Energy storage systems for high power applications

Energy storage systems provide viable solutions for better efficiency, improved power quality and reliability issues in DC/AC power systems including power grids with considerable penetration of renewable energy. It is also essential for shipboard power systems, aircraft powertrains, electric vehicles and hybrid electric vehicles to meet the peak load economically and improve the system's reliability and efficiency. Depending on the application and the required power and energy of the system, the storage devices should be selected. Moreover, the system cost, weight, space as well as its maintenance are the other factors that should be considered when a storage system is designed. This paper focuses on the latest technology development of high power storage devices e.g. supercapacitor, superconductive magnetic energy storage (SMES) and flywheels. These storage systems are able to efficiently provide very high power for a short duration of time and are suitable for a system with frequent and rapid charge and discharge characteristics. This paper also presents the detailed application of these storage technologies in a power grid and transportation system as well as critical loads and pulse loads.

[1]  A H Moghadasi,et al.  Pareto Optimality for the Design of SMES Solenoid Coils Verified by Magnetic Field Analysis , 2011, IEEE Transactions on Applied Superconductivity.

[2]  O. Mohammed,et al.  Event-Based Protection Scheme for a Multiterminal Hybrid DC Power System , 2015, IEEE Transactions on Smart Grid.

[3]  A. Mullane,et al.  Wind-turbine fault ride-through enhancement , 2005, IEEE Transactions on Power Systems.

[4]  Chia-Chi Chu,et al.  Power swings damping improvement by control of UPFC and SMES based on direct Lyapunov method application , 2008, 2008 IEEE Power and Energy Society General Meeting - Conversion and Delivery of Electrical Energy in the 21st Century.

[5]  Maarten Steinbuch,et al.  Optimal Control of a Mechanical Hybrid Powertrain With Cold-Start Conditions , 2014, IEEE Transactions on Vehicular Technology.

[6]  Shuiwen Shen,et al.  Analysis and control of a flywheel hybrid vehicular powertrain , 2004, IEEE Transactions on Control Systems Technology.

[7]  J. Vetrano,et al.  Grid Energy Storage , 2013 .

[8]  D. J. Swider,et al.  Compressed Air Energy Storage in an Electricity System With Significant Wind Power Generation , 2007, IEEE Transactions on Energy Conversion.

[9]  Nilanjan Senroy,et al.  Wind turbine with flywheel for improved power smoothening and LVRT , 2013, 2013 IEEE Power & Energy Society General Meeting.

[10]  Ahmed M. Massoud,et al.  A series flywheel architecture for power levelling and mitigation of DC voltage transients in multi‐terminal HVDC grids , 2014 .

[11]  Jorge L. Duarte,et al.  Line-Interactive UPS Using a Fuel Cell as the Primary Source , 2008, IEEE Transactions on Industrial Electronics.

[12]  Louis Wehenkel,et al.  Trajectory-Based Supplementary Damping Control for Power System Electromechanical Oscillations , 2014, IEEE Transactions on Power Systems.

[13]  Xavier Roboam,et al.  Hybrid power generation system for aircraft electrical emergency network , 2011 .

[14]  A.H.M.A. Rahim,et al.  A closed-loop quasi-optical dynamic braking resistor and shunt reactor control strategy for transient stability (of synchronous generators) , 1988 .

[15]  A. Massoud,et al.  Ride-through capability enhancement of VSC-HVDC based wind farms using low speed flywheel energy storage system , 2014, 2014 IEEE Applied Power Electronics Conference and Exposition - APEC 2014.

[16]  Jun Liang,et al.  Stability Improvement of Micro-grids with Coordinate Control of Fuel Cell and Ultracapacitor , 2007, 2007 IEEE Power Electronics Specialists Conference.

[17]  Carlos Moreira,et al.  Advanced Control Solutions for Operating Isolated Power Systems: Examining the Portuguese islands. , 2015, IEEE Electrification Magazine.

[18]  U Köhler,et al.  High performance nickel-metal hydride and lithium-ion batteries , 2002 .

[19]  Diego Feroldi,et al.  Design and Analysis of Fuel-Cell Hybrid Systems Oriented to Automotive Applications , 2009, IEEE Transactions on Vehicular Technology.

[20]  Ryan T. Elliott,et al.  Damping of inter-area oscillations using energy storage , 2013, 2013 IEEE Power & Energy Society General Meeting.

[21]  Prabath J. Binduhewa.  Uninterruptible power supply for short-time power back-up using ultracapacitors , 2011, 2011 6th International Conference on Industrial and Information Systems.

[22]  A.M. Miri,et al.  A stabilizer for oscillating torques in synchronous machines , 2005, IEEE Transactions on Industry Applications.

[23]  Rui Esteves Araujo,et al.  Robust DC-Link Control in EVs With Multiple Energy Storage Systems , 2012, IEEE Transactions on Vehicular Technology.

