Flow boiling heat transfer performance of copper-alumina micro-nanostructured surfaces developed by forced convection electrodeposition technique

[1]  S. Sivapirakasam,et al.  An experimental investigation on pool boiling heat transfer enhancement using sol-gel derived nano-CuO porous coating , 2019, Experimental Thermal and Fluid Science.

[2]  R. Misra,et al.  Experimental study of pool boiling heat transfer on copper surfaces with Cu-Al2O3 nanocomposite coatings , 2018, International Communications in Heat and Mass Transfer.

[3]  Sanjay Kumar Gupta,et al.  An experimental investigation on pool boiling heat transfer enhancement using Cu-Al2O3 nano-composite coating , 2018, Experimental Heat Transfer.

[4]  K. Terrani,et al.  Potential impact of accident tolerant fuel cladding critical heat flux characteristics on the high temperature phase of reactivity initiated accidents , 2017 .

[5]  H. Saffari,et al.  Effect of electrolyte temperature on porous electrodeposited copper for pool boiling enhancement , 2017 .

[6]  G. Mayer,et al.  An experimental study on critical heat flux in vertical annulus under low flow and low pressure conditions , 2016 .

[7]  S. Suresh,et al.  Pool boiling heat transfer enhancement using vertically aligned carbon nanotube coatings on a copper substrate , 2016 .

[8]  Sudev Das,et al.  Experimental study of nucleate pool boiling heat transfer of water on silicon oxide nanoparticle coated copper heating surface , 2016 .

[9]  M. Kim,et al.  Boiling on spatially controlled heterogeneous surfaces: Wettability patterns on microstructures , 2015 .

[10]  Kai Chen,et al.  Pool boiling heat transfer enhancement with copper nanowire arrays , 2015 .

[11]  S. Kandlikar,et al.  Development of a two-step electrodeposition process for enhancing pool boiling , 2014 .

[12]  Tong Liu,et al.  A critical heat flux experiment with water flow at low pressures in thin rectangular channels , 2014 .

[13]  M. McCarthy,et al.  Role of wickability on the critical heat flux of structured superhydrophilic surfaces. , 2014, Langmuir : the ACS journal of surfaces and colloids.

[14]  Ji Min Kim,et al.  Enhanced heat transfer is dependent on thickness of graphene films: the heat dissipation during boiling , 2014, Scientific Reports.

[15]  H. Cho,et al.  Stable and uniform heat dissipation by nucleate-catalytic nanowires for boiling heat transfer , 2014 .

[16]  A. Koşar,et al.  Boiling heat transfer enhancement in mini/microtubes via polyhydroxyethylmethacrylate (pHEMA) coatings on inner microtube walls at high mass fluxes , 2013 .

[17]  Biao Tang,et al.  Enhanced flow boiling in parallel microchannels with metallic porous coating , 2013 .

[18]  M. Rubner,et al.  Separate effects of surface roughness, wettability, and porosity on the boiling critical heat flux , 2013 .

[19]  Chien-Yuh Yang,et al.  Effect of coating layer thickness for boiling heat transfer on micro porous coated surface in confined and unconfined spaces , 2013 .

[20]  J. Khan,et al.  Effect of Cu–Al2O3 nanocomposite coating on flow boiling performance of a microchannel , 2013 .

[21]  Meng Lin,et al.  Photographic study of bubble behavior in subcooled flow boiling using R-134a at low pressure range , 2012 .

[22]  Dougal A. Jerram,et al.  jPOR: An ImageJ macro to quantify total optical porosity from blue-stained thin sections , 2011, Comput. Geosci..

[23]  M. El-Genk,et al.  Enhanced nucleate boiling on copper micro-porous surfaces , 2010 .

[24]  H. Qiu,et al.  Do surfaces with mixed hydrophilic and hydrophobic areas enhance pool boiling , 2010, 1008.2208.

[25]  P. Marty,et al.  Surface wettability control by nanocoating: The effects on pool boiling heat transfer and nucleation mechanism , 2009 .

[26]  Y. Nam,et al.  Bubble nucleation on hydrophobic islands provides evidence to anomalously high contact angles of nanobubbles , 2008 .

[27]  M. Toprak,et al.  Nature‐Inspired Boiling Enhancement by Novel Nanostructured Macroporous Surfaces , 2008 .

[28]  Soon-Heung Chang,et al.  Subcooled flow boiling CHF enhancement with porous surface coatings , 2007 .

[29]  Se-Young Chun,et al.  Effect of pressure on critical heat flux in uniformly heated vertical annulus under low flow conditions , 2001 .

[30]  S. M. You,et al.  Enhancing Small-Channel Convective Boiling Performance Using a Microporous Surface Coating , 1998, Heat Transfer: Volume 3 — Application of Heat Transfer in Equipment, Systems, and Education.

[31]  F. Cheung,et al.  A hydrodynamic critical heat flux model for saturated pool boiling on a downward facing curved heating surface , 1997 .

[32]  Sang Jun Ha,et al.  A dry-spot model of critical heat flux in pool and forced convection boiling , 1998 .

[33]  Robert J. Moffat,et al.  Describing the Uncertainties in Experimental Results , 1988 .