Numerical investigation of perforation to cementing interface damage area

[1]  W. K. Godfrey.  Effect of Jet Perforating on Bond Strength of Cement , 1968 .

[2]  S. Kelkar,et al.  Perforation placement optimization: A modified hydraulic fracturing technique , 1984 .

[3]  L. A. Behrmann,et al.  An Investigation of the Damaged Zone Created by Perforating , 1991 .

[4]  N. Jones,et al.  A failure criterion for beams under impulsive loading , 1992 .

[5]  C. Yew,et al.  A Study of the Damage Zone Created by Shaped-Charge Perforating , 1993 .

[6]  Chun-Yu Chen,et al.  The Equation of State of Detonation Products obtained from cylinder expansion test , 1994 .

[7]  K. E. Krogh,et al.  Micro-Mechanical Modeling of Perforating Shock Damage , 1997 .

[8]  S. Rahman,et al.  Hydraulic fracture initiation and propagation: roles of wellbore trajectory, perforation and stress regimes , 2000 .

[9]  K. Matsuki,et al.  Damage of rock core due to tensile stresses during boring under in-situ stresses and its relation to DSCA , 2020, Frontiers of Rock Mechanics and Sustainable Development in the 21st Century.

[10]  Ali Ghalambor,et al.  Experimental and Simulation Analysis of Jet-Perforated Rock Damage , 2001 .

[11]  Howard H. Hu,et al.  Direct numerical simulations of fluid-solid systems using the arbitrary Langrangian-Eulerian technique , 2001 .

[12]  R. K. Luo,et al.  An approach to evaluate the impact damage initiation and propagation in composite plates , 2001 .

[13]  N. Banthia,et al.  Crack growth resistance of hybrid fiber reinforced cement composites , 2003 .

[14]  N. Vlahopoulos,et al.  Formulation of a numerical process for acoustic impedance sensitivity analysis based on the indirect boundary element method , 2003 .

[15]  T. Wierzbicki,et al.  Numerical study on crack propagation in high velocity perforation , 2005 .

[16]  BuYuhuan,et al.  Performance of Fiber Cement Slurry in the Oil and Gas Well Cementation , 2005 .

[17]  M. Jono.  Fatigue damage and crack growth under variable amplitude loading with reference to the counting methods of stress–strain ranges , 2005 .

[18]  N. Filipovic,et al.  An implicit algorithm within the arbitrary Lagrangian–Eulerian formulation for solving incompressible fluid flow with large boundary motions , 2006 .

[19]  Y. Liu,et al.  A meshless method for stress-wave propagation in anisotropic and cracked media , 2007 .

[20]  D. Umbrello,et al.  The influence of Johnson–Cook material constants on finite element simulation of machining of AISI 316L steel , 2007 .

[21]  Majidreza Nazem,et al.  Arbitrary Lagrangian–Eulerian method for large‐strain consolidation problems , 2008 .

[22]  H. Hao,et al.  Modelling of compressive behaviour of concrete-like materials at high strain rate , 2008 .

[23]  R. Karimi,et al.  Finite element analysis of deformation and fracture of an exploded gas cylinder , 2009 .

[24]  Majidreza Nazem,et al.  Arbitrary Lagrangian–Eulerian method for dynamic analysis of geotechnical problems , 2009 .

[25]  Xiong Zhang,et al.  Comparison study of MPM and SPH in modeling hypervelocity impact problems , 2009 .

[26]  Wei Zhu,et al.  Experiment Study on Size Effect of Concrete Compress Damage Parameters , 2010 .

[27]  Ali Osman Atahan,et al.  Vehicle crash test simulation of roadside hardware using LS-DYNA: a literature review , 2010 .

[28]  M. S. Asadi,et al.  A DEM Study on Perforation Induced Damaged Zones and Penetration Length in Sandstone Reservoirs , 2010 .

[29]  Todd P Slavik,et al.  A coupling of empirical explosive blast loads to ALE air domains in LS-DYNA® , 2010 .

[30]  Matteo Loizzo,et al.  Interface debonding as a controlling mechanism for loss of well integrity: Importance for CO2 injector wells , 2011 .

[31]  C. Soares,et al.  Numerical modelling of the boundary conditions on beams stuck transversely by a mass , 2011 .

[32]  P. Zhong,et al.  Effect of interface defects on shear strength and fluid channeling at cement–interlayer interface , 2012 .

[33]  A. Bunger,et al.  Interface debonding driven by fluid injection in a cased and cemented wellbore: Modeling and experiments , 2013 .

[34]  A. Zhang,et al.  Influences of initial and boundary conditions on underwater explosion bubble dynamics , 2013 .

[35]  Qingming Li,et al.  Influences of target strength and confinement on the penetration depth of an oil well perforator , 2013 .

[36]  C. Teodoriu,et al.  Low cycle cement fatigue experimental study and the effect on HPHT well integrity , 2013 .

[37]  H. Kamarudin,et al.  Study on the Properties of Oil Palm Trunk Fiber (OPTF) in Cement Composite , 2013 .

[38]  J. Sulem,et al.  Cement Sheath Integrity for CO2 Storage – An Integrated Perspective , 2013 .

[39]  Pradeep L. Menezes,et al.  Studies on the formation of discontinuous chips during rock cutting using an explicit finite element model , 2014 .

[40]  Jianwei Zhang,et al.  A cement interface enhancer and its action mechanism , 2015, Arabian Journal of Geosciences.

[41]  A. C. Soares,et al.  Experimental Perforating Test and Damage Zone Characterization , 2015 .

[42]  Torbjørn Vrålstad,et al.  Effect of Thermal Cycling on Cement Sheath Integrity: Realistic Experimental Tests and Simulation of Resulting Leakages , 2015 .

[43]  J. Olson,et al.  Mechanisms of Simultaneous Hydraulic-Fracture Propagation From Multiple Perforation Clusters in Horizontal Wells , 2016 .

[44]  J. Schmittbuhl,et al.  Quantification of microcrack characteristics and implications for stiffness and strength of granite , 2017 .

[45]  Guanshui Xu,et al.  The Effects of Perforation Erosion on Practical Hydraulic-Fracturing Applications , 2017 .

[46]  D. Potyondy.  Simulating Perforation Damage With a Flat-Jointed Bonded-Particle Material , 2017 .

[47]  A. Ichim,et al.  Investigations on the surface well cement integrity induced by thermal cycles considering an improved overall transfer coefficient , 2017 .

[48]  A. D. Taleghani,et al.  Impact of hydraulic fracturing on cement sheath integrity; A modelling approach , 2017 .

[49]  M. Erkayaoğlu,et al.  Investigation of the elastic material properties of Class G cement , 2017 .

[50]  Qingming Li,et al.  Influence of target strength on the penetration depth of shaped charge jets into RHA targets , 2018 .