[24]  Mustafa Farhadi,et al.  Comparative analysis of energy control techniques for DC microgrid and pulsed power load applications , 2014, IECON 2014 - 40th Annual Conference of the IEEE Industrial Electronics Society.

[25]  Saifur Rahman,et al.  Flywheel Energy Storage Systems for Ride-through Applications in a Facility Microgrid , 2012, IEEE Transactions on Smart Grid.

[26]  S.M. Muyeen,et al.  A Variable Speed Wind Turbine Control Strategy to Meet Wind Farm Grid Code Requirements , 2010, IEEE Transactions on Power Systems.

[27]  Charis S. Demoulias,et al.  A new Fault Ride-Through control method for full-converter wind turbines employing Supercapacitor Energy Storage System , 2012, 2012 47th International Universities Power Engineering Conference (UPEC).

[28]  Barrie Mecrow,et al.  Design principles for a flywheel energy store for road vehicles , 1995 .

[29]  Alberto Bellini,et al.  Battery choice and management for new-generation electric vehicles , 2005, IEEE Transactions on Industrial Electronics.

[30]  M. Stanley Whittingham,et al.  History, Evolution, and Future Status of Energy Storage , 2012, Proceedings of the IEEE.

[31]  A. Oudalov,et al.  Optimizing a Battery Energy Storage System for Primary Frequency Control , 2007, IEEE Transactions on Power Systems.

[32]  Yilu Liu,et al.  The impact of energy storage on the dynamic performance of a static synchronous compensator , 2000, Proceedings IPEMC 2000. Third International Power Electronics and Motion Control Conference (IEEE Cat. No.00EX435).

[33]  Phatiphat Thounthong,et al.  Comparative Study of Fuel-Cell Vehicle Hybridization with Battery or Supercapacitor Storage Device , 2009, IEEE Transactions on Vehicular Technology.

[34]  J. McDowall,et al.  Commercial successes in power storage , 2005, IEEE Power and Energy Magazine.

[35]  M. G. Molina,et al.  Emulation of Synchronous Generator for Frequency Control of Smart Microgrids , 2013, IEEE Latin America Transactions.

[36]  Gaetano Zizzo,et al.  An Innovative Conversion Device to the Grid Interface of Combined RES-Based Generators and Electric Storage Systems , 2015, IEEE Transactions on Industrial Electronics.

[37]  Naehyuck Chang,et al.  Battery-supercapacitor hybrid system for high-rate pulsed load applications , 2011, 2011 Design, Automation & Test in Europe.

[38]  Ying Wu,et al.  Optimization of Fuel Cell and Supercapacitor for Fuel-Cell Electric Vehicles , 2006, IEEE Transactions on Vehicular Technology.

[39]  E. Hirst,et al.  Ancillary service details: Voltage control , 1997 .

[40]  Mevludin Glavic,et al.  Design of a resistive brake controller for power system stability enhancement using reinforcement learning , 2005, IEEE Transactions on Control Systems Technology.

[41]  Venkat Srinivasan,et al.  Mathematical Modeling of Electrochemical Capacitors , 1999 .

[42]  Osama A. Mohammed,et al.  Real-Time Operation and Harmonic Analysis of Isolated and Non-Isolated Hybrid DC Microgrid , 2014, IEEE Transactions on Industry Applications.

[43]  Osama A. Mohammed,et al.  Performance enhancement of actively controlled hybrid DC microgrid with pulsed load , 2014, 2014 IEEE Industry Application Society Annual Meeting.

[44]  Enrico Tironi,et al.  New Full-Frequency-Range Supercapacitor Model With Easy Identification Procedure , 2013, IEEE Transactions on Industrial Electronics.

[45]  P. T. Krein,et al.  Review of the Impact of Vehicle-to-Grid Technologies on Distribution Systems and Utility Interfaces , 2013, IEEE Transactions on Power Electronics.

[46]  Mohamed Elleuch,et al.  DPC for three-phase inverter to improve the integration of wind turbine associated to Flywheel Energy Storage System into the grid , 2009, 2009 6th International Multi-Conference on Systems, Signals and Devices.

[47]  T. Leung,et al.  Concept of a modified flywheel for megajoule storage and pulse conditioning , 1991 .

[48]  Philippe Delarue,et al.  Energy Storage System With Supercapacitor for an Innovative Subway , 2010, IEEE Transactions on Industrial Electronics.

[49]  Mario Paolone,et al.  Primary Voltage Control in Active Distribution Networks via Broadcast Signals: The Case of Distributed Storage , 2014, IEEE Transactions on Smart Grid.

[50]  Claudio R. Vergara.  Parametric interface for Battery Energy Storage Systems providing ancillary services , 2012, 2012 3rd IEEE PES Innovative Smart Grid Technologies Europe (ISGT Europe).

[51]  B. Roberts,et al.  Capturing grid power , 2009, IEEE Power and Energy Magazine.

