Characterization of microstructural changes in an Al-6.8 wt.% Mg alloy by electrical resistivity measurements

Abstract Microstructural changes in an AlMg6.8 alloy after different thermo mechanical (TMT) and sensitization treatments were investigated by electrical resistivity measurements. The electrical resistivity was most affected by the content of Mg solute atoms in the α-Al matrix, due to β-phase precipitation, while contribution of the dislocation density to the resistivity of the AlMg6.8 alloy was less pronounced. The amount and distribution of the β-phase precipitated during sensitization were found to be strongly affected by the microstructure developed under the previously applied TMTs, i.e. by the dislocation density and the primary β-phase particles in the dual (α + β) phase structure. During sensitization of the specimens with a recovered/recrystallized dual (α + β) phase structure, precipitation of randomly distributed, globular β-phase particles occurred. Sensitization of cold deformed and recrystallized single α-Al structures induced β-phase precipitation in the form of a continuous layer along the shear bands/grain boundaries.

[1]  Joseph R. Davis.  Corrosion of Aluminum and Aluminum Alloys , 1999 .

[2]  D. Lloyd,et al.  Microstructural control of aluminum sheet used in automotive applications , 1995 .

[3]  Y. Bréchet,et al.  Dislocation densities and stored energy after cold rolling of Al-Mg alloys: Investigations by resistivity and differential scanning calorimetry , 1997 .

[4]  A Comparative Study on the Softening Behaviour of Cold Rolled Ingot and Continuous Cast AA5754 , 2006 .

[5]  T. Chuang,et al.  Stress-corrosion cracking susceptibility of the superplastically formed 5083 aluminum alloy in 3.5 pct NaCl solution , 1999 .

[6]  W. Poole,et al.  Electrical Resistivity Measurements: A Sensitive Tool for Studying Aluminium Alloys , 2006 .

[7]  D. Hamana,et al.  Calorimetric study of pre-precipitation and precipitation in Al-Mg alloy , 1995 .

[8]  L. F. Mondolfo.  Aluminum alloys: Structure and properties , 1976 .

[9]  P. Ólafsson,et al.  Comparison of experimental, calculated and observed values for electrical and thermal conductivity of aluminium alloys , 1997 .

[10]  E. A. Starke,et al.  Aluminum alloys their physical and mechanical properties , 1986 .

[11]  J. Hatch,et al.  Aluminum: Properties and Physical Metallurgy , 1984 .

[12]  E. Romhanji,et al.  Stress corrosion cracking susceptibility of Al–Mg alloy sheet with high Mg content , 2002 .

[13]  Yumin Zhao,et al.  The effect of Mg precipitation on the mechanical properties of 5xxx aluminum alloys , 2005 .

[14]  W. Poole,et al.  Softening behaviour of cold rolled continuous cast and ingot cast aluminum alloy AA5754 , 2006 .

[15]  M. Surappa,et al.  Role of cold work and SiC reinforcements on the β′/β precipitation in Al-10 pct Mg alloy , 1998 .

[16]  Russel H. Jones,et al.  Role of Mg in the stress corrosion cracking of an Al-Mg alloy , 2001 .

[17]  M. Strangwood,et al.  Intergranular Corrosion and Stress Corrosion Cracking of Sensitised AA5182 , 2006 .

[18]  Russel H. Jones,et al.  Stress Corrosion Cracking of Al-Mg and Mg-Al Alloys , 2004 .