Model for Early-Age Rate of Evaporation of Cement-Based Materials

AbstractEarly-age cracking affects the structural integrity of concrete structures and, if not inhibited, would lead to a reduction in service life. Plastic cracks are observed in the first few hours after placing the concrete, a time period well within the initial stages when the drying process is controlled by the rate of evaporation of concrete surfaces, which is roughly constant and similar to the rate of evaporation from water surfaces. In the absence of a theoretical method, this rate is commonly estimated using a nomograph based on Dalton’s law. In this paper, a fluid mechanics–based approach for water evaporation based on the boundary-layer theory, mass transfer, diffusion, and convection is described. A parametric study is conducted on the effect of boundary-layer temperature, wind speed, relative humidity, and evaporation characteristic length on the calculated evaporation rates. Predicted evaporation rates are verified by recent experiments. Results show that given appropriate environmental par...

[1]  T. A. Hammer.  Effect of silica fume on the plastic shrinkage and pore water pressure of high-strength concretes , 2001 .

[2]  S. Friedlander,et al.  Smoke, Dust and Haze: Fundamentals of Aerosol Behavior , 1977 .

[3]  W. D. Hoff,et al.  Water Transport in Brick, Stone and Concrete , 2002 .

[4]  J. Sanjayan,et al.  Mechanism of early age shrinkage of concretes , 2009 .

[5]  Peter F. Dux,et al.  Cracking of plastic concrete , 2003 .

[6]  Volker Slowik,et al.  Experimental investigation into early age shrinkage of cement paste by using fibre Bragg gratings , 2004 .

[7]  Hiroyuki Ozoe,et al.  A Correlation for Laminar Free Convection From a Vertical Plate , 1973 .

[8]  K. Maekawa,et al.  Drying induced moisture losses from mortar to the environment. Part I: experimental research , 2007 .

[9]  Markus Schmidt,et al.  Capillary pressure in fresh cement-based materials and identification of the air entry value , 2008 .

[10]  Jan Olek,et al.  Mechanism of plastic shrinkage cracking in portland cement and portland cement-silica fume paste and mortar , 1990 .

[11]  Gordon Nonhebel,et al.  Drying of solids in the chemical industry , 1971 .

[12]  David S. Kosson,et al.  Modeling Moisture Transport from a Portland Cement-Based Material During Storage in Reactive and Inert Atmospheres , 2003 .

[13]  A. Aguado,et al.  Influence of shrinkage-reducing admixtures on the reduction of plastic shrinkage cracking in concrete , 2009 .

[14]  J. Lienhard.  A heat transfer textbook , 1981 .

[15]  Y. Jaluria,et al.  An Introduction to Heat Transfer , 1950 .

[16]  Barzin Mobasher,et al.  Moisture loss characteristics of cement-based materials under early-age drying and shrinkage conditions , 2012 .

[17]  C A Menzel.  A tribute to "Causes and Prevention of Crack Development in Plastic Concrete" , 2008 .

[18]  R. Reid,et al.  The Properties of Gases and Liquids , 1977 .

[19]  S. Yi,et al.  Comparison of dry deposition predicted from models and measured with a water surface sampler , 1997 .

[20]  R. E. Bolz,et al.  CRC Handbook of tables for Applied Engineering Science , 1970 .

[21]  Louis J. Thibodeaux,et al.  Chemodynamics, environmental movement of chemicals in air, water, and soil , 1979 .

[22]  Rui Faria,et al.  Drying induced moisture losses from mortar to the environment. Part II: numerical implementation , 2007 .

[23]  Adrian Radocea.  A Study on the Mechanism of Plastic Shrinkage of Cement-Based Materials , 1992 .

[24]  B. Mobasher,et al.  Experimental observations of early-age drying of Portland cement paste under low-pressure conditions , 2011 .

[25]  Satoko Tanaka,et al.  Evaporation rate of water in a vessel , 1993 .

[26]  Kenneth C. Hover,et al.  Evaporation of Water from Concrete Surfaces , 2006 .

[27]  Paul J. Uno,et al.  PLASTIC SHRINKAGE CRACKING AND EVAPORATION FORMULAS , 1998 .

[28]  M. Fukuda,et al.  EXPERIMENTAL AND THEORETICAL STUDY OF EVAPORATION OF WATER IN A VESSEL , 1995 .

[29]  Kenneth C. Hover,et al.  Rapid evaporation from freshly cast concrete and the Gulf environment , 2001 .

[30]  Pietro Lura,et al.  Influence of Shrinkage-Reducing Admixtures on Development of Plastic Shrinkage Cracks , 2007 .

[31]  Peter F. Dux,et al.  Tensile Properties of Early-Age Concrete , 2009 .

[32]  Theodore W. Bremner,et al.  Drying of saturated lightweight concrete: an experimental investigation , 1996 .

[33]  P. R. Wiederhold.  Water Vapor Measurement: Methods and Instrumentation , 1997 .

[34]  F. H. Wittmann,et al.  On the action of capillary pressure in fresh concrete , 1976 .

[35]  R. Stull.  An Introduction to Boundary Layer Meteorology , 1988 .

[36]  Oskar Esping,et al.  Effect of limestone filler BET(H2O)-area on the fresh and hardened properties of self-compacting concrete , 2008 .

[37]  Antoine E. Naaman,et al.  Unrestrained early age shrinkage of concrete with polypropylene, PVA, and carbon fibers , 2007 .