[52]  Jae Woong Shim,et al.  Enhanced frequency regulation service using Hybrid Energy Storage System against increasing power-load variability , 2013, 2013 IEEE Power & Energy Society General Meeting.

[53]  Lotfi Krichen,et al.  Control and power management of a PEMFC-supercapacitor as a distributed generator , 2011, Eighth International Multi-Conference on Systems, Signals & Devices.

[54]  F. Blaabjerg,et al.  Control of Power Converters in AC Microgrids , 2012, IEEE Transactions on Power Electronics.

[55]  R. S. Weissbach,et al.  A combined uninterruptible power supply and dynamic voltage compensator using a flywheel energy storage system , 2001 .

[56]  Amir Hasan Moghadasi,et al.  Reduction in VA rating of the Unified Power Quality Conditioner with superconducting fault current limiters , 2010, 2010 1st Power Electronic & Drive Systems & Technologies Conference (PEDSTC).

[57]  L. Piegari,et al.  Storage systems for transportation, land handling and naval applications , 2012, 2012 Electrical Systems for Aircraft, Railway and Ship Propulsion.

[58]  Scott D. Sudhoff,et al.  Reducing Impact of Pulsed Power Loads on Microgrid Power Systems , 2010, IEEE Transactions on Smart Grid.

[59]  Karen L. Butler-Purry,et al.  Reactive Power Coordination of Shipboard Power Systems in Presence of Pulsed Loads , 2013, IEEE Transactions on Power Systems.

[60]  T. Murata,et al.  Effect of fuzzy logic-controlled SMES on damping turbine generator shaft torsional oscillations during unsuccessful reclosing , 2008, 2008 IEEE/PES Transmission and Distribution Conference and Exposition.

[61]  Youyi Wang,et al.  A dynamic discharge structure for ultracapacitor application in the fuel cell UPS , 2008, 2008 10th International Conference on Control, Automation, Robotics and Vision.

[62]  Bin Wu,et al.  An Overview of SMES Applications in Power and Energy Systems , 2010, IEEE Transactions on Sustainable Energy.

[63]  G. Joos,et al.  Supercapacitor Energy Storage for Wind Energy Applications , 2007, IEEE Transactions on Industry Applications.

[64]  Osama A. Mohammed,et al.  Adaptive Energy Management in Redundant Hybrid DC Microgrid for Pulse Load Mitigation , 2015, IEEE Transactions on Smart Grid.

[65]  Abdessattar Guermazi,et al.  Battery/Supercapacitors Combination in Uninterruptible Power Supply (UPS) , 2013, IEEE Transactions on Power Electronics.

[66]  N. Mithulananthan,et al.  A comparison of ultracapacitor, BESS and shunt capacitor on oscillation damping of power system with large-scale PV plants , 2011, AUPEC 2011.

[67]  Joe H. Chow,et al.  Electricity Market Design: An Integrated Approach to Reliability Assurance , 2005, Proceedings of the IEEE.

[68]  M. A. Abido,et al.  Supercapacitor based energy storage system for effective fault ride through of wind generation system , 2010, 2010 IEEE International Symposium on Industrial Electronics.

[69]  Srdjan M. Lukic,et al.  Energy Storage Systems for Automotive Applications , 2008, IEEE Transactions on Industrial Electronics.

[70]  H. Heydari,et al.  Optimization Scheme in Combinatorial UPQC and SFCL Using Normalized Simulated Annealing , 2011, IEEE Transactions on Power Delivery.

[71]  Fang Zhang,et al.  Effective flywheel energy storage (FES) offer strategies for frequency regulation service provision , 2014, 2014 Power Systems Computation Conference.

[72]  Jae-Do Park,et al.  Control of High-Speed Solid-Rotor Synchronous Reluctance Motor/Generator for Flywheel-Based Uninterruptible Power Supplies , 2008, IEEE Transactions on Industrial Electronics.

[73]  Yuan-Kang Wu,et al.  Effect of Low-Voltage-Ride-Through Technologies on the First Taiwan Offshore Wind Farm Planning , 2011, IEEE Transactions on Sustainable Energy.

[74]  Benoit Robyns,et al.  Design and Control Strategies of an Induction-Machine-Based Flywheel Energy Storage System Associated to a Variable-Speed Wind Generator , 2010, IEEE Transactions on Energy Conversion.

[75]  R.A. Dougal,et al.  Power enhancement of an actively controlled battery/ultracapacitor hybrid , 2005, IEEE Transactions on Power Electronics.

[76]  Jon Are Suul,et al.  Low Voltage Ride Through of Wind Farms With Cage Generators: STATCOM Versus SVC , 2008, IEEE Transactions on Power Electronics.

[77]  Jean-Michel Vinassa,et al.  Embedded Fractional Nonlinear Supercapacitor Model and Its Parametric Estimation Method , 2010, IEEE Transactions on Industrial Electronics.