Theoretical and experimental investigation of heat pipe solar collector

Heat pipe solar collector was designed and constructed at IROST and its performance was measured on an outdoor test facility. The thermal behavior of a gravity assisted heat pipe solar collector was investigated theoretically and experimentally. A theoretical model based on effectiveness-NTU method was developed for evaluating the thermal efficiency of the collector, the inlet, outlet water temperatures and heat pipe temperature. Optimum value of evaporator length to condenser length ratio is also determined. The modelling predictions were validated using experimental data and it shows that there is a good concurrence between measured and predicted results.

[1]  Kim Choon Ng,et al.  Thermal performance of a flat-plate heat-pipe collector array , 1993 .

[2]  U. Ortabasi,et al.  An internal cusp reflector for an evacuated tubular heat pipe solar thermal collector , 1977 .

[3]  H. Hottel,et al.  Evaluation of flat-plate solar collector performance , 1955 .

[4]  S. A. Nada,et al.  Performance of a two-phase closed thermosyphon solar collector with a shell and tube heat exchanger , 2004 .

[5]  F. Moztarzadeh,et al.  An experimental study of a co-axial heat pipe solar collector , 1986 .

[6]  Xudong Zhao,et al.  A novel hybrid heat pipe solar collector/CHP system—Part 1: System design and construction , 2004 .

[7]  Armando C. Oliveira,et al.  Evaluation of the Use of Artificial Neural Networks for the Simulation of Hybrid Solar Collectors , 2004 .

[8]  A. Georgiev,et al.  Simulation and experimental results of a vacuum solar collector system with storage , 2005 .

[9]  Armando C. Oliveira,et al.  Analysis of a plate heat pipe solar collector , 2006 .

[10]  S. L. Abreu,et al.  An experimental study of two-phase closed thermosyphons for compact solar domestic hot-water systems , 2004 .

[11]  U. Mital,et al.  A two-phase closed thermosyphon , 1972 .

[12]  Amir Faghri,et al.  Heat Pipe Science And Technology , 1995 .

[13]  Xudong Zhao,et al.  Developing a theoretical model to investigate thermal performance of a thin membrane heat-pipe solar collector , 2005 .

[14]  John R. Hull,et al.  Analysis of heat transfer factors for a heat pipe absorber array connected to a common manifold , 1986 .