Fabrication of mesoporous lignocellulose aerogels from wood via cyclic liquid nitrogen freezing–thawing in ionic liquid solution

Homogeneous mesoporous lignocellulose aerogels were prepared from hardwood using 1-allyl-3-methylimidazolium chloride (AMImCl) as an ionic liquid (IL) via cyclic liquid nitrogen freezing–thawing (NFT, from −196 °C to 20 °C) treatment processes. The obtained hydrogels after NFT treatment were solvent-exchanged by acetone, washed with liquid carbon dioxide and then dried by releasing the carbon dioxide at the critical temperature. It was observed that the obtained aerogels after five-cycles of NFT treatment had open-structured 3-dimensional (3D) fibril-like networks. The surface areas and pore size distributions could be adjusted by controlling the NFT treatment cycles. However, the samples treated by common freezing–thawing (FT, from −20 °C to 20 °C) displayed a film-like 2D structure and low surface area. This may be ascribed to the difference of the assembled ‘secondary units’ formed during the freezing process. For instance, in the NFT process, 3D-like ‘secondary assembly units’ were squeezed out by small IL crystals formed during the ultra low temperature freezing process. These ‘secondary assembly units’ were able to build a large 3D network through the connection and overlap effect with cyclic NFT processes. However, the assembled 2D-like ‘secondary assembly units’ were squeezed out by large IL crystals in the common FT process due to the slow freezing process and finally were developed to a film-like structure. These ‘secondary assembly units’ could be linked together in a slow thawing process to form compact aerogels. This study provides a new means to fabricate novel mesoporous lignocellulose aerogels, which is crucial to fully utilize abundant lignocellulose biomass. The homogeneous mesoporous aerogels can be used as highly insulating materials with low thermal conductivity and also have appealing performance in sound absorption and noise reduction properties.

[1]  T. Nakaoki,et al.  Coagulation size of freezable water in poly(vinyl alcohol) hydrogels formed by different freeze/thaw cycle periods , 2011 .

[2]  D. Zhao,et al.  Carbon Materials for Chemical Capacitive Energy Storage , 2011, Advanced materials.

[3]  Jian Li,et al.  Ultralight and highly flexible aerogels with long cellulose I nanofibers , 2011 .

[4]  I. Smirnova,et al.  Polysaccharide-based aerogels—Promising biodegradable carriers for drug delivery systems , 2011 .

[5]  P. Langan,et al.  Ionic-liquid induced changes in cellulose structure associated with enhanced biomass hydrolysis. , 2011, Biomacromolecules.

[6]  R. C. Picu.  Mechanics of random fiber networks—a review , 2011 .

[7]  Xun Hu,et al.  Levulinic esters from the acid-catalysed reactions of sugars and alcohols as part of a bio-refinery , 2011 .

[8]  Huijun Zhao,et al.  Lignocellulose aerogel from wood-ionic liquid solution (1-allyl-3-methylimidazolium chloride) under freezing and thawing conditions. , 2011, Biomacromolecules.

[9]  A. Corma,et al.  Converting carbohydrates to bulk chemicals and fine chemicals over heterogeneous catalysts , 2011 .

[10]  Robin H. A. Ras,et al.  Inorganic hollow nanotube aerogels by atomic layer deposition onto native nanocellulose templates. , 2011, ACS nano.

[11]  B. Simmons,et al.  Transition of cellulose crystalline structure and surface morphology of biomass as a function of ionic liquid pretreatment and its relation to enzymatic hydrolysis. , 2011, Biomacromolecules.

[12]  Akira Isogai,et al.  TEMPO-oxidized cellulose nanofibers. , 2011, Nanoscale.

[13]  N. Sun,et al.  Rapid dissolution of lignocellulosic biomass in ionic liquids using temperatures above the glass transition of lignin , 2011 .

[14]  G. Huber,et al.  Renewable Chemical Commodity Feedstocks from Integrated Catalytic Processing of Pyrolysis Oils , 2010, Science.

[15]  Mouming Zhao,et al.  Hydrogels prepared from pineapple peel cellulose using ionic liquid and their characterization and primary sodium salicylate release study , 2010 .

[16]  Michael E Himmel,et al.  Cellulose crystallinity index: measurement techniques and their impact on interpreting cellulase performance , 2010, Biotechnology for biofuels.

[17]  Antje Potthast,et al.  Aerogels from unaltered bacterial cellulose: application of scCO2 drying for the preparation of shaped, ultra-lightweight cellulosic aerogels. , 2010, Macromolecular bioscience.

[18]  M. Sierakowski,et al.  Nanostructural reorganization of bacterial cellulose by ultrasonic treatment. , 2010, Biomacromolecules.

[19]  Y. Y. Lee,et al.  Cellulose pretreatment in subcritical water: effect of temperature on molecular structure and enzymatic reactivity. , 2010, Bioresource Technology.

[20]  N. Vrana,et al.  Cell encapsulation within PVA‐based hydrogels via freeze‐thawing: a one‐step scaffold formation and cell storage technique , 2009, Journal of tissue engineering and regenerative medicine.

[21]  B. Mattiasson,et al.  Mechanism of Cryopolymerization: Diffusion-Controlled Polymerization in a Nonfrozen Microphase. An NMR Study , 2009 .

[22]  Robin D. Rogers,et al.  Complete dissolution and partial delignification of wood in the ionic liquid 1-ethyl-3-methylimidazolium acetate , 2009 .

[23]  A. Fatimi,et al.  An injectable cellulose‐based hydrogel for the transfer of autologous nasal chondrocytes in articular cartilage defects , 2009, Biotechnology and bioengineering.

