Design and Characterization of Backside Termination Structures for Thick Fully-Depleted MAPS

Fully Depleted Monolithic Active Pixel Sensors (FD-MAPS) represent an appealing alternative to hybrid detectors for radiation imaging applications. We have recently demonstrated the feasibility of FD-MAPS based on a commercial 110 nm CMOS technology, adapted using high-resistivity substrates and backside post-processing. A p/n junction diode, fabricated on the detector backside using low-temperature processing steps after the completion of the front-side Back End of Line (BEOL), is reverse-biased to achieve the full depletion of the substrate and thus fast charge collection by drift. Test diodes including termination structures with different numbers of floating guard rings and different pitches were fabricated together with other Process Control Monitor structures. In this paper, we present the design of the backside diodes, together with results from the electrical characterization of the test devices, aiming to improve understanding of the strengths and limitations of the proposed approach. Characterization results obtained on several wafers demonstrate the effectiveness of the termination rings in increasing the breakdown voltage of the backside diodes and in coping with the variability of the passivation layer characteristics. A breakdown voltage exceeding 400 V in the worst case was demonstrated in devices with 30 guard rings with 6 μm pitch, thus enabling the full depletion of high-resistivity substrates with a thickness larger than or equal to 300 μm. Additionally, we show the first direct comparison for this technology of measured pixel characteristics with 3D TCAD simulations, proving a good agreement in the extracted operating voltages.

[1]  Mike Tyndel,et al.  Monolithic active pixel sensors (MAPS) in a VLSI CMOS technology , 2003 .

[2]  G. Verzellesi,et al.  On the accuracy of generation lifetime measurement in high-resistivity silicon using PN gated diodes , 1999 .

[3]  Norbert Wermes,et al.  Pixel detectors ... where do we stand? , 2018, Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment.

[4]  Magnus Mager,et al.  A process modification for CMOS monolithic active pixel sensors for enhanced depletion, timing performance and radiation tolerance , 2017 .

[5]  Robert Klanner,et al.  Investigation of X-ray induced radiation damage at the Si-SiO2 interface of silicon sensors for the European XFEL , 2012, 1210.0427.

[6]  Stefan Lauxtermann.  A Fully Depleted Backside Illuminated CMOS Imager with VGA Resolution and 15 micron Pixel Pitch , 2013 .

[7]  G. Bolla,et al.  Guard Ring Simulations for n-on-p Silicon Particle Detectors , 2010, IEEE Transactions on Nuclear Science.

[8]  Natalie Levkovich,et al.  Where do we stand? , 2016, Families, systems & health : the journal of collaborative family healthcare.

[9]  Andrew D. Holland,et al.  Fully Depleted, Monolithic Pinned Photodiode CMOS Image Sensor Using Reverse Substrate Bias , 2017 .

[10]  A. G. Chynoweth,et al.  Ionization Rates for Electrons and Holes in Silicon , 1958 .

[11]  B. S. Avset,et al.  The effect of metal field plates on multiguard structures with floating p+ guard rings , 1996 .

[12]  W. Snoeys,et al.  PIN detector arrays and integrated readout circuitry on high-resistivity float-zone silicon , 1994 .

[13]  Magnus Mager,et al.  ALPIDE, the Monolithic Active Pixel Sensor for the ALICE ITS upgrade , 2016 .

[14]  N. Bacchetta,et al.  Study of breakdown effects in silicon multi-guard structures , 1997 .

[15]  Jing Chen,et al.  SoI Monolithic Active Pixel Sensors for Radiation Detection Applications: A Review , 2015, IEEE Sensors Journal.

[16]  M. Caccia,et al.  Fully Depleted MAPS in 110-nm CMOS Process With 100–300-μm Active Substrate , 2020, IEEE Transactions on Electron Devices.

[17]  Walter Snoeys,et al.  Monolithic CMOS sensors for high energy physics , 2019, Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment.

[18]  N. Demaria,et al.  A 110 nm CMOS process for fully-depleted pixel sensors , 2019, Journal of Instrumentation.

[19]  B. Willmore,et al.  CMOS Monolithic Active Pixel Sensors (MAPS): New ‘eyes’ for science , 2006 .

[20]  Fabrice Guilloux,et al.  Development of a Depleted Monolithic CMOS Sensor in a 150 nm CMOS Technology for the ATLAS Inner Tracker Upgrade , 2016, 1711.01233.

[22]  K. Hara,et al.  Characteristics of non-irradiated and irradiated double SOI integration type pixel sensor , 2015, 1507.05382.

[23]  G. Verzellesi,et al.  Extraction of bulk generation lifetime and surface generation velocity in high-resistivity silicon by means of gated diodes , 2002 .

[24]  Ivan Peric,et al.  A novel monolithic pixelated particle detector implemented in high-voltage CMOS technology ☆ , 2007 .

[25]  R. V. Overstraeten,et al.  Measurement of the ionization rates in diffused silicon p-n junctions , 1970 .