Si-CMOS-compatible lift-off fabrication of low-loss planar chalcogenide waveguides.

We demonstrate, for the first time to the best of our knowledge, low-loss, Si-CMOS-compatible fabrication of single-mode chalcogenide strip waveguides. As a novel route of chalcogenide glass film patterning, lift-off allows several benefits: leverage with Si-CMOS process compatibility; ability to fabricate single-mode waveguides with core sizes down to submicron range; and reduced sidewall roughness. High-index-contrast Ge(23)Sb(7)S(70) strip waveguides have been fabricated using lift-off with excellent uniformity of loss propagation and the lowest loss figure of reported to date. We also show that small core Ge(23)Sb(7)S(70) rib waveguides can be fabricated via lift-off as well, with loss figures lower than 0.5 dB/cm. Additionally, we find through waveguide modal analysis that although overall transmission loss is low, the predominant source of this loss comes from scattering at the sidewalls.

[1]  Oleg M. Efimov,et al.  Waveguide writing in chalcogenide glasses by train of femtosecond laser pulses , 2001 .

[2]  Kathleen Richardson,et al.  Fabrication and testing of planar chalcogenide waveguide integrated microfluidic sensor. , 2007, Optics express.

[3]  S. Spector,et al.  Silicon waveguide sidewall smoothing by wet chemical oxidation , 2005, Journal of Lightwave Technology.

[4]  B. Sfez,et al.  NEW APPLICATION OF INORGANIC CHALCOGENIDE PHOTORESISTS IN LIFT-OFF PHOTOLITHOGRAPHY , 2003 .

[5]  Barry Luther-Davies,et al.  Dry-etch of As2S3 thin films for optical waveguide fabrication , 2005 .

[6]  Barry Luther-Davies,et al.  Fabrication and characterization of low loss rib chalcogenide waveguides made by dry etching. , 2004, Optics express.

[7]  Bruno Bureau,et al.  Evaluation of Toxic Agent Effects on Lung Cells by Fiber Evanescent Wave Spectroscopy , 2005, Applied spectroscopy.

[8]  Michel Couzi,et al.  Correlation between physical, optical and structural properties of sulfide glasses in the system Ge–Sb–S , 2006 .

[9]  Joon Tae Ahn,et al.  Selenide Glass Optical Fiber Doped with Pr3+ for U‐Band Optical Amplifier , 2005 .

[10]  Tigran Galstian,et al.  Fabrication and characterization of integrated optical waveguides in sulfide chalcogenide glasses , 1999 .

[11]  D. Hewak,et al.  Deposition and characterization of germanium sulphide glass planar waveguides. , 2004, Optics express.

[12]  Kathleen Richardson,et al.  Exploration of waveguide fabrication from thermally evaporated Ge–Sb–S glass films , 2008 .

[13]  J. Sanghera,et al.  Waveguide amplifiers in sputtered films of Er3+-doped gallium lanthanum sulfide glass. , 2006, Optics express.

[14]  J. McMullin,et al.  Small core rib waveguides with embedded gratings in As2Se3 glass. , 2004, Optics express.

[15]  Masaki Asobe,et al.  Efficient and ultrafast all-optical switching using high Delta n, small core chalcogenide glass fibre , 1993 .

[16]  S. K. Chaudhuri,et al.  Full-vectorial mode calculations by finite difference method , 1994 .

[17]  Jasbinder S. Sanghera,et al.  Surface relief gratings in AsSe glass fabricated under 800-nm laser exposure , 2007 .

[18]  H.T. Nguyen,et al.  High index contrast waveguides in chalcogenide glass and polymer , 2005, IEEE Journal of Selected Topics in Quantum Electronics.

[19]  T. Barwicz,et al.  Three-dimensional analysis of scattering losses due to sidewall roughness in microphotonic waveguides , 2005, Journal of Lightwave Technology.