The influence of cutting parameters on residual stresses and surface topography during hard turning of 18MnCr5 case carburised steel
暂无分享,去创建一个
Marcel Escursell | F. Gunnberg | M. Jacobson | Fredrik Gunnberg | Michael Jacobson | Marcel Escursell
[1] Peter Vomacka,et al. Residual Stresses due to Hard-Machining - Industrial Experiences , 2000 .
[2] Jeffrey D. Thiele,et al. Effect of cutting edge geometry and workpiece hardness on surface generation in the finish hard turning of AISI 52100 steel , 1999 .
[3] Patrik Dahlman,et al. Cutting speed influence on surface integrity of hard turned bainite steel , 2002 .
[4] Fukuo Hashimoto,et al. Surface Integrity Generated by Precision Hard Turning , 1999 .
[5] M. Jacobson,et al. Surface integrity of hard-turned M50 steel , 2002 .
[6] W. König,et al. Residual Stresses — Measurement and Causes in Machining Processes , 1982 .
[7] W. König,et al. Turning versus grinding: a comparison of surface integrity aspects and attainable accuracies , 1993 .
[8] S. Mittal,et al. Optimal pre-stressing the surface of a component by superfinish hard turning for maximum fatigue life in rolling contact , 1998 .
[9] Hans Kurt Tönshoff,et al. Cutting of Hardened Steel , 2000 .