Finite-Element Modeling of Tubular Joints. I: Numerical Results

The results of a study of 12 tubular joint models with varying branch to chord diameter ratios β and branch inclination angles θ, subjected to axial tension, axial compression, and in-plane bending moment, are presented. The analyses were performed using finite-element software that is capable of modeling elasto-plastic material behavior and geometric nonlinearities as well as ductile and brittle fracture. The results showed that the current use of sin(θ) in design equations for inclined branches is reasonable, but somewhat conservative. When compared with the current experimental database, a close correlation of results was obtained for all axial tension cases, and for axial compression and in-plane bending moment cases for low to moderate β values. For a β value of 1 and compression and bending loads, the enhanced strength that was observed was attributed to uncertainty in the definition of failure, and the effects of various support conditions and chord lengths in the experimental studies. It is recomm...

[1]  C. L. Chow,et al.  A finite element analysis of continuum damage mechanics for ductile fracture , 1988, International Journal of Fracture.

[2]  M Lalani,et al.  RECENT DEVELOPMENTS IN THE ULTIMATE STRENGTH ASSESSMENT OF TUBULAR JOINTS: A NONLINEAR NUMERICAL TREATMENT , 1989 .

[3]  J. Lemaître.  How to use damage mechanics , 1984 .

[4]  J. G. Kuang,et al.  Ultimate Strength of Tubular Joints , 1977 .

[5]  Nelson F. F. Ebecken,et al.  Computational techniques for the elastic—plastic analysis of tubular joints , 1987 .

[6]  J. K. Ward,et al.  The Influence Of Chord Length And Boundary Conditions On K Joint Capacity , 1992 .

[7]  J. Lemaître.  A CONTINUOUS DAMAGE MECHANICS MODEL FOR DUCTILE FRACTURE , 1985 .

[8]  Jean Lemaitre,et al.  Local approach of fracture , 1986 .

[9]  Nelson F. F. Ebecken,et al.  Elastoplastic analysis of tubular joints of offshore platforms , 1987 .

[10]  Ai Kah Soh,et al.  SCF EQUATIONS FOR DT/X SQUARE-TO-ROUND TUBULAR JOINTS , 1991 .

[11]  William F. Cofer,et al.  Analysis of Welded Tubular Connections Using Continuum Damage Mechanics , 1992 .

[12]  W. F. Cofer,et al.  A three-dimensional, shell-solid transition element for general nonlinear analysis , 1991 .

[13]  Jihad S. Jubran,et al.  Ultimate strength analysis of structural components using the continuum damage mechanics approach , 1991 .

[14]  William Franklin Cofer.  An analytical determination of ultimate strength of tubular joints for offshore structures , 1988 .

[15]  W F Cofer,et al.  AN ANALYTICAL METHOD FOR ULTIMATE STRENGTH EVALUATION OF TUBULAR JOINTS , 1990 .

[16]  C. L. Chow,et al.  An anisotropic theory of elasticity for continuum damage mechanics , 1987 .

[17]  J. Chaboche.  Continuum Damage Mechanics: Part II—Damage Growth, Crack Initiation, and Crack Growth , 1988 .

[18]  Peter W. Marshall.  Design of Welded Tubular Connections : Basis and Use of AWS Code Provisions(構造)(学位論文要旨) , 1990 .

[19]  Kenneth M. Will,et al.  A FINITE ELEMENT TECHNIQUE FOR THE ULTIMATE STRENGTH ANALYSIS OF TUBULAR JOINTS , 1992 .