论文信息 - Risk and Design Management Based on Failure Mode

Risk and Design Management Based on Failure Mode

Latent problems in products can cause the accidents in use. Failure modes and effects analysis (FMEA) is normally used to predict these latent problems. However, a process of filling data sheets of FMEA is not obvious in detail and the utility of FMEA sheet in next product plans involves various problems such as difficulties in searching specific data. In this chapter, the revised method of FMEA, called System design review based on failure modes (DRBFM) based on the design concept

Yuichi Otsuka

[1] Jop Groeneweg,et al. Accidents at Sea: Multiple Causes and Impossible Consequences , 1987, Int. J. Man Mach. Stud..

[2] Hirokazu Shimizu,et al. Design review based on failure mode to visualise reliability problems in the development stage of mechanical products , 2010 .

[3] Tatsuhiko Yoshimura,et al. Reliability Problem Prevention Method of Stimulating Creativity Needed to Notice Problems , 2004 .

[4] Wang Ying-lin,et al. A metrics based task analysis model for design review planning , 2003 .

[5] Robert E. Melchers,et al. Probabilistic Risk Assessment of Engineering Systems , 1997 .

[6] James T. Reason,et al. Managing the risks of organizational accidents , 1997 .

[7] Kikuo Fujita,et al. Survey and Analysis of Utilization of Tools and Methods in Product Development , 2006 .

[8] S. Timoshenko,et al. Theory of elasticity , 1975 .

[9] Karl-Erik Sveiby. Transfer of knowledge and the information processing professions , 1996 .

[10] S. Suresh. Fatigue of materials , 1991 .

[11] Jun Munemori,et al. Development and trial of groupware for organizational design and management: distributed and cooperative KJ method support system , 1991 .

[12] Yotaro Hatamura. Learning from Failure , 2002 .

[13] Trevor Kletz,et al. Learning from Accidents , 2001 .