Electrostatic Excitation for the Force Amplification of Microcantilever Sensors

This paper describes an electrostatic excited microcantilever sensor operating in static mode that is more sensitive than traditional microcantilevers. The proposed sensor comprises a simple microcantilever with electrostatic excitation ability and an optical or piezoresistive detector. Initially the microcantilever is excited by electrostatic force to near pull-in voltage. The nonlinear behavior of the microcantilever in near pull-in voltage i.e., the inverse-square relation between displacement and electrostatic force provides a novel method for force amplification. In this situation, any external load applied to the sensor will be amplified by electrostatic force leading to more displacement. We prove that the proposed microcantilever sensor can be 2 to 100 orders more sensitive compared with traditional microcantilevers sensors of the same dimensions. The results for surface stress and the free-end point force load are discussed.

[1]  Zhongxu Hu,et al.  A parametrically amplified MEMS rate gyroscope , 2011 .

[2]  Kimberly L. Turner,et al.  Comparison of parametric and linear mass detection in the presence of detection noise , 2011 .

[3]  Michael Huth,et al.  A Tunable Strain Sensor Using Nanogranular Metals , 2010, Sensors.

[4]  Ying Chen,et al.  Quad-cantilever microsensors with a low-cost single-sided micro-machining technique for trace chemical vapor detection , 2010 .

[5]  F. Keulen,et al.  Application of electrostatic pull-in instability on sensing adsorbate stiffness in nanomechanical resonators , 2010 .

[6]  H. Ji,et al.  Approaches to increasing surface stress for improving signal-to-noise ratio of microcantilever sensors. , 2010, Analytical chemistry.

[7]  Beth L Pruitt,et al.  Design optimization of piezoresistive cantilevers for force sensing in air and water. , 2009, Journal of applied physics.

[8]  Chongdu Cho,et al.  Deflection, Frequency, and Stress Characteristics of Rectangular, Triangular, and Step Profile Microcantilevers for Biosensors , 2009, Sensors.

[9]  S. Chaterjee,et al.  A large deflection model for the pull-in analysis of electrostatically actuated microcantilever beams , 2009 .

[10]  Chongdu Cho,et al.  Comparison between Deflection and Vibration Characteristics of Rectangular and Trapezoidal profile Microcantilevers , 2009, Sensors.

[11]  Hai-Feng Ji,et al.  Mechanical and electronic approaches to improve the sensitivity of microcantilever sensors , 2009, Acta mechanica Sinica = Li xue xue bao.

[12]  Chongdu Cho,et al.  A Study on Increasing Sensitivity of Rectangular Microcantilevers Used in Biosensors , 2008, Sensors.

[13]  William Paul King,et al.  The effect of piezoresistive microcantilever geometry on cantilever sensitivity during surface stress chemical sensing , 2008 .

[14]  L. Nicu,et al.  A Microcantilever-Based Picoliter Droplet Dispenser With Integrated Force Sensors and Electroassisted Deposition Means , 2008, Journal of Microelectromechanical Systems.

[15]  Hui Xie,et al.  Enhanced Accuracy of Force Application for AFM Nanomanipulation Using Nonlinear Calibration of Optical Levers , 2008, IEEE Sensors Journal.

[16]  Anja Boisen,et al.  SU-8 Cantilevers for Bio/chemical Sensing; Fabrication, Characterisation and Development of Novel Read-out Methods , 2008, Sensors.

[17]  G. Rezazadeh,et al.  Application of the Generalized Differential Quadrature Method to the Study of Pull-In Phenomena of MEMS Switches , 2007, Journal of Microelectromechanical Systems.

[18]  A. Alasty,et al.  Analytical investigation and numerical verification of Casimir effect on electrostatic nano-cantilevers , 2007 .

[19]  Javier Tamayo,et al.  Study of the Origin of Bending Induced by Bimetallic Effect on Microcantilever , 2007, Sensors.

