Development of a fiber-reinforced plastic armrest frame for weight-reduced automobiles

This paper presents the design optimization process of a short fiber-reinforced plastic armrest frame to minimize its weight by replacing the steel frame with a plastic frame. The analysis was carried out with the equivalent mechanical model and design of experiment (DOE) method. Instead of considering the whole structure, it is divided into three simpler regions to reduce the complexity of the problem through examining its structural characteristics and load conditions. The maximum stress and deflection of the regions that carry the normal load are calculated by the analytical mathematical form derived from an equivalent model. The other regions loaded by contact stress are handled by FEM (finite element method), the DOE method, and the RSM (response surface model). To optimize the design variables in both cases, the object functions derived from these calculations are solved with a CAE (computer aided engineering) tool. This method clearly shows the mechanical and mathematical representation of structural optimization and reduces the computing costs. After design optimization, the weight of the optimum plastic-based armrest frame is reduced by about 18% compared to the initial design of a plastic frame and is decreased by 50% in comparison with the steel frame. Some prototypical armrest frames were also made by injection molding and tested. The research results fulfilled all of the design requirements.

[1]  P. Mallick,et al.  A non-linear damage model for the tensile behavior of an injection molded short E-glass fiber reinforced polyamide-6,6 , 2005 .

[2]  Christina Schäfer,et al.  Shape optimisation by design of experiments and finite element methods—an application of steel wheels , 2008 .

[3]  Hae-Sim Park,et al.  Design of conformal cooling channels for an automotive part , 2009 .

[4]  Donald V. Rosato,et al.  Plastics Engineered Product Design , 2003 .

[5]  Donald V. Rosato,et al.  2 – DESIGN OPTIMIZATION , 2003 .

[6]  Andrzej Osyczka,et al.  Evolutionary Algorithms for Single and Multicriteria Design Optimization , 2001 .

[7]  H. S. Park,et al.  DEVELOPMENT OF DIGITAL LASER WELDING SYSTEM FOR AUTOMOBILE SIDE PANELS , 2007 .

[8]  Hamit Akbulut,et al.  On optimization of a car rim using finite element method , 2003 .

[9]  Hongzhe Zhang,et al.  An open platform of shape design optimization for shell structure , 2008 .

[10]  Xiao Hu,et al.  Tensile properties of short-glass-fiber- and short-carbon-fiber-reinforced polypropylene composites , 2000 .

[11]  Gang Liu,et al.  Design optimization of stiffened storage tank for spacecraft , 2008 .

[12]  Koetsu Yamazaki,et al.  Application of structure optimization technique to aluminum beverage bottle design , 2005 .

[13]  J. Thomason.  The influence of fibre length and concentration on the properties of glass fibre reinforced polypropylene: 5. Injection moulded long and short fibre PP , 2002 .

[14]  J. W. Yoon,et al.  DESIGN OPTIMIZATION OF AUTOMOTIVE LOCK-UP CLUTCHES WITH DAMPER SPRINGS USING SIMULATED ANNEALING, FEM, AND B-SPLINE CURVES , 2007 .