Transient Analysis of Proton Electrolyte Membrane Fuel Cells (PEMFC) at Start‐Up and Failure

A two-dimensional, transient, single-phase computational model, incorporating water transport in the membrane and the flow and transport of species in porous gas diffusion electrodes is developed to evaluate the transient performance of a PEMFC with interdigitated gas distributors. The co-flow and counter-flow of the anode and cathode reactants are discussed to address their effects on PEMFC performance and transients. The important role of water transport in the membrane on the transients is demonstrated. The membrane’s water intake or outtake determines the duration of the transients. The effect of the operating conditions on steady state and transient performances is outlined. Overshoots and undershoots are observed in the average current density, due to a step change in the cell voltage and the cathode pressure under start-up conditions. Simulation results are used to address the role of auxiliary components in the failure modes of the PEMFC.

[1]  V. S. Vaidhyanathan,et al.  Transport phenomena , 2005, Experientia.

[2]  Lin Wang,et al.  Performance studies of PEM fuel cells with interdigitated flow fields , 2004 .

[3]  Chaoyang Wang,et al.  Two-Phase Modeling and Flooding Prediction of Polymer Electrolyte Fuel Cells , 2005 .

[4]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[5]  Hongtan Liu,et al.  Modelling of performance of PEM fuel cells with conventional and interdigitated flow fields , 1999 .

[6]  S. Rael,et al.  Mathematical model and characterization of the transient behavior of a PEM fuel cell , 2004, IEEE Transactions on Power Electronics.

[7]  Tatsuhiro Okada,et al.  Simulation for water management in membranes for polymer electrolyte fuel cells , 1998 .

[8]  Ioannis G. Kevrekidis,et al.  The dynamic response of PEM fuel cells to changes in load , 2005 .

[9]  Ned Djilali,et al.  CFD-based modelling of proton exchange membrane fuel cells , 2005 .

[10]  B. Wetton,et al.  Water Management in PEM Fuel Cells , 2004 .

[11]  T. Nguyen,et al.  Multicomponent transport in porous electrodes of proton exchange membrane fuel cells using the interdigitated gas distributors , 1999 .

[12]  Trung Van Nguyen,et al.  Diagnostic Tool to Detect Electrode Flooding in Proton-Exchange-Membrane Fuel Cells , 2003 .

[13]  T. Nguyen,et al.  Two-phase flow model of the cathode of PEM fuel cells using interdigitated flow fields , 2000 .

[14]  T. Fuller,et al.  Influence of rib spacing in proton-exchange membrane electrode assemblies , 1996 .

[15]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[16]  M. Verbrugge,et al.  Mathematical model of a gas diffusion electrode bonded to a polymer electrolyte , 1991 .

[17]  Anzhong Gu,et al.  Three dimensional, two phase flow mathematical model for PEM fuel cell: Part I. Model development , 2004 .

[18]  Trung Van Nguyen,et al.  A Gas Distributor Design for Proton‐Exchange‐Membrane Fuel Cells , 1996 .

[19]  John M. Stockie,et al.  A finite volume method for multicomponent gas transport in a porous fuel cell electrode , 2003 .

[20]  Sirivatch Shimpalee,et al.  The effect of reservoirs and fuel dilution on the dynamic behavior of a PEMFC , 2004 .

[21]  Mark W. Verbrugge,et al.  A Mathematical Model of the Solid‐Polymer‐Electrolyte Fuel Cell , 1992 .

[22]  Ralph E. White,et al.  A water and heat management model for proton-exchange-membrane fuel cells , 1993 .

[23]  Xianguo Li,et al.  Composition and performance modelling of catalyst layer in a proton exchange membrane fuel cell , 1999 .

[24]  Chao-Yang Wang,et al.  Transient analysis of polymer electrolyte fuel cells , 2005 .

[25]  Anzhong Gu,et al.  Three dimensional, two phase flow mathematical model for PEM fuel cell: Part II. Analysis and discussion of the internal transport mechanisms , 2004 .

[26]  S. Dutta,et al.  Numerical prediction of mass-exchange between cathode and anode channels in a PEM fuel cell , 2001 .