Design of a broadband passive X-band double-balanced mixer in SiGe HBT technology

In this paper, a passive double-balanced mixer in SiGe HBT technology is presented. Owing to lack of suitable passive mixing elements in the technology, the mixing elements are formed by diode-connected HBTs. The mixer uses lumped element Marchand baluns on both the local oscillator (LO) and the radio frequency (RF) port. A break out of the Marchand balun is measured. This demonstrates good phase and magnitude match of 0.7° and 0.11 dB, respectively. The Marchand baluns are broadband with a measured 3 dB bandwidth of 6.4 GHz, while still having a magnitude imbalance better than 0.4 dB and a phase imbalance better than 5°. Unfortunately with a rather high loss of 2.5 dB, mainly due to the low Q-factor of the inductors used. The mixer is optimized for use in doppler radars and is highly linear with a 1 dB compression point above 12 dBm IIP 2 of 66 dBm. The conversion gain at the center frequency of 8.5 GHz is −9.8 dB at an LO drive level of 15 dBm. The whole mixer is very broadband with 3 dB bandwidth from 7 to 12 GHz covering the entire X-band. The LO–IF, RF–IF, and RF–LO isolation is better than 46, 36, and 36 dB, respectively, in the entire band of operation.

[1]  Stephen A. Maas,et al.  Nonlinear Microwave and RF Circuits , 2003 .

[2]  Stephen A. Maas,et al.  Microwave Mixers , 1986 .

[4]  R. Michaelsen,et al.  Investigation of LO-leakage cancellation and DC-offset influence on flicker-noise in X-band mixers , 2012, 2012 7th European Microwave Integrated Circuit Conference.

[5]  J. A. Babcock,et al.  Comparative low frequency noise analysis of bipolar and MOS transistors using an advanced complementary BiCMOS technology , 2001, Proceedings of the IEEE 2001 Custom Integrated Circuits Conference (Cat. No.01CH37169).

[6]  Kian Sen Ang,et al.  Analysis and design of miniaturized lumped-distributed impedance-transforming baluns , 2003 .

[7]  Behzad Razavi,et al.  Design considerations for direct-conversion receivers , 1997 .

[8]  M.Y.W. Chia,et al.  A new planar marchand balun , 2005, IEEE MTT-S International Microwave Symposium Digest, 2005..

[9]  Olga Boric-Lubecke,et al.  0.18‐μm CMOS wideband passive mixer , 2013 .

[10]  Yeong-Her Wang,et al.  A Broadband Doubly Balanced Monolithic Ring Mixer with a Compact Intermediate Frequency (IF) Extraction , 2011 .

[11]  V. Krozer,et al.  Analysis and design of lumped element Marchand baluns , 2008, MIKON 2008 - 17th International Conference on Microwaves, Radar and Wireless Communications.

[12]  Hsien-Chin Chiu,et al.  A wide bandwidth V‐band balanced resistive mixer with a miniature meandering balun , 2013 .

[13]  Mohammad Yavari,et al.  A highly linear mixer with inherent balun using a new technique to remove common mode currents , 2011, 2011 IEEE International Symposium of Circuits and Systems (ISCAS).