C60-polysulfone nanocomposite membranes: Entropic and enthalpic determinants of C60 aggregation and its effects on membrane properties

Abstract The study focuses on the effects of C60 filler on the phase inversion process and related changes in the morphology and separation properties of cast C60-polysulfone nanocomposite membranes. The effects of C60 on the rejection and permeability of the cast membranes are correlated to rheological and demixing properties of the corresponding casting mixtures. The observed differences between C60-free and nanocomposite membranes are interpreted as resulting from enthalpic and entropic C60-polysulfone interactions that drive and are mediated by the aggregation of C60. Only 30 nm and smaller C60 aggregates are observed in membranes with the smallest (1% C60/polysulfone by mass) C60 loading. In contrast, only aggregates larger than 30 nm are found in composites with 5% and 10% C60 loadings. A correlation between the demixing rate and permeability and a counter-correlation between permeability and rejection are observed for nanocomposite membranes for the entire C60 loadings range studied. The observed accumulation of the filler at the surface of internal membrane pores is attributed to the expulsion of C60 aggregates to the free surface for an entropic gain. The findings have implications for the design of polymer nanocomposite membranes as well as for the lifecycle analysis of nanomaterial-enabled products.

[1]  K. Nagai,et al.  Gas permeation of fullerene‐dispersed poly(1‐trimethylsilyl‐1‐propyne) membranes , 2000 .

[2]  G. Hummer,et al.  Water conduction through the hydrophobic channel of a carbon nanotube , 2001, Nature.

[3]  Peng Wang,et al.  The influence of nano-sized TiO2 fillers on the morphologies and properties of PSF UF membrane , 2007 .

[4]  Woo Nyon Kim,et al.  Fabrication and characterization of multi-walled carbon nanotubes/polymer blend membranes , 2006 .

[5]  V. Tarabara,et al.  Effect of filler incorporation route on the properties of polysulfone–silver nanocomposite membranes of different porosities , 2008 .

[6]  J. Zhu,et al.  Morphologies and properties of poly(phthalazinone ether sulfone ketone) matrix ultrafiltration membranes with entrapped TiO2 nanoparticles , 2007 .

[7]  D. M. Sterescu,et al.  Novel Gas Separation Membranes Containing Covalently Bonded Fullerenes , 2004 .

[8]  Anna C. Balazs,et al.  Entropy-driven segregation of nanoparticles to cracks in multilayered composite polymer structures , 2006 .

[9]  W. Milne,et al.  Polymer-Assisted Isolation of Single Wall Carbon Nanotubes in Organic Solvents for Optical-Quality Nanotube -Polymer Composites , 2008 .

[10]  Sharon C. Glotzer,et al.  Origin of Particle Clustering in a Simulated Polymer Nanocomposite and its Impact on Rheology , 2003 .

[11]  A. Venkatesan,et al.  Fullerene composite proton conducting membranes for polymer electrolyte fuel cells operating under low humidity conditions , 2006 .

[12]  V. C. Moore,et al.  Individually suspended single-walled carbon nanotubes in various surfactants , 2003 .

[13]  Hyung Gyu Park,et al.  Ion exclusion by sub-2-nm carbon nanotube pores , 2008, Proceedings of the National Academy of Sciences.

[14]  Peng Wang,et al.  Rheological and thermodynamic variation in polysulfone solution by PEG introduction and its effect on kinetics of membrane formation via phase-inversion process , 2006 .

[15]  C. Grigoropoulos,et al.  Fast Mass Transport Through Sub-2-Nanometer Carbon Nanotubes , 2006, Science.

[16]  S. Ong,et al.  Fullerene‐Containing Polymer Membranes for Rejection of Estrogenic Compounds in Water , 2006 .

[17]  A. Toikka,et al.  Fullerene-containing polyphenylene oxide membranes for pervaporation , 2006 .

[18]  V. Ganesan,et al.  Mechanisms of steady-shear rheology in polymer-nanoparticle composites , 2006 .

[19]  Juin-Yih Lai,et al.  A top surface liquid layer during membrane formation using vapor-induced phase separation (VIPS)-Evidence and mechanism of formation , 2008 .

[20]  P. Duxbury,et al.  Self-assembled multilayers of nanocomponents. , 2007, Nano letters.

[21]  M. Dresselhaus,et al.  Physical properties of carbon nanotubes , 1998 .

[22]  Ming-Chien Yang,et al.  The preparation and characterization of silver‐loading cellulose acetate hollow fiber membrane for water treatment , 2005 .

[23]  K. Nagai,et al.  Preparation and gas permeation of immobilized fullerene membranes , 2000 .

