Magnesium oxide nanoparticles dispersed solar salt with improved solid phase thermal conductivity and specific heat for latent heat thermal energy storage

Abstract Composites comprising MgO nanoparticles as the dispersed phase and solid phase solar salt as the matrix have been prepared through solid-state mixing. The inclusion of MgO nanoparticles had very little influence on the solid-liquid phase change temperature and the latent heat of solar salt. However, the solid phase thermal conductivity of MgO-solar salt was elevated by 17.5% with the dispersion of 0.25 wt% MgO nanoparticles. The clustered nature of MgO nanoparticles and their presence at the interface between solar salt particles with reduced resistance might have contributed to the solid phase thermal conductivity enhancement for this composition of the composite. The maximum enhancement in specific heat of MgO-solar salt composite (14%) was observed at another composition (1 wt%), revealing the requirement of different composition for optimum thermal conductivity and optimum specific heat. The solidification time for 0.25 wt% composite was 30% lower than that of the solar salt. Also, the rate of discharge from 0.25 wt% composite was 42.4% higher than that of solar salt. The corresponding data for the composite containing 2 wt% MgO are 13.8% and 33.8% respectively. These composites can be used in latent heat thermal energy storage systems.

[1]  D. Wen,et al.  Effect of Al2O3 nanoparticle dispersion on the specific heat capacity of a eutectic binary nitrate salt for solar power applications , 2017 .

[2]  J. M. Sala-Lizarraga,et al.  Molten salt-based nanofluids as efficient heat transfer and storage materials at high temperatures. An overview of the literature , 2018 .

[3]  Ming Li,et al.  Thermal characterization of nitrates and nitrates/expanded graphite mixture phase change materials for solar energy storage , 2013 .

[4]  R. Tamme,et al.  Development of PCM Storage for Process Heat and Power Generation , 2009 .

[5]  J. Kenny,et al.  Effect of nanoparticles on heat capacity of nanofluids based on molten salts as PCM for thermal energy storage , 2013, Nanoscale Research Letters.

[6]  Bin-Juine Huang,et al.  Development of hybrid solar-assisted cooling/heating system , 2010 .

[7]  Gilles Flamant,et al.  High-efficiency solar power towers using particle suspensions as heat carrier in the receiver and in the thermal energy storage , 2017 .

[8]  Experimental study on heat capacity of paraffin/water phase change emulsion , 2010 .

[9]  R. L. Sawhney,et al.  Solar water heaters with phase change material thermal energy storage medium: A review , 2009 .

[10]  Georgios Kokogiannakis,et al.  Review of phase change emulsions (PCMEs) and their applications in HVAC systems , 2015 .

[11]  C. Doetsch,et al.  Evaluation of paraffin/water emulsion as a phase change slurry for cooling applications , 2009 .

[12]  Yulong Ding,et al.  Thermal-physical properties of nanoparticle-seeded nitrate molten salts , 2018 .

[13]  Syeda Humaira Tasnim,et al.  Nano-PCM filled energy storage system for solar-thermal applications , 2018, Renewable Energy.

[14]  G. Brooks,et al.  Thermal analysis of molten ternary lithium-sodium-potassium nitrates , 2017 .

[15]  Cristina Prieto,et al.  Review of commercial thermal energy storage in concentrated solar power plants: Steam vs. molten salts , 2017 .

[16]  Peng Zhang,et al.  Thermal energy storage and retrieval characteristics of a molten-salt latent heat thermal energy storage system , 2016 .

[17]  Ge Li,et al.  Effect of in-situ synthesized nano-MgO on thermal properties of NaNO3-KNO3 , 2018 .

[18]  Hanfei Zhang,et al.  Microencapsulated binary carbonate salt mixture in silica shell with enhanced effective heat capacity for high temperature latent heat storage , 2019, Renewable Energy.

[19]  Yulong Ding,et al.  Mechanical Dispersion of Nanoparticles and Its Effect on the Specific Heat Capacity of Impure Binary Nitrate Salt Mixtures , 2015, Nanomaterials.

[20]  Prabha Dashora,et al.  Design development and performance studies of a novel Single Family Solar Cooker , 2012 .

