论文信息 - Identification of vehicle parameters using stationary driving maneuvers

Identification of vehicle parameters using stationary driving maneuvers

Using the velocity dependent static gains of the one track model it is shown how special combinations of parameters like cornering stiffness and center of gravity can be estimated. Driving with various speed and a constant cornering radius it is possible to estimate three different gains by measurement of the lateral acceleration, the yaw rate and the vehicle slip angle without knowing the moment of inertia of the vehicle. Results are shown for different measurements of a passenger car.

Rolf Isermann | Daniel Wesemeier | R. Isermann | Daniel Wesemeier

[1] Lennart Ljung,et al. System Identification: Theory for the User , 1987 .

[2] Eric J. Rossetter,et al. Vehicle Sideslip and Roll Parameter Estimation using GPS , 2002 .

[3] R. Isermann,et al. Fault tolerant sensors for vehicle dynamics control , 2006, 2006 American Control Conference.

[4] Charara Ali,et al. Evaluation of sliding mode observer for vehicle sideslip angle , 2005 .

[5] Rolf Isermann,et al. Controller design for an active steering system in passenger cars based on local linear models , 2004 .

[6] Rolf Isermann,et al. Fault detection for lateral and vertical vehicle dynamics , 2004 .

[7] Rolf Isermann,et al. Model-based detection of critical driving situations with fuzzy logic decision making , 2006 .

[8] R. Isermann. Estimation of physical parameters for dynamic processes with application to an industrial robot , 1992 .

[9] Masayoshi Tomizuka,et al. A complete fault diagnostic system for automated vehicles operating in a platoon , 2001, IEEE Trans. Control. Syst. Technol..

[10] Uwe Kiencke,et al. Automotive Control Systems , 2005 .

[11] Rolf Isermann,et al. Fault-Diagnosis Systems , 2005 .