Repetition Rate Dependence of Gain Compression in InGaAsP Optical Amplifiers

A two-level model of a semiconductor optical amplifier is used to calculate gain compression due to picosecond optical pulse injection. Gain compression (measured in decibels) is shown to depend linearly on output pulse energy, with a slope that is characterized by a saturation energy. The authors present measurements of gain compression in the three regimes of repetition rates. A very low repetition rate (200 kHz) is the single-pulse injection regime, 500 MHz to 2 GHz is the regime where the pulse period is comparable to the gain recovery time in the amplifier under test, and 3-6 GHz is the regime where the pulse period is smaller than the gain recovery time. In all cases, the measurements confirm the gain compression characteristics predicted by the model. They show that a short gain recovery time results in an increased output power for a given acceptable level of gain compression, as well as an increased gain level for a given output power. >

[1]  E. Ippen,et al.  Amplification of subpicosecond optical pulses: Theory and experiment , 1982, IEEE Journal of Quantum Electronics.

[2]  B. Thedrez,et al.  Two-level description of gain and mixing susceptibilities in amplifying semiconductor materials , 1988 .

[3]  L. Frantz,et al.  Theory of Pulse Propagation in a Laser Amplifier , 1963 .

[4]  Gregory Raybon,et al.  Travelling-wave optical amplifier at 1.3μm , 1987 .

[5]  N. Frigo.  Ultrashort pulse propogation in saturable media: A simple physical model , 1983 .

[6]  D. Spirit,et al.  Picosecond pulse response of a travelling-wave semiconductor laser amplifier , 1987 .

[7]  Gregory Raybon,et al.  Distortionless picosecond pulse amplification and gain compression in a traveling‐wave InGaAsP optical amplifier , 1988 .

[8]  Gregory Raybon,et al.  Amplification of high repetition rate picosecond pulses using an InGaAsP traveling-wave optical amplifier , 1988 .

[9]  R. F. Karlicek,et al.  High‐speed distributed feedback lasers grown by hydride epitaxy , 1988 .

[10]  C. Henry.  Chapter 3 Spectral Properties of Semiconductor Lasers , 1985 .

[11]  M. Pilkuhn,et al.  Quantitative evaluation of gain and losses in quaternary lasers , 1985 .

[12]  J. Wiesenfeld,et al.  Picosecond pulse generation in optically pumped, ultrashort-cavity, InGaAsP, InP, and InGaAs film lasers , 1986 .

[13]  F. G. Storz,et al.  Gain recovery time of traveling‐wave semiconductor optical amplifiers , 1989 .

[14]  Takaaki Mukai,et al.  Broadband 1.5μm GaInAsP travelling-wave laser amplifier with high-saturation output power , 1987 .

[15]  N. Dutta,et al.  Improved linearity and kink criteria for 1.3‐μm InGaAsP‐InP channeled substrate buried heterostructure lasers , 1984 .

[16]  Erich P. Ippen,et al.  Subpicosecond gain dynamics in GaAlAs laser diodes , 1987 .

[17]  Frey,et al.  Two-level approach to saturation properties in semiconductor materials. , 1988, Physical review. B, Condensed matter.

[18]  C. A. Raffo,et al.  Absorption saturation in germanium, silicon, and gallium arsenide at 10.6 μm , 1972 .

[19]  Adel A. M. Saleh,et al.  Effects of semiconductor-optical-amplifier nonlinearity on the performance of high-speed intensity-modulation lightwave systems , 1990, IEEE Trans. Commun..