Spring-in of curved CFRP/foam-core sandwich structures

Abstract This paper reports on a comprehensive study on process-induced distortions (PID) of curved CFRP/foam-core sandwich panels. The study’s aim is to validate the prediction quality of two existing analytical models and a novel straightforward simulation technique, which utilizes measured spring-in distortions of representative monolithic samples as input. Sandwich specimens with a radius of approximately 350 mm are manufactured with three different core thicknesses and two different core run-out geometries. The manufactured parts show a significant radius reduction which declines for increasing core thickness which is satisfactorily predicted by both, the analytical models and the simulation. The effect of the run-out shape turned out to be of inferior relevance for the investigated specimen configurations. However, it is found to be essential to use plane-stress assumptions and to capture the stiffness ratio between the skins and the core. Therefore, an extension of the Fernlund model is proposed whose predictions match excellently with the measured distortion of the specimens. Given the simplicity of the simulation approach in combination with the limited number of inputs makes it a tool of great value, particularly early on in the design cycle.

[1]  Qi Zhu,et al.  Dimensional Accuracy of Thermoset Composites: Simulation of Process-Induced Residual Stresses , 2001 .

[2]  Göran Fernlund,et al.  Predicting process-induced distortions in composite manufacturing – A pheno-numerical simulation strategy , 2015 .

[3]  Nuri Ersoy,et al.  In situ measurements of through-the-thickness strains during processing of AS4/8552 composite , 2007 .

[4]  George S. Springer,et al.  Heat of Reaction, Degree of Cure, and Viscosity of Hercules 3501-6 Resin , 1982 .

[5]  Michael Sinapius,et al.  Manufacturing distortions of a CFRP box-structure – A semi-numerical prediction approach , 2013 .

[6]  Christian Hühne,et al.  Experimental identification of process parameters inducing warpage of autoclave-processed CFRP parts , 2012 .

[7]  Anoush Poursartip,et al.  Tool–part interaction in composites processing. Part I: experimental investigation and analytical model , 2004 .

[8]  Nuri Ersoy,et al.  Shear-lag Analysis of the Effect of Thickness on Spring-in of Curved Composites , 2007 .

[9]  Eric Jones,et al.  SciPy: Open Source Scientific Tools for Python , 2001 .

[10]  Scott R. White,et al.  Process Modeling of Composite Materials: Residual Stress Development during Cure. Part I. Model Formulation , 1992 .

[11]  Göran Fernlund.  Spring-in of angled sandwich panels , 2005 .

[12]  C. K. Huang,et al.  Warping in advanced composite tools with varying angles and radii , 1997 .

[13]  A. Johnston,et al.  An integrated model of the development of process-induced deformation in autoclave processing of composite structures , 1997 .

[14]  Reza Vaziri,et al.  Computationally efficient pseudo-viscoelastic models for evaluation of residual stresses in thermoset polymer composites during cure , 2010 .

[15]  Carolyne Albert,et al.  Spring-in and warpage of angled composite laminates , 2002 .