[24]  Lorraine F. Francis,et al.  Addition of alumina to cellulose acetate membranes , 1995 .

[25]  Rodney Andrews,et al.  Aligned Multiwalled Carbon Nanotube Membranes , 2004, Science.

[26]  Amar K Mohanty,et al.  Single-walled carbon nanotubes dispersed in aqueous media via non-covalent functionalization: effect of dispersant on the stability, cytotoxicity, and epigenetic toxicity of nanotube suspensions. , 2010, Water research.

[27]  D. Bhattacharyya,et al.  Impact of membrane immobilization on particle formation and trichloroethylene dechlorination for bimetallic Fe/Ni nanoparticles in cellulose acetate membranes. , 2007, The journal of physical chemistry. B.

[28]  Ani Idris,et al.  The effect of different molecular weight PEG additives on cellulose acetate asymmetric dialysis membrane performance , 2006 .

[29]  S. Nunes,et al.  Membranes of poly(ether imide) and nanodispersed silica , 1999 .

[30]  G. Stucky,et al.  Fabrication of new fullerene composite membranes and their application in proton exchange membrane fuel cells , 2007 .

[31]  A. Karim,et al.  Suppression of Dewetting in Nanoparticle-Filled Polymer Films , 2000 .

[32]  Jan Feijen,et al.  Phase-Separation Processes in Polymer-Solutions in Relation to Membrane Formation , 1996 .

[33]  Chen Xuesi,et al.  The research of rheology and thermodynamics of organic–inorganic hybrid membrane during the membrane formation , 2008 .

[34]  P. Alvarez,et al.  Properties of Membranes Containing Semi-dispersed Carbon Nanotubes , 2008 .

[35]  Marcel Mulder,et al.  Basic Principles of Membrane Technology , 1991 .

[36]  Won Ho Park,et al.  Preparation of Antimicrobial Ultrafine Cellulose Acetate Fibers with Silver Nanoparticles , 2004 .

[37]  Jae-Hong Kim,et al.  Effect of encapsulating agents on dispersion status and photochemical reactivity of C60 in the aqueous phase. , 2008, Environmental science & technology.

[38]  Jiangyong Hu,et al.  Estrogenic compounds removal by fullerene-containing membranes , 2007 .

[39]  Jeong-Hoon Kim,et al.  Effect of PEG additive on membrane formation by phase inversion , 1998 .

[40]  M. Jhon,et al.  The effect of ZnCl2 on the formation of polysulfone membrane , 1996 .

[41]  Noureddine Abidi,et al.  Wettability and surface free energy of graphene films. , 2009, Langmuir : the ACS journal of surfaces and colloids.

[42]  Y. Kang,et al.  Membrane formation by water vapor induced phase inversion , 1999 .

[43]  Lu Yan,et al.  EFFECT OF NANO SIZED AL2O3-PARTICLE ADDITION ON PVDF ULTRAFILTRATION MEMBRANE PERFORMANCE , 2006 .

[44]  A. Ghoshal,et al.  Preparation, characterization and performance studies of polysulfone membranes using PVP as an additive , 2008 .

[45]  Craig J Hawker,et al.  General Strategies for Nanoparticle Dispersion , 2006, Science.

[46]  P. Jacobs,et al.  Polysulfone–aerosil composite membranes: Part 2. The influence of the addition of aerosil on the skin characteristics and membrane properties , 2000 .

[47]  K. Schweizer,et al.  Theory of Phase Separation in Polymer Nanocomposites , 2006 .

[48]  Anna C. Balazs,et al.  Nanoparticle Polymer Composites: Where Two Small Worlds Meet , 2006, Science.

[49]  P. Jacobs,et al.  POLYSULFONE-AEROSIL COMPOSITE MEMBRANES. PART 1. THE INFLUENCE OF THE ADDITION OF AEROSIL ON THE FORMATION PROCESS AND MEMBRANE MORPHOLOGY , 2000 .

[50]  P. Flory.  Principles of polymer chemistry , 1953 .

[51]  C. A. Smolders,et al.  Microstructures in phase inversion membranes. Part II. The role of a polymeric additive , 1992 .

[52]  James L White,et al.  The influence of carbon black on the extrusion characteristics and rheological properties of elastomers: Polybutadiene and butadiene–styrene copolymer , 1974 .

[53]  M. Wiesner,et al.  Hydration and dispersion of C60 in aqueous systems: the nature of water-fullerene interactions. , 2009, Langmuir : the ACS journal of surfaces and colloids.

[54]  K. Ebert,et al.  Influence of inorganic fillers on the compaction behaviour of porous polymer based membranes , 2004 .