Inkjet-printing- and electroless-plating- based fabrication of RF circuit structures on high-frequency substrates

In this paper, a method to fabricate radio frequency (RF) circuit structures is described. This method involves inkjet printing of a silver nanoparticle-based ink on a functional substrate material to create the seed track (i.e., the seed layer), onto which copper is subsequently deposited by an electroless plating method, to obtain the desired thickness and conductivity of the RF structures. This process combination was validated by fabricating an S-band filter on a high-frequency substrate and comparing the RF performance of this filter with that of a filter fabricated using the conventional lithography-based method. The adhesion of the circuit structures to the substrate was qualitatively ascertained by the scotch tape test method. The performance of the inkjet-printed–electroless-plated filter was comparable to that of the conventional filter, thus proving the suitability of this novel method for practical RF applications.

[1]  Dirk Hegemann,et al.  Plasma treatment of polymers for surface and adhesion improvement , 2003 .

[2]  T. Cui,et al.  Polymer-based rectifying diodes on a glass substrate fabricated by ink-jet printing , 2005 .

[3]  Matti Mäntysalo,et al.  An inkjet-deposited antenna for 2.4 GHz applications , 2009 .

[4]  Jang Sub Kim,et al.  Direct writing of copper conductive patterns by ink-jet printing , 2007 .

[5]  C. Kao,et al.  Electroless Copper Plating onto Printed Lines of Nanosized Silver Seeds , 2007 .

[6]  T. Dupont,et al.  Capillary flow as the cause of ring stains from dried liquid drops , 1997, Nature.

[7]  Ghassan E. Jabbour,et al.  Simple Modification of Sheet Resistivity of Conducting Polymeric Anodes via Combinatorial Ink‐Jet Printing Techniques , 2005 .

[8]  W. Stark,et al.  Graphene-stabilized copper nanoparticles as an air-stable substitute for silver and gold in low-cost ink-jet printable electronics , 2008, Nanotechnology.

[9]  U. Schubert,et al.  Inkjet Printing of Narrow Conductive Tracks on Untreated Polymeric Substrates , 2008 .

[10]  R. Akkerman,et al.  Inkjet printing and adhesion characterisation of conductive tracks on a commercial printed circuit board material , 2009 .

[11]  Li Yang,et al.  RFID Tag and RF Structures on a Paper Substrate Using Inkjet-Printing Technology , 2007, IEEE Transactions on Microwave Theory and Techniques.

[12]  K. Yung,et al.  Fabrication of Polymer Silver Conductor Using Inkjet Printing and Low Temperature Sintering Process , 2008, IEEE Transactions on Electronics Packaging Manufacturing.

[13]  J. Kivilahti,et al.  Adhesion of electrolessly-deposited copper to photosensitive epoxy , 2001 .

[14]  V. Subramanian,et al.  An ink-jet-deposited passive component process for RFID , 2004, IEEE Transactions on Electron Devices.

[15]  J. Joung,et al.  A Study on Improvement of Interfacial Adhesion Energy of Inkjet-printed Ag Thin film on Polyimide by CF 4 Plasma Treatment , 2007 .