Efficiency considerations for the use of blended biofuel in diesel engines

Biodiesel continues to be an alternative fuel of interest for use in diesel engines. Although biodiesel’s properties are similar to petroleum diesel’s, certain differences create possibilities for parameters, such as efficiency, to be different. The objective of the study is to identify the parameters that influence gross indicated fuel conversion efficiency and how they are affected by the use of biodiesel relative to petroleum diesel, in a production-ready diesel engine. This study of nine operating conditions observes mostly insignificant differences in efficiency among the three fuels. This seems to result from a tradeoff between biodiesel’s inherently shorter combustion durations, which phases combustion better for higher efficiency, and its inherently lower air–fuel ratios, which causes a relatively lower ratio of specific heats resulting in lower efficiency. Both features seem to be linked to the fuel-bound oxygen of biodiesel. Because of the changing fractions of premixed and diffusion combustion and turbocharger performance at different engine speeds and loads, the influences of the two competing factors vary with operating condition. Significant differences in efficiency are mostly manifested by system response issues, where the engine controller alters due to a response of an interpreted higher load with the use of the lower energy-density biodiesel.

[1]  Mahabubul Alam,et al.  Fuel Formulation Effects on Diesel Fuel Injection, Combustion, Emissions and Emission Control , 2003 .

[2]  José Antonio Velásquez,et al.  Heat release and engine performance effects of soybean oil ethyl ester blending into diesel fuel , 2011 .

[3]  A. Demirbas,et al.  Importance of biodiesel as transportation fuel , 2007 .

[4]  Hua Zhao,et al.  Effects of EGR on heat release in diesel combustion , 1998 .

[5]  D. E. Beasley,et al.  Theory and design for mechanical measurements , 1991 .

[6]  Jon H. Van Gerpen,et al.  Fuel Properties and Engine Performance for Biodiesel Prepared from Modified Feedstocks , 1997 .

[7]  Michael F. J. Brunt,et al.  Calculation of Heat Release in Direct Injection Diesel Engines , 1999 .

[8]  Ramkrishna Sen,et al.  Fuel properties, engine performance and environmental benefits of biodiesel produced by a green process , 2013 .

[9]  Timothy J. Jacobs,et al.  Biodiesel Imposed System Responses in a Medium-Duty Diesel Engine , 2010 .

[10]  J. H. Van Gerpen,et al.  COMPARISON OF ENGINE PERFORMANCE AND EMISSIONS FOR PETROLEUM DIESEL FUEL, YELLOW GREASE BIODIESEL, AND SOYBEAN OIL BIODIESEL , 2003 .

[11]  A. Tsolakis,et al.  Engine performance and emissions of a diesel engine operating on diesel-RME (rapeseed methyl ester) blends with EGR (exhaust gas recirculation) , 2007 .

[12]  Ayhan Demirbas,et al.  Progress and recent trends in biofuels , 2007 .

[13]  Murray H. Edson.  The Influence of Compression Ratio and Dissociation on Ideal Otto Cycle Engine Thermal Efficiency , 1962 .

[14]  Timothy J. Jacobs,et al.  Performance Parameter Analysis of a Biodiesel-Fuelled Medium Duty Diesel Engine , 2009 .

[15]  J. V. Gerpen,et al.  The effect of biodiesel oxidation on engine performance and emissions , 2001 .

[16]  D. Faedo,et al.  Effects of 30% v/v biodiesel/diesel fuel blend on regulated and unregulated pollutant emissions from diesel engines , 2011 .

[17]  Robert L. McCormick,et al.  Combustion of fat and vegetable oil derived fuels in diesel engines , 1998 .

[18]  Octavio Armas,et al.  Effect of biodiesel fuels on diesel engine emissions , 2008 .

[19]  Jerald A. Caton,et al.  A thermodynamic analysis of the use of exhaust gas recirculation in spark ignition engines including the second law of thermodynamics , 2009 .

[20]  Donald L. Stivender,et al.  Development of a Fuel-Based Mass Emission Measurement Procedure , 1971 .

[21]  T. K. Gogoi,et al.  A cycle simulation model for predicting the performance of a diesel engine fuelled by diesel and biodiesel blends , 2010 .

[22]  Gerhard Knothe,et al.  Biodiesel and renewable diesel: A comparison , 2010 .

[23]  Takeshi Kunitomo,et al.  Prediction of Radiative Heat Flux in a Diesel Engine , 1975 .

[24]  Timothy J. Jacobs,et al.  The Impact of Biodiesel on Injection Timing and Pulsewidth in a Common-Rail Medium-Duty Diesel Engine , 2009 .

[25]  D. Vasudevan,et al.  Performance, emission and combustion characteristics of a variable compression ratio engine using methyl esters of waste cooking oil and diesel blends , 2011 .

[26]  David R. Lancaster,et al.  MEASUREMENT AND ANALYSIS OF ENGINE PRESSURE DATA , 1975 .

[27]  Murray H. Edson,et al.  The Limits of Engine Performance — Comparison of Actual and Theoretical Cycles , 1963 .

[28]  G. Hohenberg.  Advanced Approaches for Heat Transfer Calculations , 1979 .

[29]  A. S. Cheng,et al.  Investigation of the impact of biodiesel fuelling on NO x emissions using an optical direct injection diesel engine , 2006 .

[30]  Timothy J. Jacobs,et al.  Interesting Behavior of Biodiesel Ignition Delay and Combustion Duration , 2010 .

[31]  F. M. Strange.  An Analysis of the Ideal Otto Cycle, Including the Effects of Heat Transfer, Finite Combustion Rates, Chemical Dissociation, and Mechanical Losses , 1963 .

[32]  Eric W. Lemmon.  NIST Standard Reference Database 72: NIST Thermophysical Properties of Air and Air Component Mixtures, Version 1.0 , 1997 .

[33]  Dennis L. Siebers,et al.  Effects of Oxygenates on Soot Processes in DI Diesel Engines: Experiments and Numerical Simulations , 2003 .

[34]  Timothy J. Jacobs,et al.  Biodiesel Effects on Influencing Parameters of Brake Fuel Conversion Efficiency in a Medium Duty Diesel Engine , 2010 .

[35]  David E. Foster,et al.  An Overview of Zero-Dimensional Thermodynamic Models for IC Engine Data Analysis , 1985 .

[36]  Avinash Kumar Agarwal,et al.  Biofuels (alcohols and biodiesel) applications as fuels for internal combustion engines , 2007 .

[37]  M. Canakci,et al.  Combustion characteristics of a turbocharged DI compression ignition engine fueled with petroleum diesel fuels and biodiesel. , 2007, Bioresource technology.

[38]  Juhun Song,et al.  Combustion and emissions performance of low sulfur, ultra low sulfur and biodiesel blends in a DI diesel engine , 2004 .

[39]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[40]  N. V. Deshpande,et al.  Effect of Injection Timing Retard on Emissions and Performance of a Pongamia Oil Methyl Ester Fuelled CI Engine , 2005 .

[41]  Dennis N. Assanis,et al.  Instructional Use of a Single-Zone, Premixed Charge, Spark-Ignition Engine Heat Release Simulation , 2007 .

[42]  Naeim A. Henein,et al.  Effect of Biodiesel (B-20) on Performance and Emissions in a Single Cylinder HSDI Diesel Engine , 2008 .

[43]  Rolf D. Reitz,et al.  Multidimensional modeling of the effects of radiation and soot deposition in heavy-duty diesel engines , 2003 .

[44]  John B. Heywood,et al.  Future fuel cell and internal combustion engine automobile technologies: A 25-year life cycle and fleet impact assessment , 2006 .