An aerial 3D printing test mission

This paper provides an overview of an aerial 3D printing technology, its development and its testing. This technology is potentially useful in its own right. In addition, this work advances the development of a related in-space 3D printing technology. A series of aerial 3D printing test missions, used to test the aerial printing technology, are discussed. Through completing these test missions, the design for an in-space 3D printer may be advanced. The current design for the in-space 3D printer involves focusing thermal energy to heat an extrusion head and allow for the extrusion of molten print material. Plastics can be used as well as composites including metal, allowing for the extrusion of conductive material. A variety of experiments will be used to test this initial 3D printer design. High altitude balloons will be used to test the effects of microgravity on 3D printing, as well as parabolic flight tests. Zero pressure balloons can be used to test the effect of long 3D printing missions subjected to low temperatures. Vacuum chambers will be used to test 3D printing in a vacuum environment. The results will be used to adapt a current prototype of an in-space 3D printer. Then, a small scale prototype can be sent into low-Earth orbit as a 3-U cube satellite. With the ability to 3D print in space demonstrated, future missions can launch production hardware through which the sustainability and durability of structures in space will be greatly improved.

[1]  Jeremy Straub,et al.  Implementation of a large solar collector for electric charge generation , 2016, SPIE Defense + Security.

[2]  Ryan B. Wicker,et al.  Integrating stereolithography and direct print technologies for 3D structural electronics fabrication , 2012 .

[3]  Joshua M. Pearce,et al.  Mechanical properties of components fabricated with open-source 3-D printers under realistic environmental conditions , 2014 .

[4]  Jeremy Straub,et al.  Enablement of scientific remote sensing missions with in-space 3D printing , 2016, SPIE Commercial + Scientific Sensing and Imaging.

[5]  Jeremy Straub,et al.  Design for an in-space 3D printer , 2016, SPIE Defense + Security.

[6]  Ola L. A. Harrysson,et al.  Characterization of H13 steel produced via electron beam melting , 2004 .

[7]  Jeremy Straub,et al.  Powering an in-space 3D printer using solar light energy , 2016, SPIE Commercial + Scientific Sensing and Imaging.

[8]  P. Wright,et al.  Anisotropic material properties of fused deposition modeling ABS , 2002 .

[9]  H. M. Cathey,et al.  Thermal performance modeling of NASA’s scientific balloons , 2002 .

[10]  Robert H. Holzworth,et al.  Electrodynamics of the stratosphere using 5000 m3 superpressure balloons , 1983 .

[11]  Jeremy Straub,et al.  Enablement of defense missions with in-space 3D printing , 2016, SPIE Defense + Security.

[12]  L. Froyen,et al.  Binding Mechanisms in Selective Laser Sintering and Selective Laser Melting , 2004 .

[13]  Cynthia M. Gomes,et al.  Laminated object manufacturing of LZSA glass‐ceramics , 2011 .

[14]  R. Inführ,et al.  Photopolymers for rapid prototyping , 2007 .

[15]  David A. Hutchins,et al.  A Simple, Low-Cost Conductive Composite Material for 3D Printing of Electronic Sensors , 2012, PloS one.