[24]  M. Himmel,et al.  Visualizing lignin coalescence and migration through maize cell walls following thermochemical pretreatment , 2008, Biotechnology and bioengineering.

[25]  Olli Ikkala,et al.  Long and entangled native cellulose I nanofibers allow flexible aerogels and hierarchically porous templates for functionalities , 2008 .

[26]  L. Papadopoulou,et al.  Development of micro- and nano-porous composite materials by processing cellulose with ionic liquids and supercritical CO2 , 2008 .

[27]  S. Gaspard,et al.  Comparison of parameters calculated from the BET and Freundlich isotherms obtained by nitrogen adsorption on activated carbons: A new method for calculating the specific surface area , 2008 .

[28]  Lina Zhang,et al.  Cellulose aerogels from aqueous alkali hydroxide-urea solution. , 2008, ChemSusChem.

[29]  A. Sannino,et al.  Spin coating cellulose derivatives on quartz crystal microbalance plates to obtain hydrogel‐based fast sensors and actuators , 2007 .

[30]  Gunnar Henriksson,et al.  An environmentally friendly method for enzyme-assisted preparation of microfibrillated cellulose (MFC) nanofibers , 2007 .

[31]  Seung‐Hwan Lee,et al.  Physical and mechanical properties of polyvinyl alcohol and polypropylene composite materials reinforced with fibril aggregates isolated from regenerated cellulose fibers , 2007 .

[32]  K. E. Salmawi,et al.  Synthesis of crosslinked superabsorbent carboxymethyl cellulose/acrylamide hydrogels through electron-beam irradiation , 2007 .

[33]  O. Ikkala,et al.  Enzymatic hydrolysis combined with mechanical shearing and high-pressure homogenization for nanoscale cellulose fibrils and strong gels. , 2007, Biomacromolecules.

[34]  Arthur J. Ragauskas,et al.  Ionic Liquid as a Green Solvent for Lignin , 2007 .

[35]  P. Achard,et al.  Cellulose-based aerogels , 2006 .

[36]  Christopher W. Jones,et al.  Batch Aqueous-Phase Reforming of Woody Biomass , 2006 .

[37]  M. Wada,et al.  The thermal expansion of cellulose II and IIIII crystals , 2006 .

[38]  Charlotte K. Williams,et al.  The Path Forward for Biofuels and Biomaterials , 2006, Science.

[39]  Shenglian Guo,et al.  Mechanisms of lead biosorption on cellulose/chitin beads. , 2005, Water research.

[40]  Jun Zhang,et al.  1-Allyl-3-methylimidazolium chloride room temperature ionic liquid: A new and powerful nonderivatizing solvent for cellulose , 2005 .

[41]  C. Garvey,et al.  On the Interpretation of X‐Ray Diffraction Powder Patterns in Terms of the Nanostructure of Cellulose I Fibres , 2005 .

[42]  Thomas Heinze,et al.  Ionic liquids as reaction medium in cellulose functionalization. , 2005, Macromolecular bioscience.

[43]  Lina Zhang,et al.  Polymer fractionation using chromatographic column packed with novel regenerated cellulose beads modified with silane. , 2005, Journal of chromatography. A.

[44]  Thomas Geiger,et al.  Cellulose Fibrils for Polymer Reinforcement , 2004 .

[45]  Hao Jin,et al.  Nanofibrillar cellulose aerogels , 2004 .

[46]  J. Watanabe,et al.  Antifouling blood purification membrane composed of cellulose acetate and phospholipid polymer. , 2003, Biomaterials.

[47]  J. Sugiyama,et al.  Characterization of the supermolecular structure of cellulose in wood pulp fibres , 2003 .

[48]  B. Girgis,et al.  Characteristics of activated carbon from peanut hulls in relation to conditions of preparation , 2002 .

[49]  Robin D. Rogers,et al.  Dissolution of Cellose with Ionic Liquids , 2002 .

[50]  P. Langan,et al.  A REVISED STRUCTURE AND HYDROGEN-BONDING SYSTEM IN CELLULOSE II FROM A NEUTRON FIBER DIFFRACTION ANALYSIS , 1999 .

[51]  M. W. Daniels,et al.  Does the mechanism of symmetric methyl transfer to water from water differ from that for transfer to water from other leaving groups? [Erratum to document cited in CA110(7):57048r] , 1992 .

[52]  Lina Zhang,et al.  Superabsorbent hydrogels based on cellulose for smart swelling and controllable delivery , 2010 .

[53]  T. Budtova,et al.  Aerocellulose: new highly porous cellulose prepared from cellulose-NaOH aqueous solutions. , 2008, Biomacromolecules.

[54]  Yuhan Sun,et al.  Super hydrophobic mesoporous silica with anchored methyl groups on the surface by a one-step synthesis without surfactant template , 2007 .

[55]  Lynn A. Capadona,et al.  Chemical, Physical, and Mechanical Characterization of Isocyanate Cross-linked Amine-Modified Silica Aerogels , 2006 .

[56]  D. Fengel.  Ideas on the ultrastructural organization of the cell wall components , 1971 .

[57]  E. Barrett,et al.  (CONTRIBUTION FROM THE MULTIPLE FELLOWSHIP OF BAUGH AND SONS COMPANY, MELLOX INSTITUTE) The Determination of Pore Volume and Area Distributions in Porous Substances. I. Computations from Nitrogen Isotherms , 1951 .

[58]  S. S. Kistler,et al.  The Relation between Heat Conductivity and Structure in Silica Aerogel , 1934 .