Properties and tool performance of ta-C films deposited by double-bend filtered cathodic vacuum arc for micro drilling applications

This paper describes the results of the application of ta-C films to micro drilling operation for deep and small machining boreholes. Tetrahedral amorphous carbon (ta-C) films were successfully deposited on WC-Co substrates by a double-bend filtered cathodic vacuum arc (FCVA) system. The structure, mechanical and tribological properties of both pure ta-C and ta-C incorporated argon gas (ta-C:Ar-flow) films were systematically investigated. And then, high-speed through-hole drilling tests were performed on the PCB (printed circuit board) workpiece to investigate the machining performance of ta-C coated micro drills. The experimental results show that the ta-C:Ar-flow (2 sccm) coated micro drill has excellent microstructure, microhardness, and friction coefficient properties and represents the optimal coatings for micro drilling applications.

[1]  J. Robertson.  Diamond-like amorphous carbon , 2002 .

[2]  J. Robertson.  The deposition mechanism of diamond-like a-C and a-C: H , 1994 .

[3]  Dongping Liu,et al.  The effect of the surface layer of tetrahedral amorphous carbon films on their tribological and electron emission properties investigated by atomic force microscopy , 2003 .

[4]  K. Kim,et al.  Performance evaluation of AIP-TiAlN coated tool for high speed machining , 2003 .

[5]  Xiang Yu,et al.  Structure and properties of tetrahedral amorphous carbon films implanted with Ti ion , 2007 .

[6]  John Robertson,et al.  Preparation of tetrahedral amorphous carbon films by filtered cathodic vacuum arc deposition , 2000 .

[7]  O. Monteiro,et al.  Investigation of non-hydrogenated DLC:Si prepared by cathodic arc[Diamond-Like Carbon] , 2002 .

[8]  John Robertson,et al.  Properties of diamond-like carbon , 1992 .

[9]  McKenzie,et al.  Compressive-stress-induced formation of thin-film tetrahedral amorphous carbon. , 1991, Physical review letters.

[10]  B. Tay,et al.  On stress reduction of tetrahedral amorphous carbon films for moving mechanical assemblies , 2003 .

[11]  Yong Qing Fu,et al.  Toughening of hard nanostructural thin films: a critical review , 2005 .

[12]  A. Grill.  Diamond-like carbon: state of the art , 1999 .

[13]  Dongping Liu,et al.  SPM investigation of diamond-like carbon and carbon nitride films , 2003 .

[14]  K. Kim,et al.  Cutting performance of Ti–Al–Si–N-coated tool by a hybrid-coating system for high-hardened materials , 2005 .

[15]  B. Tay,et al.  Properties of carbon ion deposited tetrahedral amorphous carbon films as a function of ion energy , 1996 .

[16]  Gehan A. J. Amaratunga,et al.  Properties of tetrahedral amorphous carbon prepared by vacuum arc deposition , 1991 .

[17]  Valentin Craciun,et al.  High intensity femtosecond laser deposition of diamond-like carbon thin films , 1999 .

[18]  K. Weinert,et al.  Machining NiTi micro-parts by micro-milling , 2008 .

[19]  Ali Erdemir,et al.  A study of the wear mechanism of diamond-like carbon films , 1996 .