Heat of Vaporization Measurements for Ethanol Blends Up to 50 Volume Percent in Several Hydrocarbon Blendstocks and Implications for Knock in SI Engines

The objective of this work was to measure knock resistance metrics for ethanol-hydrocarbon blends with a primary focus on development of methods to measure the heat of vaporization (HOV). Blends of ethanol at 10 to 50 volume percent were prepared with three gasoline blendstocks and a natural gasoline. Performance properties and composition of the blendstocks and blends were measured, including research octane number (RON), motor octane number (MON), net heating value, density, distillation curve, and vapor pressure. RON increases upon blending ethanol but with diminishing returns above about 30 vol%. Above 30% to 40% ethanol the curves flatten and converge at a RON of about 103 to 105, even for the much lower RON NG blendstock. Octane sensitivity (S = RON MON) also increases upon ethanol blending. Gasoline blendstocks with nearly identical S can show significantly different sensitivities when blended with ethanol. HOV was estimated from a detailed hydrocarbon analysis (DHA) as well as using a differential scanning calorimetry/thermogravimetric analysis (DSC/TGA) method. The DHA method allows relatively straight-forward estimation of fuel composition and temperature effects, and errors are estimated at less than 10%. The DSC/TGA produces results in good agreement with DHA, and can provide HOV as a function of fraction evaporated. A striking feature of the HOV results was the insensitivity of HOV to the hydrocarbon blendstock for temperatures up to 150°C all four hydrocarbon blendstocks had essentially the same HOV in kJ/kg and exhibited the same HOV response to blending with ethanol. HOV is much less variable than RON or S. HOV at 20% evaporated from the DSC/TGA experiment appeared to be unaffected by ethanol content while HOV at 50% evaporated increased monotonically with ethanol content. CITATION: Chupka, G., Christensen, E., Fouts, L., Alleman, T. et al., "Heat of Vaporization Measurements for Ethanol Blends Up to 50 Volume Percent in Several Hydrocarbon Blendstocks and Implications for Knock in SI Engines," SAE Int. J. Fuels Lubr. 8(2):2015, doi:10.4271/2015-01-0763. 2015-01-0763 Published 04/14/2015 Copyright © 2015 SAE International doi:10.4271/2015-01-0763 saefuel.saejournals.org NREL/CP-5400-63091. Posted with permission. Presented at the SAE 2015 World Congress & Exhibition, 21–23 April 2015, Detroit, Michigan.

[1]  Thomas G. Leone,et al.  High octane number ethanol–gasoline blends: Quantifying the potential benefits in the United States , 2012 .

[2]  Michael Howard Shelby,et al.  Effect of Heat of Vaporization, Chemical Octane, and Sensitivity on Knock Limit for Ethanol - Gasoline Blends , 2012 .

[3]  James S. Chickos,et al.  Enthalpies of Vaporization of Organic and Organometallic Compounds, 1880-2002 , 2003 .

[4]  Thomas J. Bruno,et al.  Improvements in the Measurement of Distillation Curves. 2. Application to Aerospace/Aviation Fuels RP-1 and S-8† , 2006 .

[5]  G. T. Kalghatgi,et al.  Fuel Anti-Knock Quality- Part II. Vehicle Studies - How Relevant is Motor Octane Number (MON) in Modern Engines? , 2001 .

[6]  A. Marchal,et al.  Impact of Fuel Properties on the Performances and Knock Behaviour of a Downsized Turbocharged DI SI Engine - Focus on Octane Numbers and Latent Heat of Vaporization , 2009 .

[7]  I. Mita,et al.  Determination of heat of mixing and heat of vaporization with a differential scanning calorimeter , 1971 .

[8]  John B. Heywood,et al.  Charge Cooling Effects on Knock Limits in SI DI Engines Using Gasoline/Ethanol Blends: Part 2-Effective Octane Numbers , 2012 .

[9]  K. Kobe.  The properties of gases and liquids , 1959 .

[10]  Roman M. Balabin,et al.  Molar enthalpy of vaporization of ethanol–gasoline mixtures and their colloid state , 2007 .

[11]  John B. Heywood,et al.  Charge Cooling Effects on Knock Limits in SI DI Engines Using Gasoline/Ethanol Blends: Part 1-Quantifying Charge Cooling , 2012 .

[12]  Robert Albert Stein,et al.  An Overview of the Effects of Ethanol-Gasoline Blends on SI Engine Performance, Fuel Efficiency, and Emissions , 2013 .

[13]  J. Yanowitz,et al.  Renewable Oxygenate Blending Effects on Gasoline Properties , 2011 .

[14]  A. Harrison.  Enthalpy Requirement—A New Fundamentally-Based Gasoline Volatility Parameter For Predicting Cold-Weather Driveability , 1988 .

[15]  James P. Szybist,et al.  Experimental Investigation of Spark-Ignited Combustion with High-Octane Biofuels and EGR. 1. Engine Load Range and Downsize Downspeed Opportunity , 2014 .

[16]  John B. Heywood,et al.  The Shift in Relevance of Fuel RON and MON to Knock Onset in Modern SI Engines Over the Last 70 Years , 2009 .

[17]  R. Stone,et al.  Measurement of Enthalpies of Vaporization of Isooctane and Ethanol Blends and Their Effects on PM Emissions from a GDI Engine , 2011 .

[18]  Prasenjeet Ghosh,et al.  Development of a Detailed Gasoline Composition-Based Octane Model , 2006 .

[19]  Kenneth Kar,et al.  Measurement of Vapor Pressures and Enthalpies of Vaporization of Gasoline and Ethanol Blends and Their Effects on Mixture Preparation in an SI Engine , 2008 .

[20]  Michael Howard Shelby,et al.  Octane Numbers of Ethanol-Gasoline Blends: Measurements and Novel Estimation Method from Molar Composition , 2012 .

[21]  R. Harley,et al.  Relating Liquid Fuel and Headspace Vapor Composition for California Reformulated Gasoline Samples Containing Ethanol , 2000 .

[22]  J. Yanowitz,et al.  Impact of adaptation on flex-fuel vehicle emissions when fueled with E40. , 2013, Environmental science & technology.

[23]  Michael Howard Shelby,et al.  Effects of Fuel Octane Rating and Ethanol Content on Knock, Fuel Economy, and CO2 for a Turbocharged DI Engine , 2014 .

[24]  Michael J. Brear,et al.  The Effect of Charge Cooling on the RON of Ethanol/Gasoline Blends , 2013 .

[25]  John B. Heywood,et al.  The Underlying Physics and Chemistry behind Fuel Sensitivity , 2010 .

[26]  P. Bielaczyc,et al.  An examination of the effect of ethanol–gasoline blends' physicochemical properties on emissions from a light-duty spark ignition engine , 2013 .

[27]  Donald G. Hesse,et al.  Determination of vaporization enthalpies of simple organic molecules by correlations of changes in gas chromatographic net retention times , 1995 .

[28]  Thomas J. Bruno,et al.  Improvements in the measurement of distillation curves. 3. Application to gasoline and gasoline + methanol mixtures , 2007 .

[29]  John B. Heywood,et al.  Benefits of a Higher Octane Standard Gasoline for the U.S. Light-Duty Vehicle Fleet , 2014 .