Towards the understanding of chloride profiles in marine exposed concrete, impact of leaching and moisture content

Abstract Cores drilled from three concrete beams submerged in sea water for 16 years at the South Western Norwegian coast were examined. The beams were cast with different binders containing Portland cement and silica fume, fly ash or slag and with water-to-binder ratios (w/b) between 0.40 and 0.44. The aim of the study was to investigate whether the binder composition would affect the elemental changes in the concrete caused by the exposure to sea water and thereby the chloride ingress. No large differences were observed. All concretes showed a 200–300 μm deep magnesium enriched zone containing negligible amounts of sulphur and chlorine at the surface. This zone was followed by a sulphur enriched zone (2–5 mm deep), which then again partially overlapped with a following chlorine enriched zone (approximately 50 mm deep). For all three concretes, moisture measurements showed that the core of the concrete beams was not saturated, indicating self-desiccation and low pore connectivity. The absence of a considerable difference in chloride ingress for the investigated concretes, indicates either that the replacement levels of the Portland cement are too low to have a marked effect on the chemistry, or that the ingress of chloride is mainly governed by comparable physical properties i.e. porosity and degree of saturation.

[1]  K. Byfors,et al.  Chloride binding in cement paste , 1986 .

[2]  M. Geiker,et al.  Changes in the phase assemblage of concrete exposed to sea water , 2014 .

[3]  Hassan Zibara,et al.  Binding of external chlorides by cement pastes , 2001 .

[4]  Matthew S. Wheal,et al.  Chloride analysis of botanical samples by ICP-OES , 2010 .

[5]  Rob B. Polder,et al.  INVESTIGATION OF CONCRETE EXPOSED TO NORTH SEA WATER SUBMERSION FOR 16 YEARS , 1995 .

[6]  Michael D.A. Thomas,et al.  Performance of Slag Concrete in Marine Environment , 2008 .

[7]  G. Saoût,et al.  Hydration mechanisms of ternary Portland cements containing limestone powder and fly ash , 2011 .

[8]  Josef Tritthart,et al.  Chloride binding in cement II. The influence of the hydroxide concentration in the pore solution of hardened cement paste on chloride binding , 1989 .

[9]  E. Samson,et al.  PREDICTING THE MICROSTRUCTURAL DEGRADATION OF CONCRETE IN MARINE ENVIRONMENT , 2003 .

[10]  Mette Rica Geiker,et al.  Chloride diffusion in partially saturated cementitious material , 2003 .

[11]  K. Weerdt,et al.  The effect of sea water on the phase assemblage of hydrated cement paste , 2015 .

[12]  C. Andrade,et al.  Determination of chloride diffusivity through partially saturated Portland cement concrete by a simplified procedure , 2011 .

[13]  M. Geiker,et al.  The impact of sulphate and magnesium on chloride binding in Portland cement paste , 2014 .

[14]  A. Razaqpur,et al.  Prediction of reinforcement corrosion in concrete structures , 2009 .

[15]  Michael D.A. Thomas,et al.  Performance of pfa concrete in a marine environment––10-year results , 2004 .

[16]  J. Farias.  Corrosion of steel in cracked concrete: Chloride microanalysis and service life predictions , 2015 .

[17]  Rachel J. Detwiler,et al.  PREPARING SPECIMENS FOR MICROSCOPY , 2001 .

[18]  Tarek Uddin Mohammed,et al.  Chloride diffusion, microstructure, and mineralogy of concrete after 15 years of exposure in tidal environment , 2002 .