Abstract A new method of analysis is proposed for the extrusion of arbitrarily shaped sections through curved die profiles. A kinematically admissible velocity field is found by deriving the equation of a stream line. Conformal transformation of a unit circle onto a section is utilized in the derivation. The upper-bound method is then applied to determine the extrusion pressure for the rigid-perfectly plastic material. The redundant work relating to the velocity discontinuities at the entrance and the exit is included in the formulation. The general formulation for an arbitrary cross section is obtained by use of conformal transformation. The upper-bound pressure for extrusion through curved die profiles is computed for a complex section with a curved boundary. Two curved die profiles widely used are chosen to compare the effects of die profiles. From the derived velocity field, the upper-bound extrusion pressures are also computed for the extrusion of regular polygons and rectangles of various aspect ratios. The effects of sectional shape, die profile and interfacial friction at the die surface are discussed.
[1]
J. Halling,et al.
An upper-bound solution for axi-symmetric extrusion
,
1965
.
[2]
Betzalel Avitzur,et al.
Metal Flow Through Conical Converging Dies—A Lower Upper Bound Approach Using Generalized Boundaries of the Plastic Zone
,
1970
.
[3]
V. Nagpal,et al.
On the Solution of Three-Dimensional Metal-Forming Processes
,
1977
.
[4]
Dong-Yol Yang,et al.
An analysis for extrusion of helical shapes from round billets
,
1978
.
[5]
A new die profile with high process efficiency
,
1972
.
[6]
Rajnish Prakash,et al.
An analysis for drawing and extrusion of polygonal sections
,
1975
.