Predictive depth of jet penetration models for abrasive waterjet cutting of alumina ceramics

Abstract A study of the depth of jet penetration (or depth of cut) in abrasive waterjet (AWJ) cutting of alumina ceramics with controlled nozzle oscillation is presented and discussed. An experimental investigation is carried out first to study the effects of nozzle oscillation at small angles on the depth of cut under different combinations of process parameters. Based on the test conditions, it is found that nozzle oscillation at small angles can improve the depth of cut by as much as 82% if the cutting parameters are correctly selected. Depending on the other cutting parameters in this study, it is found that a high oscillation frequency (10–14 Hz) with a low oscillation angle (4–6°) can maximize the depth of cut. Using a dimensional analysis technique, predictive models for jet penetration when cutting alumina ceramics with and without nozzle oscillation are finally developed and verified. It is found that the model predictions are in good agreement with the experimental results with the average percentage errors of less than 2.5%.

[1]  Syed H. Masood,et al.  Modelling of a continuous food pressing process by dimensional analysis , 2002 .

[2]  Iain Finnie,et al.  On the velocity dependence of the erosion of ductile metals by solid particles at low angles of incidence , 1978 .

[3]  Jun Wang,et al.  Abrasive Waterjet Machining of Polymer Matrix Composites – Cutting Performance, Erosive Process and Predictive Models , 1999 .

[4]  C. A. van Luttervelt,et al.  Analytical and experimental modelling of the abrasive water jet cutting of ductile materials , 1998 .

[5]  Thomas J. Kim,et al.  An erosion model for abrasive waterjet milling of polycrystalline ceramics , 1996 .

[6]  E. Siores,et al.  Optimising the AWJ cutting process of ductile materials using nozzle oscillation technique , 2002 .

[7]  Jun Wang,et al.  Abrasive Waterjet Machining of Engineering Materials , 2003 .

[8]  M. Hashish.  A Modeling Study of Metal Cutting With Abrasive Waterjets , 1984 .

[9]  Jun Wang,et al.  A Predictive Depth of Penetration Model for Abrasive Waterjet Cutting of Polymer Matrix Composites , 2002 .

[10]  E. de St Q. Isaacson,et al.  Dimensional methods in engineering and physics : reference sets and the possibilities of their extension , 1975 .

[11]  J. Bitter,et al.  A study of erosion phenomena , 1963 .

[12]  Thomas J. Kim,et al.  Development of an Abrasive Waterjet Kerf Cutting Model for Brittle Materials , 1992 .

[13]  T. Kuriyagawa,et al.  An Experimental Study to Enhance the Cutting Performance in Abrasive Waterjet Machining , 2003 .

[14]  J. Bitter.  A study of erosion phenomena part I , 1963 .

[15]  Radovan Kovacevic,et al.  Effects of water-mixture film on impact contact in abrasive waterjet machining , 1997 .

[16]  R. Roy.  A Primer on the Taguchi Method , 1990 .

[17]  Radovan Kovacevic,et al.  State of the Art of Research and Development in Abrasive Waterjet Machining , 1997 .