Optimization of Thermal Spray Parameters of NiAl/Cr2C3 Coating by Taguchi Method

In this study the effect of thermal spray process on wear resistance of NiAl/Cr2C3 thermal spray coating has been investigated. For this purpose the NiAl power mixed with 10 %wt. Cr2C3 powder and milled for 1 hrs at argon atmosphere. The APS parameters such as voltage (V), current (A), spray distance (mm), powder feed rate (gr/min), were optimize using a response surface methodology. For investigation effect of spray parameters on quality of coatings, the porosity and wear resistance of coatings analyzed with SEM and pin on disk wear test. Results show that increase of voltage and current are more effective other parameters. Increasing of powder feed rate and spray distance raised porosity of coatings intensively.

[1]  Cheng Lu,et al.  Mechanical and tribological properties of plasma sprayed NiAl composite coatings with addition of nanostructured TiO2/Bi2O3 , 2018, Surface and Coatings Technology.

[2]  M. Shamanian,et al.  High-Temperature Oxidation Behavior of Nano-structured CoNiCrAlY–YSZ Coatings Produced by HVOF Thermal Spray Technique , 2018, Oxidation of Metals.

[3]  M. Bai,et al.  Experimental and thermodynamic investigations on the chlorine-induced corrosion of HVOF thermal sprayed NiAl coatings and 304 stainless steels at 700 °C , 2018 .

[4]  Mofid Gorji-Bandpy,et al.  Investigations of fin geometry on heat exchanger performance by simulation and optimization methods for diesel exhaust application , 2016, Neural Computing and Applications.

[5]  M. Shamanian,et al.  The effect of heat treatment and thermal spray processes on the grain growth of nanostructured composite CoNiCrAlY/YSZ powders , 2015 .

[6]  Davood Domiri Ganji,et al.  Experimental and numerical analysis of the optimized finned-tube heat exchanger for OM314 diesel exhaust exergy recovery , 2015 .

[7]  D. A. Lee,et al.  HVOF Coating Case Study for Power Plant Process Control Ball Valve Application , 2012, Journal of Thermal Spray Technology.

[8]  M. Shamanian,et al.  Microstructural and morphological evaluation of MCrAlY/YSZ composite produced by mechanical alloying method , 2012 .

[9]  Shu Chang,et al.  Impact Wear Resistance of Stellite 6 Hardfaced Valve Seats with Laser Cladding , 2008 .

[10]  J. A. Little,et al.  The effect of spray parameters on the properties of high velocity oxy-fuel NiAl intermetallic coatings , 2000 .