Procedural influences on non-linear distortions in welded thin plate fabrication

Fusion welding is the most common and convenient method used for the fabrication of large, thin-plate welded structures. However, the resulting tendency to out-of-plane distortion exacts severe design and fabrication penalties in terms of poorer buckling performance, lack of fairness in external appearance, poor fit-up and frequent requirements for expensive rework. This study forms part of a long-term project that has the aim of modelling welding and related fabrication processes computationally with particular emphasis on the out-of-plane distortion outcomes. Throughout the present work the computational models have been cross-referenced to realistic experimental test cases. A repeated finding of the trials was that minor variations in fabrication procedures, were found to have significant effects on distortion. In particular, the pre-fabrication procedures, including spot and tack welding, have a significant effect on the initial out-of-plane distortion leading to differences in distortion of the post-welded structures. The support and clamping conditions during welding and cooling of welded thin-plate structures were also found to have a considerable influence on the final predicted out-of-plane distortion. The outcomes often result in different buckling instability behaviour. This paper concentrates on these aspects and draws on studies of buttwelding between plates of thicknesses 3-8 mm.

[1]  Tom Gray,et al.  Design Support Tool for Prediction of Welding Distortion in Multiply Stiffened Plate Structures: Experimental and Computational Investigation , 2005 .

[2]  J. Goldak,et al.  A new finite element model for welding heat sources , 1984 .

[3]  Tom Gray,et al.  Thermal Distortion of Stiffened Plate due to Fillet Welds Computational and Experimental Investigation , 2006 .

[4]  Tom Gray,et al.  Investigation of temperature transients during flux-cored CO2 butt welding of CMn steel plates , 2003 .

[5]  E. Friedman.  Thermomechanical Analysis of the Welding Process Using the Finite Element Method , 1975 .

[6]  Tom Gray,et al.  Computational prediction of out-of-plane welding distortion and experimental investigation , 2005 .

[7]  Pierluigi Mollicone,et al.  Experimental validation of computational methods for welding distortion prediction , 2006 .

[8]  Tom Gray,et al.  Optimization of welded lightweight multiple-stiffener plate structures to minimise unwanted shape distortion , 2006 .

[9]  Pierluigi Mollicone,et al.  Computational methods and experimental validation of welding distortion models , 2007 .

[10]  Lars-Erik Lindgren,et al.  FINITE ELEMENT MODELING AND SIMULATION OF WELDING PART 1: INCREASED COMPLEXITY , 2001 .

[11]  Pierluigi Mollicone,et al.  Simple thermo-elastic–plastic models for welding distortion simulation , 2006 .

[12]  Tom Gray,et al.  Computationally efficient welding distortion simulation techniques , 2005 .

[13]  Pierluigi Mollicone,et al.  Alternative simulation techniques for distortion of thin plate due to fillet-welded stiffeners , 2006 .