Phase-field microstructure-based effective thermal conductivity calculations in tungsten

Using a phase-field approach with the heat conduction equation, we predict the grain growth behaviors in tungsten (W) and their effects on effective thermal conductivity. Results show that the simulated grain growth kinetics is basically consistent with experimental observations. An empirical correlation is derived, describing the averaged grain area as a function of temperature and time. Further, we study the effect of grain growth, columnar crystal structure, and recrystallization on the effective thermal conductivity of W. It is found that the effective thermal conductivity increases nonlinearly with increasing grain size, and a simple correlation of converting two-dimension into three-dimension effective thermal conductivity is obtained. Interestingly, the effective thermal conductivity of the columnar crystal is relatively high along the elongated direction and higher than that of the isometric crystal. Nevertheless, the effective thermal conductivity decreases with the occurrence of the recrystallization due to the increased grain boundary density. Our results reveal that grain growth and grain structure can affect the capacity of heat transfer at high temperatures, which could be considered in the transient event of the long-time service of W materials in fusion devices.

[1]  Yuanyuan Zhu,et al.  Suppressing irradiation induced grain growth and defect accumulation in nanocrystalline tungsten through grain boundary doping , 2021 .

[2]  Jijun Zhao,et al.  Numerical simulations of thermal conductivity in void-containing tungsten: Topological feature of voids , 2021 .

[3]  Yichao Zhu,et al.  Achieving fine-grain tungsten heavy alloys by selecting a high entropy alloy matrix with low W grain growth rate , 2020 .

[4]  Q. Fang,et al.  Interaction of radiation-induced defects with tungsten grain boundaries at across scales: a short review , 2020, Tungsten.

[5]  G. Kermouche,et al.  A high power laser facility to conduct annealing tests at high temperature. , 2020, The Review of scientific instruments.

[6]  Jijun Zhao,et al.  Understanding the thermal conductivity of pristine W and W–Re alloys from a physics-based model , 2020 .

[7]  Hongbing Yu,et al.  Thermal diffusivity degradation and point defect density in self-ion implanted tungsten , 2019, Acta Materialia.

[8]  T. Toyama,et al.  Defect characterization, mechanical and thermal property evaluation in CVD-W after low-dose neutron irradiation , 2019 .

[9]  W. Pantleon,et al.  Stagnant recrystallization in warm-rolled tungsten in the temperature range from 1150 °C to 1300 °C , 2019, Fusion Engineering and Design.

[10]  W. Pantleon,et al.  Recovery and recrystallization kinetics of differently rolled, thin tungsten plates in the temperature range from 1325 °C to 1400 °C , 2019, Nuclear Materials and Energy.

[11]  Y. Katoh,et al.  Transmutation-induced precipitation in tungsten irradiated with a mixed energy neutron spectrum , 2019, Acta Materialia.

[12]  L. Liang,et al.  Fission gas bubbles and recrystallization-induced degradation of the effective thermal conductivity in U-7Mo fuels , 2018, Journal of Nuclear Materials.

[13]  H. Greuner,et al.  European divertor target concepts for DEMO: Design rationales and high heat flux performance , 2018, Nuclear Materials and Energy.

[14]  J. V. Dommelen,et al.  Modelling recrystallization and grain growth of tungsten induced by neutron displacement defects , 2018, Mechanics of Materials.

[15]  G. Lu,et al.  Retarded recrystallization of helium-exposed tungsten , 2018, Nuclear Fusion.

[16]  V. Tomar,et al.  A phase field modeling based study of microstructure evolution and its influence on thermal conductivity in polycrystalline tungsten under irradiation , 2018, Computational Materials Science.

[17]  A. Hasegawa,et al.  Thermal properties of pure tungsten and its alloys for fusion applications , 2018, Fusion Engineering and Design.

[18]  Yunzhi Wang,et al.  Three-dimensional phase field simulation of intragranular void formation and thermal conductivity in irradiated α-Fe , 2018, Journal of Materials Science.

[19]  W. Pantleon,et al.  Isothermal annealing of thin rolled tungsten plates in the temperature range from 1300 °C to 1400 °C , 2018 .

[20]  Huai Li,et al.  Discussion of a combined solar thermal and ground source heat pump system operation strategy for office heating , 2018 .

