A Dynamic Analysis of the Multi-Stack SOFC-CHP System for Power Modulation

This paper performs a dynamic analysis of a 10-kW solid oxide fuel cell/combined heat and power (SOFC-CHP) system with a multi-stack module via numerical simulations. The performance of stacks, tail gas burners, heat exchangers, and fuel reformers are modeled by the MATLAB/Simulink module. The effects of fuel and air maldistribution on SOFC-CHP systems are addressed in this work. A two-stack module for 10-kW power generation is adopted to represent the multi-stack module with high power modulation. The air flow rate and operating current, which are related to the fuel use rate of an SOFC system, should be optimally regulated to perform with maximum power generation and efficiency. The proposed dynamic analysis shows that the operating temperatures of the two stacks have a difference of 33 K, which results in a reduced total power generation of 9.77 kW, with inconsistent fuel use (FU) rates of 78.3% and 56.8% for the two stacks. With the optimal control strategy, the output power is increased to 10.6 kW, an increment of 8.5%, and the FU rates of the two stacks are improved to 79% and 70%, respectively. As a potential distributed power generator, the long-term effects of the studied SOFC-CHP systems are also investigated. The dynamic analysis of the long-term operating SOFC-CHP system shows that the total daily output power can be increased 7.34% by using the optimal control strategy.

[1]  L. Barelli,et al.  Solid oxide fuel cell modelling: Electrochemical performance and thermal management during load-following operation , 2016 .

[2]  M. Godjevac,et al.  A thermodynamic comparison of solid oxide fuel cell-combined cycles , 2018, Journal of Power Sources.

[3]  J. Kupecki.  Off-design analysis of a micro-CHP unit with solid oxide fuel cells fed by DME , 2015 .

[4]  S. Chan,et al.  A complete polarization model of a solid oxide fuel cell and its sensitivity to the change of cell component thickness , 2001 .

[5]  Matthias Rzepka,et al.  Thermal start-up behaviour and thermal management of SOFC's , 2006 .

[6]  Gaetano Florio,et al.  A Performance Analysis of an Anaerobic Digester—High Temperature Fuel Cells Fed by Urban Solid Waste Biogas , 2011 .

[7]  Valeria Palomba,et al.  Tri-generation for industrial applications: Development of a simulation model for a gasification-SOFC based system , 2017 .

[8]  Aristide F. Massardo,et al.  Internal Reforming Solid Oxide Fuel Cell-Gas Turbine Combined Cycles (IRSOFC-GT): Part A—Cell Model and Cycle Thermodynamic Analysis , 2000 .

[9]  Amornchai Arpornwichanop,et al.  Thermodynamic analysis of solid oxide fuel cell system using different ethanol reforming processes , 2015 .

[10]  Y. Matsuzaki,et al.  Development of segmented-in-series-type solid oxide fuel cells for residential applications , 2012 .

[11]  Petronilla Fragiacomo,et al.  Experimental Activity on a 100-W IT-SOFC Test Bench Fed by Simulated Syngas , 2018 .

[12]  K. F. Fong,et al.  Development of multi-supply-multi-demand control strategy for combined cooling, heating and power system primed with solid oxide fuel cell-gas turbine , 2017 .

[13]  Mario L. Ferrari,et al.  Advanced control approach for hybrid systems based on solid oxide fuel cells , 2015 .

[14]  Zdzisław Jaworski,et al.  Numerical investigation of a novel burner to combust anode exhaust gases of SOFC stacks , 2017 .

[15]  Jakub Kupecki,et al.  Experimental and numerical analysis of a serial connection of two SOFC stacks in a micro-CHP system fed by biogas , 2017 .

[16]  K. Andreas Friedrich,et al.  Modeling of a thermally integrated 10 kWe planar solid oxide fuel cell system with anode offgas recycling and internal reforming by discretization in flow direction , 2015 .

[17]  Petronilla Fragiacomo,et al.  Performance analysis of a Solid Oxide Fuel Cell-Gasifier integrated system in co-trigenerative arrangement , 2018 .

[18]  Murat Peksen,et al.  SOFC stack performance under high fuel utilization , 2015 .

[19]  Yohei Tanaka,et al.  Numerical Simulation of SOFC System Performance at 90% Fuel Utilization with or without Anode Off-Gas Recycle for Enhancing Efficiency , 2015 .

[20]  Jonathan Love,et al.  Generating Electricity at 60% Electrical Efficiency from 1 - 2 kWe SOFC Products , 2009 .

[21]  Jamasb Pirkandi,et al.  Electrochemical and thermodynamic modeling of a CHP system using tubular solid oxide fuel cell (SOFC-CHP) , 2012 .

[22]  Chung-Jen Tseng,et al.  Analysis of an intermediate-temperature proton-conducting SOFC hybrid system , 2016 .

[23]  Takuto Araki,et al.  Cycle analysis of planar SOFC power generation with serial connection of low and high temperature SOFCs , 2006 .

[24]  Paulina Pianko-Oprych,et al.  Dynamic Analysis of Load Operations of Two-Stage SOFC Stacks Power Generation System , 2017 .

[25]  Masanori Nishiura,et al.  Recent Progress of SOFC Combined Cycle System with Segmented-in-Series Tubular Type Cell Stack at MHPS , 2013 .

[26]  Nigel P. Brandon,et al.  Anode-supported intermediate-temperature direct internal reforming solid oxide fuel cell. II. Model-based dynamic performance and control , 2005 .

[27]  A. Virkar,et al.  Dependence of polarization in anode-supported solid oxide fuel cells on various cell parameters , 2005 .

[28]  C. Adjiman,et al.  Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance , 2004 .

[29]  D. Cui,et al.  Comparison of different current collecting modes of anode supported micro-tubular SOFC through mathematical modeling , 2007 .

[30]  Melissa M. Bilec,et al.  SOFC Stack Model for Integration Into a Hybrid System: Stack Response to Control Variables , 2015 .

[31]  Sang Keun Dong,et al.  Experimental and simulated investigation of 1 kW solid oxide fuel cell balance of power system , 2012 .