[21]  K. S. Rajan,et al.  New hybrid nanofluid containing encapsulated paraffin wax and sand nanoparticles in propylene glycol-water mixture: Potential heat transfer fluid for energy management , 2017 .

[22]  Pau Gimenez-Gavarrell,et al.  Glass encapsulated phase change materials for high temperature thermal energy storage , 2017 .

[23]  Jinhong Li,et al.  Enhanced thermal conductivity of form-stable phase change composite with single-walled carbon nanotubes for thermal energy storage , 2017, Scientific Reports.

[24]  R. Cioffi,et al.  Finite Element Method Modeling of Sensible Heat Thermal Energy Storage with Innovative Concretes and Comparative Analysis with Literature Benchmarks , 2014 .

[25]  Xiaolan Wei,et al.  Thermal conductivity improvement of liquid Nitrate and Carbonate salts doped with MgO particles , 2017 .

[26]  Soteris A. Kalogirou,et al.  Solar thermal collectors and applications , 2004 .

[27]  Min Li.  A nano-graphite/paraffin phase change material with high thermal conductivity , 2013 .

[28]  S. Ünalan,et al.  Thermal performance of a concrete column as a sensible thermal energy storage medium and a heater , 2017 .

[29]  I. Pop,et al.  A review of the applications of nanofluids in solar energy , 2013 .

[30]  Robert A. Taylor,et al.  Specific heat control of nanofluids: A critical review , 2016 .

[31]  K. S. Rajan,et al.  Rapid synthesis of MgO nanoparticles & their utilization for formulation of a propylene glycol based nanofluid with superior transport properties , 2014 .

[32]  Xiaoze Du,et al.  Thermal energy storage enhancement of a binary molten salt via in-situ produced nanoparticles , 2017 .

[33]  Xinhai Xu,et al.  Heat transfer fluids for concentrating solar power systems – A review , 2015 .

[34]  R. Martinez-Cuenca,et al.  Increment of specific heat capacity of solar salt with SiO2 nanoparticles , 2014, Nanoscale Research Letters.

[35]  D. Mills.  Advances in solar thermal electricity technology , 2004 .

[36]  D. Wen,et al.  Latent and sensible energy storage enhancement of nano-nitrate molten salt , 2018, Solar Energy.

[37]  F. Bai,et al.  Design and optimization of solid thermal energy storage modules for solar thermal power plant applications , 2015 .

[38]  Byeongnam Jo,et al.  Anomalous Increase in Specific Heat of Binary Molten Salt-Based Graphite Nanofluids for Thermal Energy Storage , 2018, Applied Sciences.

[39]  Ming-Chang Lu,et al.  Specific heat capacity of molten salt-based alumina nanofluid , 2013, Nanoscale Research Letters.

[40]  Yan Li,et al.  Solar salt doped by MWCNTs as a promising high thermal conductivity material for CSP , 2018, RSC advances.

[41]  Annika Skoglund,et al.  On the physics of power, energy and economics of renewable electric energy sources - Part I , 2010 .

[42]  T. Bauer,et al.  Thermal energy storage – overview and specific insight into nitrate salts for sensible and latent heat storage , 2015, Beilstein journal of nanotechnology.

[43]  Philip D. Myers,et al.  Nitrate salts doped with CuO nanoparticles for thermal energy storage with improved heat transfer , 2016 .

[44]  S. Gustafsson.  Transient plane source techniques for thermal conductivity and thermal diffusivity measurements of solid materials , 1991 .

[45]  S. Iniyan,et al.  A review of solar thermal technologies , 2010 .

[46]  R. Pitchumani,et al.  Computational studies on a latent thermal energy storage system with integral heat pipes for concentrating solar power , 2013 .

[47]  S. B. Nasrallah,et al.  Thermal properties improvement of Lithium nitrate/Graphite composite phase change materials , 2016 .

[48]  Xing Ju,et al.  Selection principles and thermophysical properties of high temperature phase change materials for thermal energy storage: A review , 2018 .

[49]  R. Velraj,et al.  Heat transfer enhancement in a latent heat storage system , 1999 .