[21]  Zhu Xiaoyong,et al.  Hardness loss and microstructure evolution of 90% hot-rolled pure tungsten at 1200–1350 °C , 2017 .

[22]  L. Liang,et al.  Fission-induced recrystallization effect on intergranular bubble-driven swelling in U-Mo fuel , 2017 .

[23]  K. Verbeken,et al.  Evolution of plastic deformation in heavily deformed and recrystallized tungsten of ITER specification studied by TEM , 2017 .

[24]  M. Merola,et al.  Self-castellation of tungsten monoblock under high heat flux loading and impact of material properties , 2017 .

[25]  G. Matthews,et al.  Physics conclusions in support of ITER W divertor monoblock shaping , 2017 .

[26]  W. Pantleon,et al.  Effects of thickness reduction on recrystallization process of warm-rolled pure tungsten plates at 1350 °C , 2017 .

[27]  K. Barmak,et al.  Atomistic simulations of grain boundary energies in tungsten , 2017 .

[28]  M. Merola,et al.  Use of Tungsten Material for the ITER Divertor , 2016 .

[29]  B. Wirth,et al.  Irradiation hardening of pure tungsten exposed to neutron irradiation , 2016 .

[30]  M. Anitescu,et al.  Mesoscale model for fission-induced recrystallization in U-7Mo alloy , 2016 .

[31]  Long-Qing Chen,et al.  Tunable thermal conductivity via domain structure engineering in ferroelectric thin films: A phase-field simulation , 2016 .

[32]  J. Knaster,et al.  Materials research for fusion , 2016, Nature Physics.

[33]  M. Anitescu,et al.  Grain growth in U-7Mo alloy: A combined first-principles and phase field study , 2016 .

[34]  J. Hales,et al.  Multiscale modeling of thermal conductivity of high burnup structures in UO2 fuels , 2016 .

[35]  W. Pantleon,et al.  Thermal stability of a highly-deformed warm-rolled tungsten plate in the temperature range 1100 °C to 1250 °C , 2015 .

[36]  X. Duan,et al.  Experimental and numerical simulations of ELM-like transient damage behaviors to different grade tungsten and tungsten alloys , 2015 .

[37]  Shenyang Hu,et al.  Assessment of effective thermal conductivity in U–Mo metallic fuels with distributed gas bubbles , 2015 .

[38]  S. S. Harilal,et al.  Helium bubble formation in ultrafine and nanocrystalline tungsten under different extreme conditions , 2015 .

[39]  Teruya Tanaka,et al.  Microstructural development of tungsten and tungsten–rhenium alloys due to neutron irradiation in HFIR , 2014 .

[40]  Y. Qi,et al.  Development of CVD-W coatings on CuCrZr and graphite substrates with a PVD intermediate layer , 2014 .

[41]  Xiang Liu,et al.  The thermal properties of high purity and fully dense tungsten produced by chemical vapor deposition , 2014 .

[42]  Michael R. Tonks,et al.  Demonstrating the Temperature Gradient Impact on Grain Growth in UO2 Using the Phase Field Method , 2014 .

[43]  D. Raabe Recovery and Recrystallization: Phenomena, Physics, Models, Simulation , 2014 .

[44]  T. Płociński,et al.  TEM observations of radiation damage in tungsten irradiated by 20 MeV W ions , 2013 .

[45]  W. Liu,et al.  An energetic and kinetic perspective of the grain-boundary role in healing radiation damage in tungsten , 2013 .

[46]  J. E. Hilliard,et al.  Free Energy of a Nonuniform System. I. Interfacial Free Energy and Free Energy of a Nonuniform System. III. Nucleation in a Two‐Component Incompressible Fluid , 2013 .

[47]  Xiang Liu,et al.  Preparation and properties of CVD-W coated W/Cu FGM mock-ups , 2013 .

[48]  H. Greuner,et al.  Recrystallization and grain growth behavior of rolled tungsten under VDE-like short pulse high heat flux loads , 2013 .

[49]  Michael R. Tonks,et al.  Meso-scale modeling of the influence of intergranular gas bubbles on effective thermal conductivity , 2011 .

