Optimization of formic/acetic acid delignification of Miscanthus × giganteus for enzymatic hydrolysis using response surface methodology

Abstract A Box–Behnken experimental design and response surface methodology were employed to optimize the pretreatment parameters of a formic/acetic acid delignification treatment of Miscanthus  ×  giganteus for enzymatic hydrolysis. The effects of three independent variables, namely cooking time (1, 2 and 3 h), formic acid/acetic acid/water ratio (20/60/20, 30/50/20 and 40/40/20) and temperature (80, 90 and 107 °C) on pulp yield, residual Klason lignin content, concentration of degradation products (furfural and hydroxymethylfurfural) in the black liquor, and enzymatic digestibility of the pulps were investigated. The major parameter influencing was the temperature for pulp yield, delignification degree, furfural production and enzymatic digestibility. According to the response surface analysis the optimum conditions predicted for a maximum enzymatic digestibility of the glucan (75.3%) would be obtained using a cooking time of 3 h, at 107 °C and with a formic acid/acetic acid/water ratio of 40/40/20%. Glucan digestibility was highly dependent on the delignification degree.

[1]  G. Vázquez,et al.  The influence of acetosolv pulping conditions on the enzymatic hydrolysis of Eucalyptus pulps , 2000, Wood Science and Technology.

[2]  S J Duff,et al.  Effect of oxygen delignification on the rate and extent of enzymatic hydrolysis of lignocellulosic material. , 2001, Bioresource technology.

[3]  C. Wyman,et al.  Features of promising technologies for pretreatment of lignocellulosic biomass. , 2005, Bioresource technology.

[4]  G. Zeeman,et al.  Pretreatments to enhance the digestibility of lignocellulosic biomass. , 2009, Bioresource technology.

[5]  E. Arena,et al.  Methods for the determination of HMF in honey: a comparison , 2005 .

[6]  Yuan Liu,et al.  Effects of Cellulose Crystallinity, Hemicellulose, and Lignin on the Enzymatic Hydrolysis of Miscanthus sinensis to Monosaccharides , 2008, Bioscience, biotechnology, and biochemistry.

[7]  R. Elander,et al.  Process and economic analysis of pretreatment technologies. , 2005, Bioresource technology.

[8]  J. Saddler,et al.  Substrate and Enzyme Characteristics that Limit Cellulose Hydrolysis , 1999, Biotechnology progress.

[9]  B. Chabbert,et al.  Effect of harvesting date on the composition and saccharification of Miscanthus x giganteus. , 2010, Bioresource technology.

[10]  A. Wiselogel,et al.  Biomass feedstock resources and composition , 1997 .

[11]  P. Claassen,et al.  Pretreatment of Miscanthus for hydrogen production by Thermotoga elfii , 2002 .

[12]  R. Henry,et al.  A SIMPLE AND RAPID PREPARATION OF ALDITOL ACETATES FOR MONOSACCHARIDE ANALYSIS , 1983 .

[13]  Amie D. Sluiter,et al.  Determination of Structural Carbohydrates and Lignin in Biomass , 2004 .

[14]  Gerard Avignon,et al.  A new procedure for the destructuring of vegetable matter at atmospheric pressure by a catalyst/solvent system of formic acid/acetic acid.Applied to the pulping of triticale straw , 2001 .

[15]  Steven R. Thomas,et al.  Simultaneous saccharification and fermentation of pretreated hardwoods , 1997 .

[16]  T. McDonough.  The chemistry of organosolv delignification , 1992 .

[17]  A. Ragauskas,et al.  Pretreatment of Miscanthus x giganteus Using the Ethanol Organosolv Process for Ethanol Production , 2009 .

[18]  Guido Zacchi,et al.  Ethanol from lignocellulosics: A review of the economy , 1996 .

[19]  W. Steiner,et al.  Basic research and pilot studies on the enzymatic conversion of lignocellulosics , 1993 .

[20]  Bryan Bals,et al.  Optimization of Ammonia Fiber Expansion (AFEX) Pretreatment and Enzymatic Hydrolysis of Miscanthus x giganteus to Fermentable Sugars , 2007, Biotechnology progress.

[21]  Dehua Liu,et al.  Organosolv pretreatment of lignocellulosic biomass for enzymatic hydrolysis , 2009, Applied Microbiology and Biotechnology.

[22]  B. Weckhuysen,et al.  The catalytic valorization of lignin for the production of renewable chemicals. , 2010, Chemical reviews.

[23]  John N. Saddler,et al.  The effect of initial pore volume and lignin content on the enzymatic hydrolysis of softwoods , 1998 .

[24]  B. Ahring,et al.  Hydrolysis of Miscanthus for bioethanol production using dilute acid presoaking combined with wet explosion pre-treatment and enzymatic treatment. , 2008, Bioresource technology.

[25]  Ye Sun,et al.  Hydrolysis of lignocellulosic materials for ethanol production: a review. , 2002, Bioresource technology.

[26]  Monica Ek,et al.  Native lignin structure of Miscanthus x giganteus and its changes during acetic and formic acid fractionation. , 2009, Journal of agricultural and food chemistry.

[27]  N. Durán,et al.  Organosolv-pulping III , 1991 .