Investigation of Wideband Load Transformation Networks for Class-E Switching-Mode Power Amplifiers

In this paper, single-ended and differential class-E load transformation networks (LTNs) for wideband operation are investigated. For this purpose, a differential third parallel-tuned tank LTN and a parallel-circuit load LTN without suppressing tanks are proposed to fulfill the class-E wideband condition. The differential parallel-circuit load (DPCL), which considers the finite RF chokes, has higher output resistance, and because of the differential structure, which ensures an open circuit at even harmonic frequencies, it is able to cover a wide frequency range. Consequently, the DPCL is well suited for highly integrated monolithic designs, as well as wideband application. Based on this analysis, a wideband class-E switching-mode power amplifier in CMOS 90 nm using the DPCL is designed. By deliberately combining the LTN with an on-chip balun, a compact size of 1.2 mm2 is achieved. The circuit performance dependency on bond-wire length variation is analyzed and discussed. Measured results show a peak output power of 28.7 dBm, power-added efficiency (PAE) of 48.0%, and drain efficiency of 55.0% at 2.3 GHz. From 1.7 to 2.7 GHz, PAE is higher than 42% and output power is above 25 dBm.

[1]  P. Colantonio,et al.  A Design Technique for Concurrent Dual-Band Harmonic Tuned Power Amplifier , 2008, IEEE Transactions on Microwave Theory and Techniques.

[2]  F. Raab.  Class-E, Class-C, and Class-F power amplifiers based upon a finite number of harmonics , 2001 .

[3]  F. Svelto,et al.  A 30.5 dBm 48% PAE CMOS Class-E PA With Integrated Balun for RF Applications , 2008, IEEE Journal of Solid-State Circuits.

[4]  Earl W. McCune.  Multi-mode and multi-band polar transmitter for GSM, NADC, and EDGE , 2003, 2003 IEEE Wireless Communications and Networking, 2003. WCNC 2003..

[5]  Hwann-Kaeo Chiou,et al.  Fully-integrated CMOS class-E power amplifier using broadband and low-loss 1:4 transmission-line transformer , 2010 .

[6]  Frederick H. Raab,et al.  Idealized operation of the class E tuned power amplifier , 1977 .

[7]  D.J. Allstot,et al.  A Class-G Supply Modulator and Class-E PA in 130 nm CMOS , 2009, IEEE Journal of Solid-State Circuits.

[8]  Frederick H. Raab,et al.  Effects of circuit variations on the class E tuned power amplifier , 1978 .

[9]  D. Sira,et al.  Output Power Control in Class-E Power Amplifiers , 2010, IEEE Microwave and Wireless Components Letters.

[10]  F. Fortes,et al.  A second harmonic class-F power amplifier in standard CMOS technology , 2001 .

[11]  Danish Kalim,et al.  Concurrent planar multiharmonic dual-band load coupling network for switching-mode power amplifiers , 2011, 2011 IEEE MTT-S International Microwave Symposium.

[12]  A.V. Grebennikov,et al.  Class E with parallel circuit - a new challenge for high-efficiency RF and microwave power amplifiers , 2002, 2002 IEEE MTT-S International Microwave Symposium Digest (Cat. No.02CH37278).

[13]  Fadhel M. Ghannouchi,et al.  Enhanced architecture for microwave currentmode class-D amplifiers applied to the design of an S-band GaN-based power amplifier , 2009 .

[14]  Bumman Kim,et al.  Analysis and experiments for high-efficiency class-F and inverse class-F power amplifiers , 2006 .

[15]  F. Svelto,et al.  Analysis of reliability and power efficiency in cascode class-E PAs , 2006, IEEE Journal of Solid-State Circuits.

[16]  Youngoo Yang,et al.  Analysis and experiments for high-efficiency class-F and inverse class-F power amplifiers , 2006, IEEE Transactions on Microwave Theory and Techniques.

[17]  Steadman Jw,et al.  Class E Power Amplifiers and Frequency Multipliers with finite DC-Feed Inductance , 1987 .

[18]  Fadhel M. Ghannouchi,et al.  Concurrent Dual-Band Class-F Load Coupling Network for Applications at 1.7 and 2.14 GHz , 2008, IEEE Transactions on Circuits and Systems II: Express Briefs.

[19]  W. Bachtold,et al.  Lumped-element load-network design for class-E power amplifiers , 2006, IEEE Transactions on Microwave Theory and Techniques.

[20]  O. Degani,et al.  A Class-E PA With Pulse-Width and Pulse-Position Modulation in 65 nm CMOS , 2009, IEEE Journal of Solid-State Circuits.

[21]  J. Laskar,et al.  A 1.8-GHz 2-Watt Fully Integrated CMOS Push-Pull Parallel-Combined Power Amplifier Design , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.

[22]  F. Raab.  Class-F power amplifiers with maximally flat waveforms , 1997 .

[23]  No Sokal,et al.  CLASS-E - NEW CLASS OF HIGH-EFFICIENCY TUNED SINGLE-ENDED SWITCHING POWER AMPLIFIERS , 1975 .

[24]  R. Zulinski,et al.  An exact analysis of class E amplifiers with finite DC-feed inductance at any output Q , 1990 .

[25]  Andrei Grebennikov,et al.  Switchmode RF Power Amplifiers , 2007 .

[26]  Michiel Steyaert,et al.  A 2.45-GHz 0.13-$\mu{\hbox {m}}$ CMOS PA With Parallel Amplification , 2007, IEEE Journal of Solid-State Circuits.

[27]  Michel Steyaert,et al.  RF Power Amplifiers for Mobile Communications , 2006 .

[28]  Ali M. Niknejad,et al.  An Efficient Mixed-Signal 2.4-GHz Polar Power Amplifier in 65-nm CMOS Technology , 2011, IEEE Journal of Solid-State Circuits.

[29]  F.H. Raab,et al.  Electronically tunable class-E power amplifier , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).