[50]  M. Gilbert,et al.  Neutron-induced transmutation effects in W and W-alloys in a fusion environment , 2011 .

[51]  D. Duffy,et al.  Fusion power: a challenge for materials science , 2010, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[52]  J. Ongena,et al.  Energy for Future Centuries: Prospects for Fusion Power as a Future Energy Source , 2010 .

[53]  S. Zinkle,et al.  Structural materials for fission & fusion energy , 2009 .

[54]  Marius Stan,et al.  Phase-field modeling of gas bubbles and thermal conductivity evolution in nuclear fuels , 2009 .

[55]  Gang Wang,et al.  Grain growth in AZ31 Mg alloy during recrystallization at different temperatures by phase field simulation , 2009 .

[56]  Paul C. Millett,et al.  Phase-field simulation of thermal conductivity in porous polycrystalline microstructures , 2008 .

[57]  Bart Blanpain,et al.  Quantitative analysis of grain boundary properties in a generalized phase field model for grain growth in anisotropic systems , 2008 .

[58]  E. Favvas,et al.  What is spinodal decomposition , 2008 .

[59]  Yibin Xu,et al.  Computation of Interfacial Thermal Resistance by Phonon Diffuse Mismatch Model , 2007 .

[60]  E. Wakai,et al.  Blister bursting and deuterium bursting release from tungsten exposed to high fluences of high flux and low energy deuterium plasma , 2007 .

[61]  J. Malzbender,et al.  Critical heat flux loading experiments on CVD-W coating in the TEXTOR tokamak , 2006 .

[62]  J. Rest,et al.  A model for the effect of the progression of irradiation-induced recrystallization from initiation to completion on swelling of UO2 and U-10Mo nuclear fuels , 2005 .

[63]  G. A. Cottrell,et al.  Sigma phase formation in irradiated tungsten, tantalum and molybdenum in a fusion power plant , 2004 .

[64]  R. Neu,et al.  Materials for plasma facing components of fusion reactors , 2004 .

[65]  J. Rest,et al.  A model for the influence of microstructure, precipitate pinning and fission gas behavior on irradiation-induced recrystallization of nuclear fuels☆ , 2004 .

[66]  Chert,et al.  Applications of semi-implicit Fourier-spectral method to phase field equations , 2004 .

[67]  T. Shikama,et al.  Temperature dependence of thermal conductivity in W and W–Re alloys from 300 to 1000 K , 2003 .

[68]  Long-Qing Chen Phase-Field Models for Microstructure Evolution , 2002 .

[69]  Long-Qing Chen,et al.  Computer simulation of 3-D grain growth using a phase-field model , 2002 .

[70]  G. Bai,et al.  Interfacial thermal resistance in nanocrystalline yttria-stabilized zirconia , 2002 .

[71]  K. Bakker,et al.  Using the finite element method to compute the influence of complex porosity and inclusion structures on the thermal and electrical conductivity , 1997 .

[72]  Long-Qing Chen,et al.  COMPUTER SIMULATION OF GRAIN GROWTH USING A CONTINUUM FIELD MODEL , 1997 .

[73]  H. Eleveld,et al.  Void growth and thermal desorption of deuterium from voids in tungsten , 1994 .

[74]  F. W. Wiffen,et al.  Irradiation induced precipitation in tungsten based, W-Re alloys , 1983 .

[75]  K. Ehrlich,et al.  Radiation-induced recrystallization, its cause and consequences in heavy-ion irradiated 20% cold-drawn steels of type 1.4970☆ , 1983 .

[76]  J. Cahn,et al.  A correction to the ground state of FCC binary ordered alloys with first and second neighbor pairwise interactions , 1973 .

[77]  H. Stepper Recrystallization of α particle irradiated tungsten , 1972 .

[78]  J. Stiegler,et al.  RECRYSTALLIZATION, GRAIN GROWTH, AND THE DUCTILE--BRITTLE TRANSITION IN TUNGSTEN SHEET. , 1967 .

[79]  J. E. Hilliard,et al.  Free Energy of a Nonuniform System. I. Interfacial Free Energy , 1958 .

[80]  J. E. Burke,et al.  RECRYSTALLIZATION AND GRAIN GROWTH , 1952 .