A strain-energy-based non-linear failure criterion: comparison of numerical predictions and experimental observations for symmetric composite laminates

A strain-energy-based model to predict non-linear stress/strain response, failure onset and progression in composite laminates was presented by Wolfe and Butalia (Compos. Sci. Technol. 1998, 58, 1107). This paper focuses on some of the critical issues relating to the development of that model. Several of the assumptions made in the model are relaxed or modified. A variety of unidirectional and symmetric laminates are studied. A comparison of numerical results obtained from the model and published experimental data (Supplied by Soden, Kaddour and Hinton (Compos. Sci. Technol., in press) is presented for four different material systems. The strain energy based failure theory predictions agree very well with many of the experimental observations for the material systems investigated in this study.

[1]  P. D. Soden,et al.  Experimental failure stresses for +55° filament wound glass fibre reinforced plastic tubes under biaxial loads , 1989 .

[2]  Nm Panhwar,et al.  Durability of Postbuckling Fibre Composite Panels under Shear , 1993 .

[3]  S. Al-Hassani,et al.  An Experimental Investigation into the Strength of Angle Ply GRP Tubes under High Rate of Loading , 1989 .

[4]  Tarunjit S. Butalia,et al.  A strain-energy based failure criterion for non-linear analysis of composite laminates subjected to biaxial loading , 1998 .

[5]  P. D. Soden,et al.  Influence of winding angle on the strength and deformation of filament-wound composite tubes subjected to uniaxial and biaxial loads , 1993 .

[6]  S. Swanson,et al.  In-Situ Compressive Strength of Carbon/Epoxy AS4/3501-6 Laminates , 1993 .

[7]  F. Touchard,et al.  Comparative in-plane shear behaviour of long-carbon-fibre composites with thermoset or thermoplastic matrix , 1994 .

[8]  Stephen R. Swanson,et al.  Response of Quasi-Isotropic Carbon/Epoxy Laminates to Biaxial Stress , 1986 .

[9]  P. D. Soden,et al.  Lamina properties, lay-up configurations and loading conditions for a range of fibre-reinforced composite laminates , 1998 .

[10]  Pierre Ladevèze,et al.  Damage modelling of the elementary ply for laminated composites , 1992 .

[11]  Stephen R. Swanson,et al.  Strength of quasi-isotropic laminates under off-axis loading , 1989 .

[12]  P. Soden,et al.  The effects of radial stresses on the strength of thin-walled filament wound GRP composite pressure cylinders , 1995 .

[13]  P. D. Soden,et al.  Failure of ±55 Degree Filament Wound Glass/Epoxy Composite Tubes under Biaxial Compression , 1998 .