A contactless induction system for battery recharging of autonomous vehicles

Contactless induction mechanisms represent a valuable solution to recharge battery-powered vehicles when plugging to the mains reveals troublesome or impossible. A relevant example is that of unmanned aerial vehicles (UAV) employed in hostile environments for persistent surveillance and perils reconnaissance. To complete long duration missions, these vehicles have to land on mobile platforms several times to recharge. Specifically, the vehicle has to land on the platform, which is covered by a landing pad with copper contacts, precisely positioning on the contacts otherwise fails to recharge. Also, the recharging platform can be neutralized by dust deposited on the landing pad and corrosion due to chemical causes. A contactless power transfer system that relies on induction mechanisms and permits to improve the reliability of the recharging platform is presented. The ground electronics and the on-board front-end utilized to capture the induction flow and convert the associated power to recharge the batteries are described in detail.

[1]  Gregg E. Maryniak,et al.  Status of international experimentation in wireless power transmission , 1996 .

[2]  F. Lee,et al.  High-voltage, high-power, ZVS, full-bridge PWM converter employing an active snubber , 1991, [Proceedings] APEC '91: Sixth Annual Applied Power Electronics Conference and Exhibition.

[3]  M. Soljačić,et al.  Wireless Power Transfer via Strongly Coupled Magnetic Resonances , 2007, Science.

[4]  Javad Shokrollahi Moghani,et al.  A Current-Fed Parallel Resonant Push-Pull Inverter with a New Cascaded Coil Flux Control for Induction Heating Applications , 2011 .

[5]  Bhaskar Saha,et al.  Battery health management system for electric UAVs , 2011, 2011 Aerospace Conference.

[6]  F. Mastri,et al.  Rigorous modeling of mid-range wireless power transfer systems based on royer oscillators , 2013, 2013 IEEE Wireless Power Transfer (WPT).

[7]  S.C. Goldstein,et al.  Magnetic Resonant Coupling As a Potential Means for Wireless Power Transfer to Multiple Small Receivers , 2009, IEEE Transactions on Power Electronics.

[8]  Alanson P. Sample,et al.  Analysis , Experimental Results , and Range Adaptation of Magnetically Coupled Resonators for Wireless Power Transfer , 2010 .

[9]  Mutsuo Nakaoka,et al.  Phase shifted ZVS-PWM high frequency load resonant inverter for induction heated foam metal type dual packs fluid heater , 2003, IECON'03. 29th Annual Conference of the IEEE Industrial Electronics Society (IEEE Cat. No.03CH37468).

[10]  C. U-Yaisom,et al.  The study and analysis of the conducted EMI suppression on power MOSFET using passive snubber circuits , 2002, 2002 3rd International Symposium on Electromagnetic Compatibility.

[11]  Jonathan P. How,et al.  An Automated Battery Management System to Enable Persistent Missions With Multiple Aerial Vehicles , 2015, IEEE/ASME Transactions on Mechatronics.

[12]  William C. Brown,et al.  The history of wireless power transmission , 1996 .

[13]  M. Soljačić,et al.  Efficient wireless non-radiative mid-range energy transfer , 2006, physics/0611063.

[14]  Hiroshi Nakashima,et al.  Development of a new type of electric off-road vehicle powered by microwaves transmitted through air , 2007 .