[20]  Wei Wang,et al.  Design of High-Sensitivity Cantilever and Its Monolithic Integration With CMOS Circuits , 2007, IEEE Sensors Journal.

[21]  Shih-Ming Yang,et al.  Development of a double-microcantilever for surface stress measurement in microsensors , 2007 .

[22]  Xinxin Li,et al.  A single-sided micromachined piezoresistive SiO2 cantilever sensor for ultra-sensitive detection of gaseous chemicals , 2006 .

[23]  A. Boisen,et al.  Polymeric cantilever-based biosensors with integrated readout , 2006 .

[24]  Min Liu,et al.  Silicon dioxide microcantilever with piezoresistive element integrated for portable ultraresoluble gaseous detection , 2006 .

[25]  R. McKendry,et al.  SU8 bio-chemical sensor microarrays , 2006 .

[26]  V. Dravid,et al.  MOSFET-Embedded Microcantilevers for Measuring Deflection in Biomolecular Sensors , 2006, Science.

[27]  Hai-Feng Ji,et al.  Simulation of SiO2-based piezoresistive microcantilevers , 2006 .

[28]  J. Cairney,et al.  Rapid detection of bacterial spores using a quartz crystal microbalance (QCM) immunoassay , 2005, IEEE Sensors Journal.

[29]  A. Boisen,et al.  Aluminum nano-cantilevers for high sensitivity mass sensors , 2005, 5th IEEE Conference on Nanotechnology, 2005..

[30]  Horacio Dante Espinosa,et al.  EXPERIMENTS AND MODELING OF CARBON NANOTUBE-BASED NEMS DEVICES , 2005 .

[31]  Yin Zhang,et al.  Modelling analysis of surface stress on a rectangular cantilever beam , 2004 .

[32]  Shiuh-Jer Huang,et al.  Some design considerations on the electrostatically actuated microstructures , 2004 .

[33]  C. Ozkan,et al.  Modeling and Optimal Design of High-Sensitivity Piezoresistive Microcantilevers Within Flow Channels for Biosensing Applications , 2003 .

[34]  Cengiz S. Ozkan,et al.  High sensitivity piezoresistive cantilever design and optimization for analyte-receptor binding , 2003 .

[35]  P. Vettiger,et al.  Polymer-based stress sensor with integrated readout , 2002 .

[36]  Amit K. Gupta,et al.  On the design of piezoresistive silicon cantilevers with stress concentration regions for scanning probe microscopy applications , 2000 .

[37]  T.E. Schaffer,et al.  Microfabricated small metal cantilevers with silicon tip for atomic force microscopy , 2000, Journal of Microelectromechanical Systems.

[38]  Richard J. Colton,et al.  Biosensor based on force microscope technology , 1996 .

[39]  T. Sisson,et al.  An improved method for immobilizing IgG antibodies on protein A-agarose. , 1990, Journal of immunological methods.

[40]  Lin Yuanhui,et al.  フォトレジスト上のパリレンC(POP):ポリマー/金属ナノワイヤ製造のための低温スペーサ技術 , 2011 .

[41]  S. Sukuabol,et al.  Geometric Optimisation of SU-8 Piezoresistive Cantilever Sensors for Biochemical Applications , 2005, 2005 International Conference on Intelligent Sensors, Sensor Networks and Information Processing.

[42]  M. Larsen.  Piezoresistive SU-8 Cantilevers for Investigation of Cell-Substrate Interactions , 2005 .

[43]  Julian W. Gardner,et al.  Review of Conventional Electronic Noses and Their Possible Application to the Detection of Explosives , 2004 .

[44]  Kimberly L. Turner,et al.  Institute of Physics Publishing Journal of Micromechanics and Microengineering Mechanical Domain Coupled Mode Parametric Resonance and Amplification in a Torsional Mode Micro Electro Mechanical Oscillator , 2022 .