Operation strategy and suitability analysis of CHP system with heat recovery

Abstract In order to coordinate and balance the demand of combined heat and power (CHP) system, a solution of optimal operation strategy of CHP system with heat recovery in a distributed energy system has been presented. This paper will discuss more deeply the suitability of the CHP system under different operation strategies. The selections of electricity determined by heat load (EDHL) and heat load determined by electricity (HLDE) are actualised by Aspen Plus and formula computing. In addition, the performance difference of the CHP system operating in EDHL and HLDE is analysed by comparing thermoelectric output and fuel consumption. The result shows that the optimal heat to power ratio (HPR) is 1.75 and is derived when the electric output is approximately equal to the electric demand and the heat output is approximately equal to the heat demand. EDHL is the optimal selection when the HPR is greater than or equal to 1 and less than 1.75, and HLDE is adopted suitably when the HPR is greater than 1.75 and less than or equal to 2.5. Additionally, the total thermal efficiency does not vary with increasing or decreasing regenerative temperature or variable HPR on CHP system, maintaining 87–88% thermal efficiency, meanwhile, the total exergy efficiency is about 24.7%–28.8% when the CHP systems operate in EDHL, and 23.1%–31.4% when the CHP systems operate in HLDE. The final research results show that, it has great significance in operation strategy and suitability analysis of the CHP system.

[1]  Nan Li,et al.  Optimal design and operation strategy for integrated evaluation of CCHP (combined cooling heating and power) system , 2016 .

[2]  Zhiqiang Zhai,et al.  Performance comparison of combined cooling heating and power system in different operation modes , 2011 .

[3]  Derek Hacon,et al.  Thermodynamic analysis of tri-generation systems taking into account refrigeration, heating and electricity load demands , 2010 .

[4]  Minlin Yang,et al.  Research, development and the prospect of combined cooling, heating, and power systems , 2010 .

[5]  Fang Fang,et al.  Complementary configuration and operation of a CCHP-ORC system , 2012 .

[6]  Nan Li,et al.  Analysis of the integrated performance and redundant energy of CCHP systems under different operation strategies , 2015 .

[7]  Arif Hepbasli,et al.  Thermodynamic and thermoeconomic analyses of a trigeneration (TRIGEN) system with a gas–diesel engine: Part II – An application , 2010 .

[8]  Pedro J. Mago,et al.  Evaluation of a turbine driven CCHP system for large office buildings under different operating strategies , 2010 .

[9]  Bao Min Operation Mode Optimization for Gas Turbine's Heat & Power Cogeneration in Distributed Energy Systems , 2008 .

[10]  Qunyin Gu,et al.  Integrated assessment of combined cooling heating and power systems under different design and management options for residential buildings in Shanghai , 2012 .

[11]  Pedro J. Mago,et al.  Analysis of a combined cooling, heating, and power system model under different operating strategies with input and model data uncertainty , 2010 .

[12]  Catherine C. Adley,et al.  Efficiency improvement through waste heat reduction , 2014 .

[13]  Kuppan Thulukkanam Heat Exchanger Design Handbook , 2013 .

[14]  Wenxing Shi,et al.  A simple method to determine the optimal gas turbine capacity and operating strategy in building cooling, heating and power system , 2014 .

[15]  Genku Kayo,et al.  Energy sharing and matching in different combinations of buildings, CHP capacities and operation strategy , 2014 .

[16]  Saffa Riffat,et al.  Tri-generation systems: Energy policies, prime movers, cooling technologies, configurations and operation strategies , 2014 .

[17]  Qiong Wu,et al.  Multi-objective optimization for the operation of distributed energy systems considering economic and environmental aspects , 2010 .

[18]  Ruzhu Wang,et al.  COMBINED COOLING, HEATING AND POWER: A REVIEW , 2006 .

[19]  Hongbo Ren,et al.  A MILP model for integrated plan and evaluation of distributed energy systems , 2010 .

[20]  Sami Kara,et al.  The optimal selection of on-site CHP systems through integrated sizing and operational strategy , 2014 .

[21]  Arif Hepbasli,et al.  Thermodynamic and thermoeconomic analyses of a trigeneration (TRIGEN) system with a gas–diesel engine: Part I – Methodology , 2010 .

[22]  Yi Jiang,et al.  Energy utilization evaluation of CCHP systems , 2006 .

[23]  Nicola Bianco,et al.  Economic optimization of a residential micro-CHP system considering different operation strategies , 2016 .

[24]  Denilson Boschiero do Espirito Santo,et al.  An energy and exergy analysis of a high-efficiency engine trigeneration system for a hospital: A case study methodology based on annual energy demand profiles , 2014 .

[25]  You-Yin Jing,et al.  Multi-objective optimization design and operation strategy analysis of BCHP system based on life cycle assessment , 2012 .

[26]  Sepehr Sanaye,et al.  Simultaneous use of MRM (maximum rectangle method) and optimization methods in determining nominal capacity of gas engines in CCHP (combined cooling, heating and power) systems , 2014 .

[27]  Zhang Chun-fa,et al.  Multi-criteria analysis of combined cooling, heating and power systems in different climate zones in China , 2010 .

[28]  Na Zhang,et al.  General characteristics of single shaft microturbine set at variable speed operation and its optimization , 2004 .

[29]  Peng Sun,et al.  Analysis of combined cooling, heating, and power systems under a compromised electric–thermal load strategy , 2014 .

[30]  Pedro J. Mago,et al.  Analysis and optimization of CCHP systems based on energy, economical, and environmental considerations , 2009 .

[31]  Sheng Li,et al.  Multi-objective optimal operation strategy study of micro-CCHP system , 2012, Energy.

[32]  Zhi-Gao Sun Energy efficiency and economic feasibility analysis of cogeneration system driven by gas engine , 2008 .

[33]  Hongguang Jin,et al.  The exergy and energy level analysis of a combined cooling, heating and power system driven by a small scale gas turbine at off design condition , 2014 .

[34]  Pedro J. Mago,et al.  Evaluation of the potential emissions reductions from the use of CHP systems in different commercial buildings , 2012 .

[35]  Pedro J. Mago,et al.  Effects of load-following operational methods on combined heat and power system efficiency , 2014 .

[36]  Andrea Luigi Facci,et al.  Optimization of CHCP (combined heat power and cooling) systems operation strategy using dynamic programming , 2014 .

[37]  Meherwan P. Boyce,et al.  Gas turbine engineering handbook , 1981 .

[38]  Zaijun Wu,et al.  Modeling, planning and optimal energy management of combined cooling, heating and power microgrid: A review , 2014 .