the lower cladding. We measured the loss of straight waveguides using the Fabry-Perot interference spectrum of the cleaved samples. A 500nm wide waveguide has a loss as low as 2.4dB/cm at 1550nm wavelength. We measured 90 degree bends to have excess losses of about 1dB. Mirror bends perform comparably. We fabricated symmetrically coupled ring and "racetrack" resonators with small radius. Q-factors higher than 3000 are achieved, leading to low add-drop crosstalk, high finesse and low at-resonance insertion loss. By fitting the theoretical model to the experimental results, we extracted parameters such as the coupling ratio, cavity loss and group index. We analyzed the fabrication tolerances allowed for these resonators to be suitable as a building block for WDM filtering components. The allowed deviation on the waveguide widths and gaps for the coupling ratio to be within specification are within the possibilities of the fabrication method. However, a method to tightly control the optical cavity length is needed as the ring's group index is highly dependent on waveguide width.

[1]  Wim Bogaerts,et al.  Scattering at sidewall roughness in photonic crystal slabs. , 2003, Optics letters.

[2]  Vincent Wiaux,et al.  Large-scale production techniques for photonic nanostructures , 2003, SPIE Optics + Photonics.

[3]  D. Taillaert,et al.  A compact two-dimensional grating coupler used as a polarization splitter , 2003, IEEE Photonics Technology Letters.

[4]  Mike V. Williamson,et al.  Enhanced quantitative analysis of resist image contrast upon line- edge roughness (LER) , 2003, SPIE Advanced Lithography.

[5]  L C Kimerling,et al.  Fabrication of ultralow-loss Si/SiO(2) waveguides by roughness reduction. , 2001, Optics letters.

[6]  S. Ho,et al.  Design and modeling of waveguide-coupled single-mode microring resonators , 1998 .

[7]  Roel Baets,et al.  Optical modelling of photonic crystals and VCSELs using eigenmode expansion and perfectly matched layers , 2001 .

[8]  R. Baets,et al.  Fabrication of photonic crystals in silicon-on-insulator using 248-nm deep UV lithography , 2002 .

[9]  H. Fukuda Analysis of line edge roughness using probability process model for chemically amplified resists , 2002, 2002 International Microprocesses and Nanotechnology Conference, 2002. Digest of Papers..

[10]  R.M. Osgood,et al.  Ultracompact corner-mirrors and T-branches in silicon-on-insulator , 2002, IEEE Photonics Technology Letters.

[11]  R. Osgood,et al.  A study of high-index-contrast 90 degree waveguide bend structures. , 2001, Optics express.